Abstract
R2O3 (R = Y, Eu, Er) metal oxides were synthesized from metal–ethylenediaminetetraacetic acid (EDTA) complexes using a flame spray technique. As this technique enables high deposition rates, films with thickness of several tens of micrometers were obtained. Films of yttria, europia, and erbia phase were synthesized on stainless-steel substrates with reaction assistance by H2–O2 combustion gas. The oxide films consisted of the desired crystalline phase with micropores. The porosity of the films was in the range of 6–15%, varying with the metal used. These results suggest that the true density of the metal oxide obtained from metal–EDTA powder through the thermal reaction process plays an important role in achieving film with the desired porosity.
This is a preview of subscription content, log in via an institution to check access.
Similar content being viewed by others
References
W. Ma, S. Gong, H. Xu, and X. Cao, The Thermal Cycling Behavior of Lanthanum-Cerium Oxide Thermal Barrier Coating Prepared by EB-PVD, Surf. Coat. Technol., 2006, 200, p 5113-5118
A. Feuerstein, J. Knapp, T. Taylor, A. Ashary, A. Bolcavage, and N. Hitchman, Technical and Economical Aspects of Current Thermal Barrier Coating Systems for Gas Turbine Engines by Thermal Spray and EBPVD: a Review, J. Therm. Spray Technol., 2008, 17, p 199-213
H.J.C. Voorwald, R.C. Souza, W.L. Pigatin, and M.O.H. Cioffi, Evaluation of WC-17Co and WC-10Co-4Cr Thermal Spray Coatings by HVOF on the Fatigue and Corrosion Strength of AISI, 4340 Steel, Surf. Coat. Technol., 2005, 190, p 155-164
V. Shklover, L. Braginsky, G. Witz, M. Mishrikey, and C. Hafner, High-Temperature Photonic Structures. Thermal Barrier Coatings, Infrared Sources and Other Applications, J. Comput. Theor. Nanosci., 2008, 5, p 862-893
R.A. Rosu, I. Bran, M. Popescu, and C. Opriş, In Vitro Characterization of Hydroxyapatite Layers Deposited by APS and HVOF Thermal Spraying Methods, Ceram. Sililk., 2012, 56, p 25-31
M.S. Hussain, The Synthesis of Nanostructured NiCrAlY Powders for Plasma Sprayed Thermal Barrier Coatings, Adv. Phys. Theor. Appl., 2013, 13, p 1-9
G.C. Saha and T.I. Khan, Comparative Abrasive Wear Study of HVOF Coatings Obtained by Spraying WC-17Co Microcrystalline and Duplex Near-Nanocrystalline Cermet Powders, J. Eng. Mater. Technol., 2011, 133,041002-1-041002-8 (8 page)
F. Chen, F. Li, Q. Shen, and L. Zhang, Cold Spray and Pressureless Sintering of Zirconium Phosphate Bonded Silicon Nitride Ceramics with Porous Gradient Structure, J. Phys. Conf. Ser., 2013, 419, 012006 (6 pages).
H. Saitoh, K. Kawahara, S. Ohshio, A. Nakamura, and N. Nambu, Synthesis of Blue Phosphor by Decomposition of Metal Complex Powder, J. Ceram. Sci. Jpn., 2002, 110, p 874-876
H. Saitoh, R. Satoh, A. Nakamura, N. Nambu, and S. Ohshio, Metal Oxide Powder Synthesized with Amorphous Metal Chelates, J. Mater. Sci., 2002, 37, p 4315-4320
H. Saitoh, K. Kawahara, S. Ohshio, A. Nakamura, and N. Nambu, Metal Composition of Y2O3:Eu Powder Evaluated Using Particle Analyzer, Sci. Technol. Adv. Mater., 2005, 6, p 205-209
N. Tanaka, S. Ohshio, H. Saitoh, and K. Uematsu, Crystal Growth of Highly Oriented Zinc Oxide by Laser Deposition Technique with Metal-EDTA (Ethylene Diamine Tetra-Acetic Acid) Complexes, Jpn. J. Appl. Phys., 1998, 37, p L1165-L1168
N. Tanaka, H. Wakabayashi, S. Mochizuki, S. Ohshio, and H. Saitoh, Synthesis of Y-Ba-Cu-O Films with Ethylene Diamine Tetraacetic Acid Complexes Assisted by Excimer-Laser Ablation, J. Mater. Res., 1998, 13, p 2775-2778
A. Nakamura, R. Satoh, S. Ohshio, N. Nambu, and H. Saitoh, Laser Deposition of (Sr, Ba)TiO3 Films with Metal-Ethylenediaminetetraaceticacid Complexes, Jpn. J. Appl. Phys., 2002, 41, p 3033-3038
H. Akasaka, M. Ohto, Y. Hasebe, A. Nakamura, S. Ohshio, and H. Saitoh, Yttria Coating Synthesized by Reactive Flame Spray Process Using Y-EDTA Complex, Surf. Coat. Technol., 2012, 205, p 3877-3880
J. Kitamura, H. Mizuno, N. Kato, and I. Aoki, Plasma-Erosion Properties of Ceramic Coating Prepared by Plasma Spraying, Mater. Trans., 2006, 47, p 1677-1683
K. Komatsu,T. Tsuchiya, Y. Hasebe, T. Sekiya, A. Toyama, A. Nakamura, H. Akasaka, H. Saitoh, Synthesis of Metal Oxide Particles Using Reaction Route from Rare-Earth Metal-EDTA Complexes, accepted to J. Therm. Spray Technol.
K. Daijiten 3 (in Japanese), Kyoritsu Shuppan Co., Ltd., p. 895
E.R. Andrievskaya, Phase Equilibria in the Refractory Oxide Systems of Zirconia, Hafnia and Yttria with Rare-Earth Oxides, J. Eur. Ceram. Soc., 2008, 28, p 2363-2388
X. Li, P. Wu, H. Qiu, S. Chen, and B. Song, Crystallization Behavior and Mechanical Properties of Erbium Oxide Coatings Fabricated by Pulsed Magnetron Sputtering, Thin Solid Films, 2011, 520, p 2316-2320
K.-R. Ernst, J. Braeutigam, F. Gaertner, and T. Klassen, Effect of Substrate Temperature on Cold-Gas-Sprayed Coatings on Ceramic Substrates, J. Therm. Spray Technol., 2013, 22, p 422-432
J. Wu, H. Fang, S. Yoon, C. Lee, and H.-J. Kim, Critical Velocities for High Speed Particle Deposition in Kinetic Spraying, Mater. Trans., 2006, 47, p 1723-1727
P. Fogarassy, D. Gerday, and A. Lodini, Agglomerated Nanostructured Particles Disintegration During the Plasma Thermal Spraying Process, Mech. Res. Commun., 2005, 32, p 221-239
K. Daijiten 3(in Japanese), Kyoritsu Shuppan, p 944
K. Daijiten 3(in Japanese), Kyoritsu Shuppan, p 897
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Komatsu, K., Sekiya, T., Toyama, A. et al. Deposition of Metal Oxide Films from Metal–EDTA Complexes by Flame Spray Technique. J Therm Spray Tech 23, 833–838 (2014). https://doi.org/10.1007/s11666-014-0104-3
Received:
Revised:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s11666-014-0104-3