Abstract
A nonlinear fracture mechanics model, which explains and reproduces the constitutive flexural behavior of a brittle-matrix composite, is proposed. It embraces in a unified dimensionless formulation two peculiar models, i.e., the cohesive-crack and the bridged-crack, which are used to analyze the composite failure process. Dimensionless parameters, which depend on the mechanical and geometrical properties, characterize the structure in flexure. It is shown that, based on the assumptions of the bridged-crack model, which simulates the composite as a multiphase material, the flexural response is controlled by two dimensionless parameters, whereas, based on the assumptions of the cohensive-crack model, which simulates the composite as a homogeneous material, the parameters reduce to one. The influence of the dimensionless parameters on the behavior is studied, along with the size-scale effects on the structural ductility. It is also shown how the matrix toughness affects the response. The two theoretical models are compared through the simulation of an experimental test on a fiber-reinforced beam, and it is shown that both the models can predict approximately the same overall behavior.
Similar content being viewed by others
References
B.N.Cox and D.B.Marshall, Concepts for bridged cracks in fracture and fatigue, Acta Metallurgica Materialia 42(2), (1994), 341–363.
G.I.Barenblatt, The formation of equilibrium cracks during brittle fracture. General ideas and hypotheses. Axially-symmetric cracks, Journal of Applied Mathematics and Mechanics 23(3), (1959), 622–636.
G.I.Barenblatt, The mathematical theory of equilibrium cracks in brittle fracture, in: H.L.Dryden and T.von Karman (eds), Advances in Applied Mechanics, Academic Press, New York (1962), 55–129.
D.S.Dugdale, Yielding of steel sheets containing slits, Journal of Mechanics and Physics of Solids 8(2), (1960), 100–104.
B.A.Bilby, A.H.Cottrell and K.H.Swinden, The spread of plastic yield from a notch, Proceedings Royal Society of London A272 (1963), 304–314.
J.R.Willis, A comparison of the fracture criteria of Griffith and Barenblatt, Journal of Mechanics and Physics of Solids 15 (1967), 151–162.
J.R.Rice, A path independent integral and the approximate analysis of strain concentration by notches and cracks, Journal of Applied Mechanics 35 (1968) 379–386.
A.Hillerborg, M.Modeer and P.E.Petersson, Analysis of crack formation and crack growth in concrete by means of fracture mechanics and finite elements, Cement and Concrete Research 6(6), (1976), 773–782.
R.Ballarini, S.P.Shah and L.M.Keer, Crack growth in cement-based composites, Engineering Fracture Mechanics 20(3), (1984), 433–445.
V.C.Li and E.Liang, Fracture processes in concrete and fiber reinforced cementitious composites, Journal of Engineering Mechanics 112(2), (1986), 566–586.
S.P.Shah, Fracture toughness of cement-based materials, Materials and Structures 21(122), (1988), 145–150.
T.Ungsuwarungsri and W.G.Knauss, Nonlinear analysis of an equilibrium craze: part I-problem formulation and solution, Journal of Applied Mechanics 55 (1988), 44–51.
A.Carpinteri, Cusp catastrophe interpretation of fracture instability, Journal of Mechanics and Physics of Solids 37(5), (1989), 567–582.
E.Smith, The size of the fully developed softening zone associated with a crack in a strain-softening material-I. A semi-infinite crack in a remotely loaded infinite solid, International Journal Engineering Science 27(3), (1989), 301–307.
B.Cotterell, P.Paramasivam and K.Y.Lam, Modeling the fracture of cementitious materials, Materials and Structures 25(145), (1992), 14–20.
A.Carpinteri, Stability of fracturing process in r.c. beams, Journal of Structural Engineering 110(3), (1984), 544–558.
Y.S.Jenq and S.P.Shah, Two parameter fracture model for concrete, Journal of Engineering Mechanics 111(10), (1985), 1227–1241.
D.B.Marshall, B.N.Cox and A.G.Evans, The mechanics of matrix cracking in brittle-matrix fiber composites, Acta Metallurgica Materialia 33 (1985), 2013–2021.
B.Budiansky, J.W.Hutchinson and A.G.Evans, Matrix fracture in fiber-reinforced ceramics, Journal of Mechanics and Physics of Solids 34 (1986), 167–189.
R.M.L.Foote, Y.-W.Mai and B.Cotterell, Crack growth resistance curves in strain-softening materials, Journal of Mechanics and Physics of Solids 34(6), (1986), 593–607.
Y.S.Jenq and S.P.Shah, Crack propagation in fiber-reinforced concrete, Journal of Structural Engineering 112(1), (1986), 19–34.
L.R.F.Rose, Influence of debonding on the efficiency of crack patching, Theoretical and Applied Fracture Mechanics 7 (1987), 125–132.
P.L.Swanson, C.J.Fairbanks, B.R.Lawn, Y.W.Mai and B.J.Hockey, Crack interface grain bridging as a fracture resistance mechanism in ceramics: II, theoretical fracture mechanics model, Journal of American Ceramic Society 70 (1987), 289–294.
F.Erdogan and P.F.Joseph, Toughening of ceramics through crack bridging by ductile particles, Journal of American Ceramic Society 72 (1989), 262–270.
R.Ballarini and S.Muju, Stability analysis of bridged cracks in brittle matrix composites, Journal of Engineering Gas Turbines Power 115 (1993), 127–138.
H.A.Luo and R.Ballarini, The effects of anisotropy on the nonlinear behavior of bridged cracks in long strips, Journal of Mechanics and Physics of Solids 42 (1994), 141–157.
K.Kendall, W.J.Clegg and R.D.Gregory, Growth of tied cracks: a model for polymer crazing, Journal Material Science Letter 10 (1991), 671–674.
B.N.Cox, Extrinsic factors in the mechanics of bridged cracks, Acta Metallurgica Materialia 39 (1991), 1189–1201.
B.N.Cox and D.B.Marshall, Stable and unstable solutions for bridged cracks in various specimens, Acta Metallurgica Materialia 39 (1991), 579–589.
C.Bosco and A.Carpinteri, Softening and snap-through behavior of reinforced elements, J. Engineering Mechanics 118(8), (1992), 1564–1577.
B.N.Cox and C.S.Lo, Load ratio, notch, and scale effects for bridged cracks in fibrous composites, Acta Metallurgica Materialia 40 (1992), 69–80.
C.Bosco and A.Carpinteri, Discontinuous constitutive response of brittle matrix fibrous composites, Journal of mechanics and Physics of Solids 43(2), (1995), 261–274.
S.J.Connel, F.W.Zok, Z.Z.Du and Z.Suo, On the tensile properties of a fiber reinforced titanium matrix composite-II. Influuence of notches and holes, Acta Metallurgica Materialia 42(10), (1994), 3451–3461.
A. Carpinteri and R. Massabó, Continuous versus discontinuous bridged crack model for fiber-reinforced materials in flexure, International Journal of Solids and Structures, in press.
A.Burakiewicz, Testing of fiber bond strength in cement matrix, in Swamy (ed.). Testing and test methods of fiber cement composites, The Construction Press Ltd, Lancaster, U.K., (1978), 355–369.
Comite Euro-International du Beton: CEB-FIB Model Code 1990, CEB Bulletin d'Information, Vol. 213–214 (1993).
H.Tada, P.C.Paris and G.Irwin, The Stress Analysis of Cracks Handbook, Paris Productions Incorporated (and Del Research Corporation), St. Louis, Missouri (1985).
A.Carpinteri, Static and energetic fracture parameters for rocks and concretes, Materials and Structures 14(81), (1981), 151–162.
E.Buckingham, Model experiments and the form of empirical equations, Transactions ASME 37 (1915), 263–296.
P.Tjiptobroto and W.Hansen, Tensile strain hardening and multiple cracking in high-performance cementbased composites containing discontinuous fibers, ACI Material Journal 90(1), (1993), 16–25.
A.Carpinteri, Size-scale transition from ductile to brittle failure: structural response vs. crack growth resistance curve, International Journal of Fracture 51 (1991), 175–186.
A.A.Griffith, The phenomena of rupture and flow in solids, Philosophical Transactions Royal Society London A221 (1921), 163–198.
Author information
Authors and Affiliations
Rights and permissions
About this article
Cite this article
Carpinteri, A., Massabó, R. Bridged versus cohesive crack in the flexural behavior of brittle-matrix composites. Int J Fract 81, 125–145 (1996). https://doi.org/10.1007/BF00033178
Received:
Accepted:
Issue Date:
DOI: https://doi.org/10.1007/BF00033178