Skip to main content
SpringerLink
Log in

Zirconium Metal Production by Electrorefining of Zr Oxycarbide

  • Research Article
  • Published:
Journal of Sustainable Metallurgy Aims and scope Submit manuscript

Abstract

In the present study, a cost-affordable electrorefining process of zirconium (Zr) using an oxycarbide anode, which has been developed for titanium (Ti) smelting, was applied to Zr production. First, the synthesis of Zr oxycarbide by carbothermic reduction of ZrO2 was investigated, and a dense and conductive ZrC0.5O0.5 anode was successfully produced followed by sintering. The reduction steps of Zr ions in a chloride electrolyte were then electrochemically analyzed; the Zr (IV) ion was electrochemically reduced to Zr metal through the formation of a low-valence Zr (probably Zr (II)) ion. In contrast, Zr (IV) ion was stabilized by F− coordination in a chloride-fluoride electrolyte, and the reduction to Zr metal mainly occurred through a single step. The cathode reaction for electrorefining was checked, and Zr was obtained by galvanostatic electrolysis in a chloride-fluoride bath. The anode reaction using a ZrC0.5O0.5 anode was investigated, and the dissolution of Zr (IV) ion accompanied by CO evolution was observed. Electrorefining experiment showed that a series of electrorefining, anodic dissolution to form Zr ions, transportation of Zr ions from the anode to cathode, and cathodic reduction to produce metallic Zr were appropriately coordinated. For achieving good results in the electrolysis, it is essential to introduce F− ions into the electrolyte and to apply high cathode-current–density (optimally over 1000 mA·cm−2). Through the present study, the feasibility of Zr production based on the electrorefining of Zr oxycarbide synthesized by the carbothermic reduction of ZrO2 was demonstrated in principle.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Log in via an institution

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Institutional subscriptions

Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6
Fig. 7
Fig. 8
Fig. 9
Fig. 10
Fig. 11
Fig. 12
Fig. 13

Similar content being viewed by others

References

  1. Bedinger GM (2017) Zirconium and Hafnium. In: 2015 Minerals yearbook, US geological survey, Reston, VA

  2. Tsutsumi Y (2014) Corrosion resistance of Zr as metallic biomaterials. Zairyo-to-Kankyo 63(6):360–364 (in Japanese)

    Article  CAS  Google Scholar 

  3. Kobayashi E, Ando M, Tsutsumi Y, Doi H, Yoneyama T, Kobayashi M, Hanawa T (2007) Inhibition effect of zirconium coating on calcium phosphate precipitation of titanium to avoid assimilation with bone. Mater Trans 48(3):301–306

    Article  CAS  Google Scholar 

  4. Nomura N, Tanaka Y, Kondo R, Doi H, Tsutsumi Y, Hanawa T (2009) Effects of phase constitution of Zr-Nb alloys on their magnetic susceptibilities. Mater Trans 50(10):2466–2472

    Article  CAS  Google Scholar 

  5. Takeda O, Uda T, Okabe TH (2014) 2. Non-ferrous process principles and production technologies, Chapter 2.2 rare earth, titanium group metals, and reactive metal production. In: Seetharaman S (ed) Treatise on process metallurgy, vol 3. Elsevier Inc, Oxford, pp 995–1069

    Chapter  Google Scholar 

  6. Steinberg MA, Sibert ME, Wainer E (1954) Extractive metallurgy of zirconium by the electrolysis of fused salt II. J Electrochem Soc 101(2):63–78

    Article  CAS  Google Scholar 

  7. Raynes BC, Thellmann EL, Steinberg MA, Wainer E (1955) The extractive metallurgy of zirconium by the electrolysis of fused salt III. J Electrochem Soc 102(3):137–144

    Article  CAS  Google Scholar 

  8. Kirihara A, Shibata Y (1957) Refining of Zr metal for nuclear use I. Reports of the Government Industrial Research Institute, Nagoya 6(11):651–656. (in Japanese)

  9. Kirihara A, Shibata Y (1058) Refining of Zr metal for nuclear use II. Reports of the Government Industrial Research Institute, Nagoya 7(1):57–63. (in Japanese)

  10. Inman D, Hills GJ, Young L, JO’m B (1960) Some thermodynamic aspects of molten salts. Ann N Y Acad Sci 79:803–829

    Article  CAS  Google Scholar 

  11. Baboain R, Hill DL, Bailey RA (1965) Electrochemical study on zirconium and hafnium in molten LiCl-KCl eutectic. J Electrochem Soc 112(12):1221–1224

    Article  Google Scholar 

  12. Sakakura T (1966) Diffusion coefficients of Zr2+ and Zr4+ ions in NaCl-KCl (equ. mol) melts. Denki Kagaku 34:780–786 (in Japanese)

    CAS  Google Scholar 

  13. Swaroop B, Flengas SN (1966) Thermodynamic and electrochemical properties of zirconium chlorides in alkali chloride melts. Can J Chem 44:199–213

    Article  CAS  Google Scholar 

  14. Sakakura T (1970) Overpotentials of electrodeposition and dissolution of zirconium in a NaCl-KCl (equ. mol) melt. Denki Kagaku 38:423–428 (in Japanese)

    CAS  Google Scholar 

  15. Basile F, Chassaing E, Lorthioir G (1981) Electrochemical reduction of ZrCl4 in molten NaCl, CsCl and KCl-LiCl and chemical reactions coupled to the electrodeposition of zirconium. J Appl Electrochem 11:645–651

    Article  CAS  Google Scholar 

  16. Polyakova LP, Stangrit PT (1982) Cathodic processes at electrolysis of chloride and chloride-fluoride melts of zirconium. J Electrochimica Acta 27(11):1641–1645

    Article  CAS  Google Scholar 

  17. Basile F, Chassaing E, Lorthioir G (1984) Reduction of Zr(IV) in (KCl/NaCl) eutectic (50/50 mol%) containing KF/ZrCl4 in molar ratios of 6/1 or 4/1 at 750 & #xB0;C. Characterization of the dissolved species by IR spectroscopy. J Appl Electrochem 14:731–739

    Article  CAS  Google Scholar 

  18. Kipouros GJ, Flengas SN (1985) Electrorefining of zirconium metal in alkali chloride and alkali fluoride fused electrolyts. J Electrochem Soc 132(5):1087–1098

    Article  CAS  Google Scholar 

  19. Guang-Sen C, Okido M, Oki T (1990) Electrochemical studies of zirconium and hafnium in alkali chloride and alkali fluoride-chloride molten salts. J Appl Electrochem 20:77–84

    Article  Google Scholar 

  20. Sakamura Y (2004) Zirconium behavior in molten LiCl-KCl eutectic. J Electrochem Soc 151(3):C187–C193

    Article  CAS  Google Scholar 

  21. Abdelkader AM, Daher A, Abdelkareem RA, El-kashif E (2007) Preparation of zirconium metal by the electrochemical reduction of zirconium oxide. Metall Mater Trans B 38B:35–44

    Article  CAS  Google Scholar 

  22. Chen Z, Zhang M, Han W, Wang X, Tang D (2008) Electrodeposition of Zr and electrochemical formation of Mg–Zr alloys from the eutectic LiCl–KCl. J Alloys Compd 459:209–214

    Article  CAS  Google Scholar 

  23. Lee CH, Kang KH, Jeon MK, Heo CM, Lee YL (2012) Electrorefining of zirconium from zircaloy-4 cladding hulls in LiCl-KCl molten salts. J Electrochem Soc 159(8):D463–D468

    Article  CAS  Google Scholar 

  24. Park KT, Lee TH, Jo NC, Nersisyan HH, Chun BS, Lee HH (2013) Purification of nuclear grade Zr scrap as the high purity dense Zr deposits from Zirlo scrap by electrorefining in LiF–KF–ZrF4 molten fluorides. J Nucl Mater 436:130–138

    Article  CAS  Google Scholar 

  25. Park J, Choi S, Sohn S, Kim KR, Hwang IS (2014) Cyclic voltammetry on zirconium redox reactions in LiCl-KCl-ZrCl4 at 500◦C for electrorefining contaminated zircaloy-4 cladding. J Electrochem Soc 161(3):H97–H104

    Article  CAS  Google Scholar 

  26. Wainer E (1952) Cell feed material for the production of titanium. US Patent 2,868,703A, 1952

  27. Takeuchi S, Watanabe O (1964) On the extraction of titanium from the anode of TiO, TiC and Ti-C-O alloys by electrolysis in the molten salt bath. J Jpn Inst Met 28(10):627–632 (in Japanese)

    Article  CAS  Google Scholar 

  28. Hashimoto Y (1968) Fused salt electrolysis of titanium metal from Ti-C-O alloys or TiC. J Jpn Inst Met 32(12):1327–1333 (in Japanese)

    Article  CAS  Google Scholar 

  29. Jiao S, Zhu H (2006) Novel metallurgical process for titanium production. J Mater Res 21(9):2172–2175

    Article  CAS  Google Scholar 

  30. Withers JC, Loutfy RO, Laughlin JP (2007) Electrolytic process to produce titanium from TiO2 feed. Mater Technol 22(2):66–70

    Article  CAS  Google Scholar 

  31. Fray D (2012) Exploring novel uses of molten salts. ECS Trans 50(11):3–13

    Article  Google Scholar 

  32. Berger LM, Gruner W, Langholf E, Stolle S (1999) On the mechanism of carbothermal reduction processes of TiO2 and ZrO2. Int J Refract Met Hard Mater 17:235–243

    Article  CAS  Google Scholar 

  33. Song J, Wang Q, Wu J, Jiao S, Zhu H (2016) The influence of fluoride ions on the equilibrium between titanium ions and titanium metal in fused alkali chloride melts. Faraday Discuss 190:421–432

    Article  CAS  Google Scholar 

  34. Sangster J, Pelton AD (1987) Phase diagrams and thermodynamic properties of the 70 binary alkali halide systems having common ions. J Phys Chem Ref Data 16(3):509–561

    Article  CAS  Google Scholar 

  35. Barin I (1989) Thermochemical data of pure substances. VCH Verlagsgesellschaft mbH, Weinheim

    Google Scholar 

  36. Barton CJ, Sheil RJ, Grimes WR (1959) Phase diagrams of nuclear reactor materials. U.S.A.E.C., Report No. ONRL-2548, Contract No. W-7405. Edited by RE Thoma, Oak Ridge National Laboratory, Oak Ridge, TN, pp 1–205

  37. Askarova LK, Zhilyaev VA (1994) High-temperature oxidation of titanium and zirconium carbides at decreased air pressure. Russ J Inorg Chem 39(5):710–713

    Google Scholar 

  38. Bard A, Faulkner LR (2001) Electrochemical methods, fundamentals and applications, 2nd edn. Wiley, Hobken

    Google Scholar 

Download references

Author information

Authors and Affiliations

  1. Tohoku University, 6-6-02 Aramaki-Aza-Aoba, Aoba-ku, Sendai, 980-8579, Japan

    Osamu Takeda, Kenta Suda, Xin Lu & Hongmin Zhu

Authors
  1. Osamu Takeda
    View author publications

    You can also search for this author in PubMed Google Scholar

  2. Kenta Suda
    View author publications

    You can also search for this author in PubMed Google Scholar

  3. Xin Lu
    View author publications

    You can also search for this author in PubMed Google Scholar

  4. Hongmin Zhu
    View author publications

    You can also search for this author in PubMed Google Scholar

Corresponding author

Correspondence to Osamu Takeda.

Ethics declarations

Conflict of interest

On behalf of all authors, the corresponding author states that there are no conflicts of interest.

Additional information

The contributing editor for this article was U. Pal.

Rights and permissions

Reprints and permissions

About this article

Check for updates. Verify currency and authenticity via CrossMark

Cite this article

Takeda, O., Suda, K., Lu, X. et al. Zirconium Metal Production by Electrorefining of Zr Oxycarbide. J. Sustain. Metall. 4, 506–515 (2018). https://doi.org/10.1007/s40831-018-0199-8

Download citation

  • Published:

  • Issue Date:

  • DOI: https://doi.org/10.1007/s40831-018-0199-8

Keywords

Search

Navigation