Skip to main content
SpringerLink
Log in

Deformation Properties of Elastic Adhesive in Adhesive Joints under Quasi-Static Low-Cycle Mechanical Loads

  • Published:
Polymer Science, Series D Aims and scope Submit manuscript

Abstract

The results of an analysis of the mechanical properties of an elastic adhesive in metal–ceramic adhesive joints under quasi-static low-cycle mechanical-shear loads are presented depending on the thermal and mechanical history of the samples. It is shown that the value of the maximum load in the load–strain diagram is not the only characteristic of the destruction of an adhesive joint. When this load is reached, the increase in deformation occurs without an increase in stress. It is assumed that, under this load, the formation of strands begins in the gluing. After a ten-cycle load, the Mullins–Patrikeev effect was not found in the studied samples.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Log in via an institution

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Institutional subscriptions

Fig. 1.
Fig. 2.
Fig. 3.
Fig. 4.
Fig. 5.

Similar content being viewed by others

Notes

  1. In the case of metal, this is the beginning of neck formation [5]. For elastomers, this phenomenon was discovered for the first time and, apparently, is associated with the formation of strands in the adhesive.

REFERENCES

  1. V. S. Erasov and E. I. Oreshko, “Fatigue test of metal materials (A review),” Aviatsionnye Materialy i Tekhnologii, No. 4, 59–70 (2020).

    Google Scholar 

  2. M. M. Reznikovskii and A. I. Lukomskaya, Mechanical Tests of Rubber (Khimiya, Moscow, 1968) [in Russian].

    Google Scholar 

  3. A. P. Petrova and G. V. Malysheva, Adhesives, Adhesive Binders, and Adhesive Prepregs (VIAM, Moscow, 2017) [in Russian].

    Google Scholar 

  4. Vishu Shakh, Handbook on Testing Plastic Masses and Reasons for Their Destruction (NOT, St. Petersburg, 2009).

    Google Scholar 

  5. Ya. B. Fridman, “Mechanical Properties of Metals,”, in Deformation and Disintegration (Mashinostroenie, Moscow, 1974) Part 1 [in Russian].

  6. A. V. Terekhin, Candidate’s Dissertation in Engineering (Moscow, 2016).

Download references

Author information

Authors and Affiliations

  1. State Scientific Center of the Russian Federation, JSC Obninsk Research and Production Enterprise Technologiya Named after A.G. Romashin, 249031, Obninsk, Kaluga oblast, Russia

    V. G. Tsverava, M. Yu. Rusin, A. V. Terekhin, D. V. Alekseev & P. Yu. Yakushkin

Authors
  1. V. G. Tsverava
    View author publications

    You can also search for this author in PubMed Google Scholar

  2. M. Yu. Rusin
    View author publications

    You can also search for this author in PubMed Google Scholar

  3. A. V. Terekhin
    View author publications

    You can also search for this author in PubMed Google Scholar

  4. D. V. Alekseev
    View author publications

    You can also search for this author in PubMed Google Scholar

  5. P. Yu. Yakushkin
    View author publications

    You can also search for this author in PubMed Google Scholar

Corresponding author

Correspondence to V. G. Tsverava.

Additional information

Translated by M. Drozdova

Rights and permissions

Reprints and permissions

About this article

Check for updates. Verify currency and authenticity via CrossMark

Cite this article

Tsverava, V.G., Rusin, M.Y., Terekhin, A.V. et al. Deformation Properties of Elastic Adhesive in Adhesive Joints under Quasi-Static Low-Cycle Mechanical Loads. Polym. Sci. Ser. D 15, 384–388 (2022). https://doi.org/10.1134/S1995421222030303

Download citation

  • Received:

  • Revised:

  • Accepted:

  • Published:

  • Issue Date:

  • DOI: https://doi.org/10.1134/S1995421222030303

Keywords:

Search

Navigation