Abstract
The experiments involves three types of industrial wastes produced by iron works, which create serious hazards to the natural environment: (1) paint-shop sludge, (2) oil-polluted diatomite, and (3) oil-polluted scale. The choice of an appropriate and safe storage method should be based on extensive physicochemical examination.
DTA, in combination with other data, allows characterization of the combustible properties of wastes. Thermoanalytical measurements were carried out in a dynamic air atmosphere. Enthalpy values were calculated from peak areas of DTA curves. Thermoanalytical data were compared with calorimetric results obtained with an oxygen bomb.
Zusammenfassung
Drei Arten industrieller Abtälle eines Stahlwerks, die schwere Umweltbelastungen darstellen, wurden untersucht: (1) Lackiererei-Schlamm, (2) ölhaltiger Diatomit, (3) ölhaltiger Kesselstein. Geeignete sichere Deponien setzen ausführliche physikalisch-chemische Untersuchungen voraus. DTA in Kombination mit anderen Untersuchungen erlaubt die Charakterisierung der Verbrennungseigenschaften der Abfälle. Die thermoanalytischen Untersuchungen erfolgten im Luftstrom, die Verbrennungswärmen wurden aus den DTA-peak-Flächen berechnet. Die Ergebnisse werden mit denen kalorimetrischer Messungen in einer Sauerstoffbombe verglichen.
Резюме
Проведены экспериме нты с тремя видами промышленных отходо в чугунно-литейных предприятий, предста вляющих серьезную оп асность для окружающей среды. Сре ди них были шлам красильных цехо в, загрязненная масло м инфузорная земля и за грязненная маслом железная окалина. Выб ор уместного и безопа сного способа их хранения д олжен быть основан, исходя из их обширног о физико-химического исследования. Метод Д ТА в комбинации с другими методами дае т возможность охарак теризовать топливные свойства т аких отходов. Термоаналитические измерения были прове дены в динамической атмосф ере воздуха. Значения энтальпии были вычис лены из площадей пико в кривых ДТА. Термоаналитические данные были сопоставлены с калор иметрическими, получ енными в кислородной бомбе.
Similar content being viewed by others
References
J. Dobosz and M. Sebastian, Mat. Sem PZITS Regionalne systemy gospodarki odpadami, Katowice, 1985.
P. Litheraty, VIIth Seminar New Analytical methods in the chemistry of water, Bratislava, 1970 p. 393–402.
E. S. Kempa, Scientific Papers of the Institute of Environment Protection Engineering, Technical University of Wrocław, 12, 1976.
P. Balmer and B. Kaffehr, DTA for the characterization of the stability of sludges. Proc. of Sec. Europ. Symp. Vienna, 1980.
D. Urban and M. Antal, Fuel, 61 (1982) 799.
A. Zeman et al. Müll und Abfall 4 (1979) 82.
K. Bartoszewski, Mat. VIIth Sem. PZITS — Universität Stuttgart, Warszawa, 1985.
G. Lombardi, For Better Thermal Analysis ICTA. Mat. Istituto di Mineralogie e Petrografia dell Università di Roma, 1980.
G. Liptay, Atlas of Thermoanalytical Curves, Akadémiai Kiadó, Budapest, 1971.
K. Balog et al. Thermochim. Acta, 93 (1985) 167.
Author information
Authors and Affiliations
Rights and permissions
About this article
Cite this article
Sebastian, M., Dobosz, J.R. Thermoanalytical investigations of some industrial wastes produced in steel works. Journal of Thermal Analysis 33, 421–424 (1988). https://doi.org/10.1007/BF01913917
Issue Date:
DOI: https://doi.org/10.1007/BF01913917