Abstract
Partial molar volumes and size factors were determined via density measurements for all of the major components in Type 316 stainless steel. All of the substitutional components were found to exhibit ideal behavior with respect to volume change upon mixing to better than 10 pct with the exception of silicon (which had a deviation of - 43.4 pct). Of the substitutional solutes only molybdenum was found to have a significant misfit or size parameter. Both carbon and nitrogen exhibit large positive size factors.
Similar content being viewed by others
References
L. A. Girifalco and D. 0. Welch:Point Defects and Diffusion in Strained Metals, Gordon and Breach, 1967.
T. R. Anthony: “Solute Segregation and Stresses Generated Around Growing Voids in Metals.” inRadiation Induced Voids in Metals, J. W. Corbett and L. C. Ianniello, eds., April 1972, U.S. Atomic Energy Commission, Office of Information Services.
H. Wiedersich:J. Metals, May 1964, pp. 425-30.
T. H. Blewitt: “Low-Temperature Irradiation Studies,” inRadiation Damcgein Solids, D. S. Billinton, ed., Academic Press, Inc., New York, 1962.
H. W. King:J Mater. Sci., 1966, vol. 1, pp. 79–90.
E. S. Barrett and T. B. Massalski:Structure of Metals, McGraw-Hill, 3rd ed., 1966.
“Handbook of Tables for Applied Engineering Science,” The Chemical Rubber Company, 1970.
S. D. Harkness and C. Y. Li: “Theoretical Study of the Swelling of Fast Neutron Irradiated Materials,”in Radiation Induced Voids in Metals, J. W. Corbett and L. C. Ianniello, eds., April 1972, U.S. Atomic Energy Commission, Office of Information Services.
H. R. Brager and J. L. Straalsund:ANS Trans., November 1972, vol. 15, no. 2, pp. 725–26.
Author information
Authors and Affiliations
Additional information
This report is based on work performed by Hanford Engineering Development Laboratory, Richland, Washington, operated by Westinghouse Hanford Company, a subsidiary of Westinghouse Electric Corporation, under United States Atomic Energy Commission Contract AT(15-l)-2170.
Rights and permissions
About this article
Cite this article
Straalsund, J.L., Bates, J.F. Partial molar volumes and size factor data for alloy constituents of stainless steel. Metall Trans 5, 493–498 (1974). https://doi.org/10.1007/BF02644119
Received:
Published:
Issue Date:
DOI: https://doi.org/10.1007/BF02644119