Abstract.
The general fluid transport equation presented in Part-I of this paper is used for predicting moisture transport and viscoelastic stresses during sorption and drying of soybeans. Predicted drying curves were validated using experimental data obtained from literature (average absolute difference 6-13%). For drying temperatures used in the soybean processing industry (70–93 °C), smooth moisture profiles were obtained, which indicated Fickian (Darcian) transport. As the drying temperature approached the glass transition temperature (25 °C at 10% moisture content), the moisture profiles became sharper, which indicated non-Fickian (non-Darcian) transport. The viscoelastic stress profiles clearly exhibited the role of the force terms during imbibition and drying. Increase in drying temperature tends to decrease the stress relaxation function but reduction in moisture content during drying tends to increase it. The increase in stress due to the reduction in moisture content below 10% was not compensated by an increase in drying temperature. Drying of soybeans below 10% moisture content should be avoided in the industry because this will lead to thicker flakes that reduce the amount of oil recovery. During imbibition of soybeans, a high magnitude of stresses was obtained in the rubbery regions, which may cause critical regions prone to fissuring. The role of glass transition on stress development and critical region development was clearly observed during drying and imbibition of soybeans.
Similar content being viewed by others
References
Kunze, O.R., Prasad, S.: Grain fissuring potentials in harvesting and drying of rice. Transactions of the ASAE 21 (2), 361–366 (1978)
Kunze, O.R.: Fissuring of the rice grain after heated air drying. Transactions of the ASAE 22 (5), 1197 (1979)
Misra, R.N., Young, J.H., Hamann, D.D.: Finite element procedures for estimating shrinkage stresses during soybean drying. Transactions of the ASAE 24 (3), 751–755 (1981)
Irudayaraj, J., Haghighi, K.: Stress-analysis of viscoelastic materials during drying.1. Theory and finite-element formulation. Drying Technol. 11 (5), 901–927 (1993)
Lan, Y.B., Kunze, O.R.: Relative humidity effects on the development of fissures in rice. Cereal Chemistry 73 (2), 222–224 (1996)
Cnossen, A.G., Siebenmorgen, T.J.: The glass transition temperature concept in rice drying and tempering: Effect on milling quality. Transactions of the ASAE 43 (6), 1661–1667 (2000)
Cnossen, A.G., Siebenmorgan, T.J., Yang, W., Bautista, R.C.: An application of glass transition temperature to explain rice kernel fissure occurrence during the drying process. Drying Technol. 19 (8), 1661–1682 (2001)
Singh, P.P., Maier, D.E., Cushman, J.H., Haghighi, K., Corvalan, C.: Effect of viscoelastic relaxation on moisture transport in foods. Part I: Solution of general transport equation. Journal of Mathematical Biology, 49, 1–19 (2004)
Singh, P.P., Cushman, J.H., Maier, D.E.: Multiscale fluid transport theory for swelling biopolymers. Chemical Engineering Sci. 58 (11), 2409–2419 (2003)
Singh, P.P., Maier, D.E., Campanella, O.: Effect of temperature and moisture on dynamic viscoelastic properties of soybeans. Transactions of the ASAE 44 (6), 1713–1719 (2001)
Kitic, D., Viollaz, P.E.: Comparison of drying kinetics of soybeans in thin layer and fluidized beds. J. Food Technol. 19, 399–408 (1984)
Misra, R.N., Young, J.H.: Numerical solution of simultaneous moisture diffusion and shrinkage during soybean drying. Transactions of the ASAE 23 (5), 1277–1282 (1980)
Bruni, F., Leopold, A.C.: Pools of water in anhydrobiotic organisms. Biophys. J. 63 (3), 663–672 (1992)
Singh, P.P.: Effect of viscoelastic relaxation on fluid and species transport in biopolymeric materials. In: Agricultural and Biological Engineering, Ph.D. Thesis, Purdue University, West Lafayette, Indiana, 2002
Liu, M., Haghighi, K., Stroshine, R.L., Ting, E.C.: Mechanical-properties of the soybean cotyledon and failure strength of soybean kernels. Transactions of the ASAE 33 (2), 559–566 (1990)
Singh, P.P., Maier, D.E., Campanella, O.: Effect of temperature and mosisture on dynamic viscoelastic properties of soybeans. Transactions of the ASAE 44 (6), 1713–1719 (2001)
Maki, K., Bartsch, J., Pitt, R., Leopold, A.C.: Viscoelastic properties and the glassy state in soybeans. Seed Sci. Res. 4 (1), 27–31 (1994)
Bruni, F., Leopold, A.C.: Glass transition in soybean seed: relevance to anhydrous biology. Plant Physiology 96 (2), 660–663 (1991)
Singh, P.P., Cushman, J.H., Maier, D.E.: Three scale thermomechanical theory for swelling biopolymeric systems. Chemical Engineering Sci. 58, 4017–4035 (2003)
Tolstoguzov, V.B.: The importance of glassy biopolymer components in food. Nahrung-Food 44 (2), 76–84 (2000)
Kim, D.J., Caruthers, J.M., Peppas, N.A.: Experimental verification of a predictive model of penetrant transport in glassy polymers. Chemical Engineering Sci. 51 (21), 4827–4841 (1996)
Achanta, S., Okos, M.R., Cushman, J.H., Kessler, D.P.: Moisture transport in shrinking gels during saturated drying. AICHE J. 43 (8), 2112–2122 (1997)
Osborn, G.S., White, G.M., Sulaiman, A.H., Walton, L.R.: Predicting equilibrium moisture properties of soybeans. Transactions of the ASAE 32 (6), 2109–2113 (1989)
Author information
Authors and Affiliations
Corresponding author
Additional information
Revised version: 5 October 2003
Rights and permissions
About this article
Cite this article
Singh, P., Maier, D., Cushman, J. et al. Effect of viscoelastic relaxation on moisture transport in foods. Part II: Sorption and drying of soybeans. J. Math. Biol. 49, 20–34 (2004). https://doi.org/10.1007/s00285-003-0250-6
Received:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s00285-003-0250-6