Abstract
This paper describes a signal processing system in a Pulsed Doppler (PD) radar. It mainly consists of a velocity tracking loop and a digital signal processing auxiliary channel. With many signal processing techniques, the system successfully solves the signal detection and tracking at low SNR and the interference identification and rejection. The idea of system design is introduced in detail. Finally, some simulation and experimental results are presented.
This is a preview of subscription content, log in via an institution to check access.
Similar content being viewed by others
References
Mao Siyi, Pulsed Doppler Radar, The National Defense Industry Press, Beijing, 1990, Chapter 2, 4, 5.
Fan Laiyao, Software and Hardware Development of 32 bit Digital Signal Processor-TMS320 Family, Xi'an: Xidian University, 1990.
Zhao Shujie, Statistical Signal Processing, Xi'an: Xidian University, 1986, 209–244.
M. I. Skolnik, Introduction to Radar Systems, New York: McGraw-Hill Book Company, 1980, 380–384.
P. F. Guarguaglini, F. Marcoz,IEEE Trans on AES,AES-10(1974)3, 193–203.
Fan Laiyao, Ji Hongbing, A Study of Pulsed Doppler Signal Processing Technique, Proc. of ICSP'93, Beijing: 1993, 375–376.
Author information
Authors and Affiliations
About this article
Cite this article
Laiyao, F., Hongbing, J. Study of pulsed doppler signal processing and velocity tracking technique. J. of Electron.(China) 13, 122–128 (1996). https://doi.org/10.1007/BF02684752
Issue Date:
DOI: https://doi.org/10.1007/BF02684752