Abstract
On the basis of a transformer-type eddy current transducer, a measuring system has been constructed that allows one to estimate the possibility of using the eddy current method for measuring the thickness of conductive and dielectric coatings deposited on a conductive substrate. The design of the measuring system and the measurement techniques are described. Data that demonstrate the dependence of the amplitude part of the signal on objects of various thicknesses are presented; the maximum object dimensions at which these measurements are feasible have been found experimentally.
Similar content being viewed by others
REFERENCES
Ptchelintsev, A. and Halleux, B., Thickness and conductivity determination of thin nonmagnetic coatings on ferromagnetic conductive substrates using surface coils, Rev. Sci. Instrum., 1998, vol. 69, no. 3, p. 1488.
Ghasr, M.T., Horst, M.J., Lechuga, M., and Rapoza, R., Accurate one-sided microwave thickness evaluation of lined-fiberglass composites, IEEE Trans. Instrum. Meas., 2015, vol. 64, no. 10, p. 2802.
Tai, C.C., Rose, J.H., Lechuga, M., and Moulder, J.C., Thickness and conductivity of metallic layers from pulsed eddy-current measurements, Rev. Sci. Instrum., 1996, vol. 67, no. 11, p. 3965.
Halleux, B., Ptchelintsev, A., and Limburg, S.B., Thickness and conductivity determination of thin coatings on ferromagnetic substrates in the case of cylindrical symmetry, Rev. Sci. Instrum., 1997, vol. 68, no. 9, p. 3533.
Takahashi, Y., Thickness evaluation of thermal spraying on boiler tubes by eddy current testing, Int. J. Appl Electromagn. Mech., 2012, vol. 39, no. 1, p. 419.
Barbosa, C.F., A simple formula for calculating the coating thickness of galvanized steel wires, IEEE Trans. Magn., 2014, vol. 50, no. 7, p. 1.
Tai, C.C., Characterization of coatings on magnetic metal using the swept-frequency eddy current method, Rev. Sci. Instrum., 2000, vol. 71, no. 8, p. 3161.
Yang, H.C. and Tai, C.C., Pulsed eddy-current measurement of a conducting coating on a magnetic metal plate, Meas. Sci. Technol., 2012, vol. 13, no. 8, p. 1259.
Noimaier, P., Eddy current phase method for measuring the thickness of electroplated coatings, V Mire Nerazrush. Kontrolya, 2008, no. 2 (40), p. 29.
Syas’ko, V.A., Bulatov, A.S., Koroteev, M.Yu., and Solomenchuk, P.V., Eddy current meter, RF Patent No. 2384839, 2011.
Bakunov, A.S. and Kaloshin, V.A., Evolution of thickness coating measurement, Kontrol’. Diagn., 2016, no. 1 (211), p. 27.
Bogdanov, N.G., Prikhod’ko, V.A., and Suzdal’tsev, A.I., Eddy current method of two-frequency control of products, RF Patent No. 2184931, 2002.
Syas’ko, V.A. and Ivkin, A.E., Measurement of the thickness of precious metal coatings using eddy current type of control, Tekhnol. Mashinostr., 2014, no. 8, p. 42.
Dmitriev, S., Ishkov, A., Katasonov, A., Malikov, V., and Sagalakov, A., Subminiature eddy current transducers for studying metal-dielectric junctions, Instrum. Exp. Tech., 2014, vol. 57, no. 6, p. 751.
Dmitriev, S., Ishkov, A., Katasonov, A., Malikov, V., and Sagalakov, A., Non-destructive testing of Al-Mg alloys by using the eddy-current method, MATEC Web of Conf., 2017, no. 106, p. 1.
Dmitriev, S.F., Ishkov, A.V., Katasonov, A.O., Sagalakov, A.M., and Shevtsova, L.I., Measurement system for studying flaws in alloy slabs by means of subminiature eddy-current transducers, Meas. Tech., 2017, vol. 60, no. 4, p. 372.
Dmitriev, S.F., Katasonov, A.O., Malikov, V.N., and Sagalakov, A.M., Flaw detection of alloys using the eddy-current method, Russ. J. Nondestr. Test., 2016, vol. 52, no. 1, p. 32.
Dmitriev, S.F., Katasonov, A.O., Malikov, V.N., and Sagalakov, A.M., Eddy-current measuring system for analysis of alloy defects and weld seams, Russ. Eng. Res., 2016, vol. 36, no. 8, p. 626.
Author information
Authors and Affiliations
Corresponding author
Ethics declarations
The authors declare they have no conflict of interest.
Additional information
Translated by M. Chubarova
About this article
Cite this article
Dmitriev, S.F., Ishkov, A.V., Katasonov, A.O. et al. Subminiature Eddy Current Transducers for Thickness Measurement Problems. J. Mach. Manuf. Reliab. 49, 783–786 (2020). https://doi.org/10.3103/S105261882009006X
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.3103/S105261882009006X