Abstract
In this research, synergetic and separate influence of nano-carbon black (C.Bn) and SiC on the microstructure and flexural strength of ZrB2 were investigated. So, ZrB2 and ZrB2-30vol%-based composites containing 10 and 15 vol% C.Bn as well as ZrB2-15 vol% SiC were fabricated via spark plasma sintering at 1850 °C for soaking time of 8 min under the applied pressure of 35 MPa. Relative density was measured by Archimedes method. Microstructural evaluation was carried out by applying the field emission electron microscopy (FESEM), and flexural strength was measured by three-point bending test. It was found the relative density improves in the presence of C.Bn and SiC especially in synergetic state so that the full densification was gained in Z30Si10C.Bn and Z30Si15C.Bn composites through their reactions with impurities at 1850 °C. In the monolithic ZrB2 system, the C.Bn addition improves the flexural strength slightly to 300 MPa and 315 MPa from 290 MPa. However, co-doped 10 vol% C.Bn with 30 vol% SiC resulted to achieve maximum flexural strength of 486 MPa in comparison with individually applying each of them (395 MPa for Z30Si and 300 MPa for Z10 C.Bn).
Similar content being viewed by others
Data availability
The data are available from corresponding author on reasonable request.
References
FarhoudDarihaki ZB, Eatemadi R (2019) Effect of nano and micro SiC particles on the microstructure and fracture toughness of ZrB2-SiC nanocomposite produced by SPS method. Mater Res Exp. 6(9):095608
Mehdi ShahediAsl, M.G.K., Iman Farahbakhsh, Babak Mazinani, Zohre Balak, Synergetic effects of SiC and Csf in ZrB2-based ceramic composites. Part II: Grain growth. Ceramics International. 42(16): p. 18612-18619.
Monteverdew, F.d.r. (2007) Resistance to thermal shock and to oxidation of metal Diborides–sic ceramics for aerospace application. Journal of american ceramics societay 90:1130–1138
Asla MS, B.N., ZohreAhmadic, Mehran JaberiZamharirc, and M.S.A. MohammadrezaShokouhimehrd, Abbas SabahiNaminij, k, (2018) Effects of carbon additives on the properties of ZrB2–based composites: A review. Ceram Int 44(7):7334–7348
Mahdi Khoeinia AN, Zakeric M, Asld MS (2019) Pressureless sintering of ZrB2 ceramics codoped with TiC and graphite. Int J Refract Metals Hard Mater 81:189–195
Victor Zamoraa M, FernandoGuiberteaua AngelL, Ortiza, (2014) Effect of graphite addition on the spark-plasma sinterability of ZrB2 and ZrB2–SiC ultra-high-temperature ceramics. Ceramics Int. https://doi.org/10.1016/j.ceramint.2014.03.130
Wang Zhi WZ, Guodong S, Fabrication, (2011) mechanical properties and thermal shock resistance of a ZrB2-graphite ceramic. Int J Refract Metals Hard Mater 29:351–355
V.-H. Nguyena, b., ∗∗, Yaghoub Pazhouhanfarc,∗∗∗, Seyed Ali Delbarid, Shahrzad Shaddele,, Y.M. Aziz Babapoorf, Quyet Van Leh,∗,, and M.S.A. Mohammadreza Shokouhimehrd, ∗∗∗∗, Abbas Sabahi Naminij,k, Beneficial role of carbon black on the properties of TiC ceramics. Ceramics International, 2020. 46(15): p. 23544–23555.
NimaAkhlaghi ZB, Birgani EN (2019) Milling time and sintering parameters optimization to fabricate ZrB2–30 vol% SiC composite with highest thermal shock resistance. Mater Res express. 6(5):055606
https://materialsproject.org/materials/mp-1472#crystal_structure.
Asla MS, Y.P., Abbas SabahiNaminic, d, ShahrzadShaddele, and Mehdi Fattahif, Mohsen Mohammadia, (2020) Role of graphite nano-flakes on the characteristics of ZrB2-based composites reinforced with SiC whiskers. Diamond Related Mater. 105:107786
Zhang XH et al (2009) Mechanical properties and thermal shock resistance of ZrB2–SiC ceramic toughened with graphite flake and SiC whiskers. Scripta Mater 61(8):809–812
Fattahi M et al (2020) Strengthening of TiC ceramics sintered by spark plasma via nano-graphite addition. Ceramics Int 46:12400–12408
Hou Y et al (2013) Effects of graphite flake diameter on mechanical properties and thermal shock behavior of ZrB2–nanoSiC–graphite ceramics. Int J Refract Metal Hard Mater 41:133–137
Savari V, Balak Z, Shahedifar V (2022) Influence of graphite platelets with and without SiC on the densification and fracture toughness of ZrB2 ceramic sintered by SPS. Carbon Letters 32(6):1559–1566
Wang Z et al (2009) Microstructure and thermal shock behavior of ZrB2–SiC–graphite composite. Mater Chem Phys 113(1):338–341
Wang Z et al (2009) Effect of graphite flake on microstructure as well as mechanical properties and thermal shock resistance of ZrB2–SiC matrix ultrahigh temperature ceramics. J Alloy Compd 484(1):390–394
Zhou S, Wang Z, Zhang W (2009) Effect of graphite flake orientation on microstructure and mechanical properties of ZrB2–SiC–graphite composite. J Alloy Compd 485(1):181–185
Asl MS, B.N. and M.S.A. MohammadrezaShokouhimehrd, Abbas SabahiNaminij, k, (2018) TEM characterization of spark plasma sintered ZrB2–SiC–graphene nanocomposite. Ceram Int 44(13):15269–15273
Yadhukulakrishnan GB et al (2013) Spark plasma sintering of graphene reinforced zirconium diboride ultra-high temperature ceramic composites. Ceram Int 39(6):6637–6646
ShahediAsla M, n., ImanFarahbakhshb, BehzadNayebi, (2016) Characteristics ofmulti-walledcarbonnanotubetoughenedZrB2–SiC ceramic compositepreparedbyhotpressing. Ceramics Int 42(1):1950–1958
Yadhukulakrishnan GB et al (2012) Spark plasma sintering of silicon carbide and multi-walled carbon nanotube reinforced zirconium diboride ceramic composite. Mater Sci Eng, A 552:125–133
Iman Farahbakhsh ZA (2017) Mehdi Shahedi Asl, Densification, microstructure and mechanical properties of hot pressed ZrB2–SiC ceramic doped with nano-sized carbon black. Ceram Int 43(11):8411–8417
Shanbao Zhou ZW, Sun X, Han J (2010) Microstructure mechanical properties and thermal shock resistance of zirconium diboride containing silicon carbide ceramic toughened by carbon black. Mater Chem Phys 122:470–473
Farahbakhsh I, Ahmadi Z, ShahediAsl M (2017) Densification, microstructure and mechanical properties of hot pressed ZrB2–SiC ceramic doped with nano-sized carbon black. Ceramics Int 43(11):8411–8417
Khoeinia M, A.N., n, M. Zakeric, M. Tamizifard, H. Samadie, (2015) Comprehensive study on the effect of SiC and carbon additives on the pressureless sintering and microstructural and mechanical characteristics of new ultra-high temperature ZrB2 ceramics. Ceramics Int 41:1456–11463
Zhou S et al (2010) Microstructure, mechanical properties and thermal shock resistance of zirconium diboride containing silicon carbide ceramic toughened by carbon black. Mater Chem Phys 122(2):470–473
Asl MS, B.N., Mahdi GhassemiKakroudi, MohammadrezaShokouhimehr, (2019) Investigation of hot pressed ZrB2–SiC–carbon black nanocomposite by scanning and transmission electron microscopy. Ceramics Int 45(14):16759–16764
Balak Z, M.Z., Mohammad rezaRahimipour, Esmael Salahi, (2015) Taguchi design and hardness optimization of ZrB2-based composites reinforced with chopped carbon fiber and different additives and prepared by SPS. J Alloys Compound 639:617–625
Xinghong Zhang ZW, Sun X, Han W, Hong C (2008) Effect of graphite flake on the mechanical properties of hot pressed ZrB2–SiC ceramics. Mater Lett 62:4360–4362
Van-Huy N, Asl MS, Delbarid SA, WonJang Q-H, Mohammadi M, Mohammad rezaShokouhimehr, (2021) Effects of SiC on densification, microstructure and nano-indentation properties of ZrB2–BN composites. Ceram Int 47(7):9873–9880
ShahediAsl M et al (2019) Investigation of hot pressed ZrB2–SiC–carbon black nanocomposite by scanning and transmission electron microscopy. Ceram Int 45(14):16759–16764
Keyvan Kavakeb, Z.B., Hosein Kafashan, Densification and flexural strength of ZrB2–30 vol% SiC with different amount of HfB2. journal of refractory metals and hard materials 2019. 83: p. 104971.
AlirezaRezaie GH, Fahrenhunsoltz W (2007) Effect of Hot Pressing Time and Temperature on the Microstructure and Mechanical Properties of ZrB2-SiC. J Mater Sci 42(8):2735–2744
Author information
Authors and Affiliations
Corresponding author
Ethics declarations
Conflict of interest
There is no conflict of the author.
Additional information
Publisher's Note
Springer Nature remains neutral with regard to jurisdictional claims in published maps and institutional affiliations.
Rights and permissions
Springer Nature or its licensor (e.g. a society or other partner) holds exclusive rights to this article under a publishing agreement with the author(s) or other rightsholder(s); author self-archiving of the accepted manuscript version of this article is solely governed by the terms of such publishing agreement and applicable law.
About this article
Cite this article
Shahriari Asl, M., Balak, Z. Sinterability and flexural strength of monolithic ZrB2: role of nano-carbon black and SiC. Carbon Lett. 33, 1689–1697 (2023). https://doi.org/10.1007/s42823-023-00523-1
Received:
Revised:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s42823-023-00523-1