Abstract
Cyclic behavior of Alloy 617 M in forged condition at several strain amplitudes ranging from ± 0.25 to ± 0.8% was studied at test temperatures from 200 to 750 °C. Axial strain control tests were performed at strain ratio R = − 1. Cyclic stress response (CSR) curve was plotted for each testing condition. CSR showed initial cyclic hardening followed by saturation and sudden stress drop due to macroscopic crack generation for lower temperatures (200 °C), whereas continuous cyclic hardening followed by stress drop was observed at higher temperatures (> 200 °C). Higher hardening rate for ± 0.25% strain amplitude was observed especially at highest temperature. Dynamic strain aging phenomenon was distinctly observed at test temperatures above 650 °C. Upward shift of stress response with increasing strain amplitude was observed. Fractography study showed fine striation distributed over large area for ± 0.25% strain amplitude and extensive cracking for higher strain amplitudes; ± 0.6% and ± 0.8%. Strain life and Coffin–Manson plots were obtained.
Similar content being viewed by others
References
Guguloth K, Sivaprasad S, Chakrabarti D, Tarafder S (2014) Low-cyclic fatigue behavior of modified 9Cr-1Mo steel at elevated temperature. Mater Sci Eng A 604:196–206. https://doi.org/10.1016/j.msea.2014.02.076
Karnati AK, Sarkar A, Nagesha A, Parameswaran P, Sandhya R, Narasaiah N (2019) Evaluation of high cycle fatigue behaviour of Alloy 617M at 973 K: Haigh diagram and associated mechanisms. Int J Press Vessels Pip 172:304–312. https://doi.org/10.1016/j.ijpvp.2019.03.021
Klöwer J, Husemann RU, Bader M (2013) Development of nickel alloys based on Alloy 617 for components in 700°C power plants. Proc Eng 55:226–231. https://doi.org/10.1016/j.proeng.2013.03.247
Maile K (2013) Qualification of Ni-based alloys for advanced ultra supercritical plants. Proc Eng 55:214–220. https://doi.org/10.1016/j.proeng.2013.03.245
Rao KBS, Schiffers H, Schuster H, Nickel H (1988) Influence of time and temperature dependent processes on strain controlled low cycle fatigue behavior of Alloy 617. Metall Trans A 19(2):359–371. https://doi.org/10.1007/BF02652546
Rao CV, Srinivas NCS, Sastry GVS, Singh V (2019) Low cycle fatigue, deformation and fracture behaviour of Inconel 617 alloy. Mater Sci Eng A. https://doi.org/10.1016/j.msea.2019.138286
Rodriguez P, Mannan SL (1995) High temperature low cycle fatigue. Sadhana 20(1):123–164. https://doi.org/10.1007/BF02747287
Sarkar A, Ghosh C, Nagesha A, Mythili R (2020) Mechanisms of fatigue endurance in Alloy 617M at different temperatures (300–1023 K). J Mater Eng Perform 29(9):5663–5671. https://doi.org/10.1007/s11665-020-05013-3
Shankar V, Kumar A, Mariappan K, Sandhya R, Laha K, Bhaduri AK, Narasaiah N (2017) Occurrence of dynamic strain aging in Alloy 617M under low cycle fatigue loading. Int J Fatigue 100:12–20. https://doi.org/10.1016/j.ijfatigue.2017.03.001
Tytko D, Choi PP, Klöwer J, Kostka A, Inden G, Raabe D (2012) Microstructural evolution of a Ni-based superalloy (617B) at 700 °c studied by electron microscopy and atom probe tomography. Acta Mater 60(4):1731–1740. https://doi.org/10.1016/j.actamat.2011.11.020
Wright JK, Carroll LJ, Simpson JA, Wright RN (2013) Low cycle fatigue of Alloy 617 at 850 °C and 950 °C. J Eng Mater Technol Trans ASME 135(3):1–9. https://doi.org/10.1115/1.4023673
Acknowledgements
The authors gratefully acknowledge the support and assistance provided by Director, Visvesvaraya National Institute of Technology, Nagpur and Director, Indira Gandhi Center for Atomic Research, Kalpakkam during this project.
Author information
Authors and Affiliations
Corresponding author
Additional information
Publisher's Note
Springer Nature remains neutral with regard to jurisdictional claims in published maps and institutional affiliations.
Rights and permissions
About this article
Cite this article
Dupare, P.C., Mhaiske, A., Ballal, A.R. et al. Cyclic Behavior of Nickel-Based Superalloy 617 M at Elevated Temperature. Trans Indian Natl. Acad. Eng. 7, 677–683 (2022). https://doi.org/10.1007/s41403-021-00317-9
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s41403-021-00317-9