Avoid common mistakes on your manuscript.
Correction to: The International Journal of Advanced Manufacturing Technology (2019) 102:3995–4009
The original article contained a mistake.
Correction 1: Figure 7 is replaced with the following figure:
Convergence characteristics of PSO and TLBO
Correction 2: Figure 13 is missing with the following citation.
[4] Gupta MK, Sood PK (2017) Machining comparison of aerospace materials considering minimum quantity cutting fluid: a clean and green approach. Proc Inst Mech Eng C J Mech Eng Sci 231:1445–1464. https://doi.org/10.1177/0954406216684158
Author information
Authors and Affiliations
Corresponding authors
Additional information
Publisher's note
Springer Nature remains neutral with regard to jurisdictional claims in published maps and institutional affiliations.
Rights and permissions
Open Access This article is licensed under a Creative Commons Attribution 4.0 International License, which permits use, sharing, adaptation, distribution and reproduction in any medium or format, as long as you give appropriate credit to the original author(s) and the source, provide a link to the Creative Commons licence, and indicate if changes were made. The images or other third party material in this article are included in the article's Creative Commons licence, unless indicated otherwise in a credit line to the material. If material is not included in the article's Creative Commons licence and your intended use is not permitted by statutory regulation or exceeds the permitted use, you will need to obtain permission directly from the copyright holder. To view a copy of this licence, visit http://creativecommons.org/licenses/by/4.0/.
About this article
Cite this article
Gupta, M.K., Mia, M., Pruncu, C.I. et al. Correction to: Parametric optimization and process capability analysis for machining of nickel-based superalloy. Int J Adv Manuf Technol 124, 1337–1338 (2023). https://doi.org/10.1007/s00170-022-10571-y
Published:
Issue Date:
DOI: https://doi.org/10.1007/s00170-022-10571-y