Abstract
An alternative way of fractionating lignocellulose biomass into its individual components, hemicelluloses, lignin and cellulose, was investigated. South African Eucalyptus grandis wood chips were fractionated using a combination of hot water and alkaline treatments with or without AQ. Initially, the biomass samples were treated in hot water to remove hemicelluloses. At optimum pre-fraction conditions, the data acquired revealed that almost 12 % of the E. grandis wood biomass could be recovered as hemicelluloses. When the hemicelluloses pre-extracted biomass was further treated using sodium hydroxide with or without AQ, the data indicated that the amount of lignin and cellulose that could be recovered was 22 and 36 %, respectively (as % of the wood mass). The substrate was characterised by a higher amount of α-cellulose (91–93 %), lower kappa no (12–13), viscosity (327–450 η mg/L) and DP (1078–1536). It was then presumed that such pulp could meet end-user requirement of the dissolving pulps. Industrial acceptance of this biomass fractionation concept, however, will further require careful assessments of various options for treating and purifying the hemicelluloses and lignin in their respect streams.
This is a preview of subscription content, log in via an institution to check access.
Similar content being viewed by others
References
Boussarsar H, Rage B, Mathlouthi M (2009) Optimisation of sugarcane bagasse conversion by hydrothermal treatment for recovery of xylose. J Bioresour Technol 100:6537–6542
Cheng H, Zhan H, Fu S, Lucia AL (2010) Alkali extraction of hemi cellulose from depithed corn stover and effects on soda–AQ pulping. J Bioresour 11(1):196–206
Christensen PK (1998) Wood and pulping chemistry, vol 1. Department of Chemical Engineering, Pulp and Paper Group, The Norwegian University of Science and Technology (NTNU), Trondheim
Corrales RC et al (2012) Structural evaluation of sugar cane bagasse steam pre-treated in the presence of CO2 and SO2. J Biotechnol Biofuel 5(36):1–8
García JC, Zamudio MAM, Perez A, Feria MJ, Lívio Gomide J, Colodette JL, López F (2011) Soda–AQ pulping of Paulownia wood after hydrolysis treatment. J Bioresour 6(2):971–986
Girio FM, Carvalheiro F, Duarte LC (2008) Hemicelluloses biorefineries: a review on biomass pre-treatments. J Sci Ind Res 67:849–864
Gullichsen J, Fogelholm C-J (1999) Chemical pulping pulp and paper making technology. Published in co-operation with the Finnish Paper Engineer’s Association and Tappi, McGraw Hill Book Company, Book 6A, Volume 6A
Hamelinck CN, Van Hooijdonk G, Faaij APC (2005) Ethanol from lignocelluloses biomass: techno-economic performance in short, middle and long term. Biomass Bioenerg 28:384–410
Janson J (1974) Analytics of polysaccharides in wood and pulp (Analytic der Polysaccharide in Holz and Zellstoff). Faserforsch Textiltech 25(9):375–382 (in German)
Johakimu JK, Andrew JA (2013) Hemicellulose extraction from South African Eucalyptus grandis using green liquor and its impact on kraft pulping efficiency and paper making properties. J Bioresour 8:3490–3504
Mosier NS, Hendrickson R, Brewer M, Ho N, Sedlak M, Dreshel R, Welch G, Dien BS, Aden A, Ladisch MR (2005) Industrial scale-up of pH-controlled liquid hot water pre-treatment of corn fibre for fuel ethanol production. J Appl Biochem Biotechnol 125:77–97
Nabarlatz D, Ebringerova A, Montane D (2007) Autohydrolysis of agricultural by-products for the production of xylose-oligosaccharides. J Carbohydr Polym 69:20–28
NNFCC Project no 10/003 (2009) Marketing study for biomass treatment technologies. www.nnfcc.co.uk. Accessed on March 2014
Öhman F (2006) Precipitation and separation of lignin from kraft black liquor. Ph.D. thesis, Chalmers Technical University, Gothenburg, Sweden
Pandey KK (1999) Study of chemical structure of soft and hardwood and wood polymers by FTIR spectroscopy. J Appl Polym Sci 71:1969–1975
Sixta H, Schild G (2009) A new generation Kraft process. J Lenz Berich 87:26–37
Sturgeoff LG, Pitl Y (1993) Low-kappa pulping without capital investment—use of anthraquinone for low kappa pulping. In: TAPPI proceedings, Atlanta, November 14–18, pp 423–429
Sun XF, Xu F, Sun RC, Fowler P, Bairdd MS (2005) Characteristics of degraded cellulose obtained from steam-exploded wheat straw. J Carbohydr Polym 340:97–106
Testova L, Borrega M, Tolonen LK, Penttilä PA, Serimaa R, Larsson PT, Sixta H (2014) Dissolving-grade birch pulps produced under various prehydrolysis intensities: quality, structure and applications. Cellulose 21:2007–2021
Tunc MS, Van Heiningen A (2008) Hemicelluloses extraction of mixed southern hardwoods with water at 150°C: effect of time. J Ind Eng Chem Res 47(18):7031–7037
Tunc MS, Lawoko M, Van Heiningen A (2010) Understanding the limitations of removal of hemicelluloses during autohydrolysis of a mixture of southern hardwoods. J Bioresour 5(1):356–371
Xiao L-P, Sun Z-J, Shi Z-J, Xu F, Sun R-C (2011) Impact of hot compressed water pre-treatment on the structural changes of woody biomass for bioethanol production. J Bioresour 6(2):1576–1598
Yang H, Zheng X, Yao L, Xie Y (2014) Structural changes of the lignin in the soda–AQ pulping process studied using the carbon-13 tracer method. J Bioresour 9(1):176–190
Yoon S-H, Van Heiningen A (2010) Green liquor extraction of hemicelluloses from southern pine in an integrated forest biorefinery. J Ind Eng Chem Res 16(1):74–80
Zheng Y, Pan Z, Zhang R (2009) Overview of biomass pre-treatment for cellulosic ethanol production. J Agric Biosci Eng Int 2(3):51–68
Acknowledgments
The authors wish to acknowledge CSIR for providing financial support which enabled the accomplishment of this research work (Project EIEB002). Special thanks are due to the technical staff at FFP laboratory for their assistance in performing the experiments.
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Johakimu, J.K., Jerome, A., Sithole, B.B. et al. Fractionation of organic substances from the South African Eucalyptus grandis biomass by a combination of hot water and mild alkaline treatments. Wood Sci Technol 50, 365–384 (2016). https://doi.org/10.1007/s00226-015-0764-2
Received:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s00226-015-0764-2