Abstract
Low-cost solder–graphite composite sheets (≥55 vol.% solder), with solder and graphite forming interpenetrating networks to a degree, are excellent thermal interface materials (TIMs). Solders 63Sn-37Pb and 95.5Sn-4Ag-0.5Cu are separately used, with the latter performing better. In composite fabrication, a mixture of micrometer-size solder powder and ozone-treated exfoliated graphite is compressed to form a graphite network, followed by fluxless solder reflow and subsequent hot pressing to form the solder network. The network connectivity (enhanced by ozone treatment) is lower in the through-thickness direction. The electrical conductivity obeys the rule of mixtures (parallel model in-plane and series model through-thickness), with anisotropy 7. Thermal contact conductance ≤26 × 104 W/(m2 K) (with 15-μm-roughness copper sandwiching surfaces), through-thickness thermal conductivity ≤52 W/(m K), and in-plane thermal expansion coefficient 1 × 10−5/°C are obtained. The contact conductance exceeds or is comparable to that of all other TIMs, provided that solder reflow has occurred and the composite thickness is ≤100 μm. Upon decreasing the thickness below 100 μm, the sandwich thermal resistivity decreases abruptly, the composite through-thickness thermal conductivity increases abruptly to values comparable to the calculated values based on the rule of mixtures (parallel model), and the composite–copper interfacial thermal resistivity (rather than the composite resistivity) becomes dominant.
Article PDF
Similar content being viewed by others
Avoid common mistakes on your manuscript.
References
D.D.L. Chung, Adv. Microelectron. 33, 8 (2006).
T.A. Howe, C.K. Leong, and D.D.L. Chung, J. Electron. Mater. 35, 1628 (2006).
C.K. Leong and D.D.L. Chung, Carbon 42, 2323 (2004).
C.K. Leong and D.D.L. Chung, Carbon 41, 2459 (2003).
C.K. Leong, Y. Aoyagi, and D.D.L. Chung, J. Electron. Mater. 34, 1336 (2005).
C. Lin and D.D.L. Chung, Carbon 45, 2922 (2007).
C. Lin and D.D.L. Chung, Carbon 47, 295 (2009).
A. Yu, P. Ramesh, M.E. Itkis, E. Bekyarova, and R.C. Haddon, J. Phys. Chem. C 111, 7565 (2007).
Y. Xu, X. Luo, and D.D.L. Chung, J. Electron. Packag. 122, 128 (2000).
C. Lin and D.D.L. Chung, J. Mater. Sci. 42, 9245 (2007).
C.K. Leong, Y. Aoyagi, and D.D.L. Chung, Carbon 44, 435 (2006).
M. Rosshirt, D. Fabris, C. Cardenas, P. Wilhite, T. Tu, and C.Y. Yang, Mater. Res. Soc. Symp. Proc. 1158, F03 (2009).
R. Cross, B.A. Cola, T. Fisher, X. Xu, K. Gall, and S.A. Graham, Nanotechnology 21, 445705 (2010).
J.R. Wasniewski, D.H. Altman, S.L. Hodson, T.S. Fisher, A. Bulusu, S. Graham, and B.A. Cola, J. Electron. Packag. 134, 020901 (2012).
J.H. Taphouse, O.L. Smith, S.R. Marder, and B.A. Cola, Adv. Funct. Mater. 24, 465 (2014).
H. Wang, J.Y. Feng, X.J. Hu, and K.M. Ng, Chem. Eng. Sci. 65, 1101 (2010).
Z.L. Gao, K. Zhang, and M.M.F. Yuen, Nanotechnology 22, 1 (2011).
D. Fabris, M. Rosshirt, C. Cardenas, P. Wilhite, T. Yamada, and C.Y. Yang, J. Electron. Packag. 133, 1 (2011).
A. Hamdan, J. Cho, R. Johnson, J. Jiao, D. Bahr, R. Richards, and C. Richards, Nanotechnology 21, 1 (2010).
D.D.L. Chung, Carbon 50, 3342 (2012).
C. Lin and D.D.L. Chung, J. Electron. Mater. 37, 1698 (2008).
S.H. Anderson and D.D.L. Chung, Carbon 22, 253 (1984).
D.D.L. Chung, J. Mater. Sci. 22, 4190 (1987).
M. Inagaki, F. Kang, and M. Toyoda, Chem. Phys. Carbon 29, 1 (2004).
X.H. Wei, L. Liu, J.X. Zhang, J.L. Shi, and Q.G. Guo, J. Mater. Sci. 45, 2449 (2010).
A. Celzard, J.F. Mareche, and G. Furdin, Prog. Mater. Sci. 50, 93 (2005).
S.G. Ionov, V.V. Avdeev, S.V. Kuvshinnikov, and E.P. Pavlova, Mol. Cryst. Liq. Cryst. Sci. Technol. A 340, 349 (2000).
D.D.L. Chung, J. Mater. Eng. Perform. 9, 161 (2000).
E.E. Marotta and S.J. Mazzuca, IEEE Trans. Compon. Packag. Manuf. Technol. 28, 102 (2005).
H.F. Lu, W.S. Kuo, and T.H. Ko, SAMPE Conf. Proc. 51, 1 (2006).
R.J. Warzoha, D. Zhang, G. Feng, and A.S. Fleischer, Carbon 61, 441 (2013).
S. Ganguli, A.K. Roy, R. Wheeler, V. Varshney, F. Du, and L. Dai, J. Mater. Res. 28, 933 (2013).
I. Dutta, R. Raj, P. Kumar, T. Chen, C.M. Nagaraj, J. Liu, M. Renavikar, and V. Wakharkar, J. Electron. Mater. 38, 2735 (2008).
C.P. Chiu, J.G. Maveety, and Q.A. Tran, Microelectron. Reliab. 42, 93 (2002).
K.H. Prakash and T. Sritharan, Acta Mater. 49, 2481 (2001).
S.M.L. Nai, J. Wei, and M. Gupta, Mater. Sci. Eng. A 423, 166 (2006).
C.T. Ho and D.D.L. Chung, J. Mater. Res. 5, 1266 (1990).
P.M. Raj, P.R. Gangidi, N. Nataraj, N. Kumbhat, G.C. Jha, and R. Tummala, IEEE Trans. Compon. Packag. Manuf. Technol. 3, 989 (2013).
L. Yang, C. Du, J. Dai, N. Zhang, and Y. Jing, J. Mater. Sci. Mater. Electron. 24, 4180 (2013).
H. Huang, X. Wei, F. Liao, and L. Zhou, J. Wuhan Univ. Technol. Mater. Sci. Ed. 24, 206 (2009).
Y.D. Han, H.Y. Jing, S.M.L. Nai, L.Y. Xu, C.M. Tan, and J. Wei, Intermetallics 31, 72 (2012).
H. Chen, Y. Zhao, and C. Chen, Front. Heat Mass Transf. 4, 013004 (2013).
Y. Zhao, D. Strauss, T. Liao, Y.C. Chen, and C.L. Chen, in Proceedings of the ASME/JSME 2011 8th Thermal Engineering Joint Conference, AJTEC2011-44169, vol. 3 (2011), pp. 83–89.
T. Oku, J. Nucl. Sci. Technol. 32, 816 (1995).
P. Chen and D.D.L. Chung, Carbon 77, 538 (2014)
T. Siewert, S. Liu, D.R. Smith, and J.C. Madeni, Database for Solder Properties with Emphasis on New Lead-Free Solders (National Institute of Standards and Technology and Colorado School of Mines, 2002, Release 4.0).
P. Chen and D.D.L. Chung, Carbon 61, 305 (2013).
D.D.L. Chung, Carbon 68, 646 (2014).
X. Luo, R. Chugh, B.C. Biller, Y.M. Hoi, and D.D.L. Chung, J. Electron. Mater. 31, 535 (2002).
K. Hu and D.D.L. Chung, Carbon 49, 1075 (2011).
X. Fu, W. Lu, and D.D.L. Chung, Carbon 36, 1337 (1998).
X. Hu, L. Jiang, and K.E. Goodson, in 20th IEEE SEMI-THERM Symposium (2004), pp. 98–103.
B. Feng, F. Faruque, P. Bao, A.T. Chien, and S. Kumar, Appl. Phys. Lett. 102, 093105-1-4 (2013).
J. Xu, A. Munari, E. Dalton, A. Mathewson, and K.M. Razeeb, J. Appl. Phys. 106, 4310 (2009).
H. Chen, M. Chen, J. Di, G. Xu, H. Li, and Q. Li, J. Phys. Chem. C 116, 3903 (2012).
H. Chen, H. Wei, M. Chen, F. Meng, H. Li, and Q. Li, Appl. Surf. Sci. 283, 525 (2013).
R.N. Das, E. Chenelly, E. Kopp, D. Alcoe, M.D. Poliks, and V.R. Markovich, in IEEE Electronic Components and Technology Conference 2012; 62nd, pp. 1442–1447.
Y. Zhang, Y. Xu, E. Suhir, C. Gu, and X. Liu, J. Phys. D 41, 1 (2008).
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Sharma, M., Chung, D.D.L. Solder–Graphite Network Composite Sheets as High-Performance Thermal Interface Materials. J. Electron. Mater. 44, 929–947 (2015). https://doi.org/10.1007/s11664-014-3589-0
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s11664-014-3589-0