Abstract
The current study investigates the ceramic oxide coatings formed on commercially pure Ti substrate via plasma electrolytic oxidation (PEO) technique in electrolytes with different chemical compositions. The effects of electrolyte on the discharge characteristics, macro- and micro-structure, thickness, phase compositions, and corrosion behaviors of coatings were evaluated. Five kinds of electrolytes based on the sodium salt compounds including aluminate, phosphate, silicate, aluminate-phosphate, and aluminate-silicate were used. The PEO processes were carried out at fixed voltage (420 V) for 180 seconds. The morphology and phase composition of samples were investigated using scanning electron microscope (SEM) and X-ray diffractometer (XRD), respectively. The corrosion behavior of specimens was analyzed in a 3.5 wt pct NaCl solution using the electrochemical impedance spectroscopy (EIS) and potentiodynamic polarization tests. The results showed that the most uniform and dense structure with less porosity was obtained in the coating prepared in aluminate-phosphate-based electrolyte. This coating consisted of TiO2 (Rutile and Anatase) and TiAl2O5 phases. Also, it was confirmed that the noblest corrosion potential and lowest corrosion current density, and consequently, the best corrosion behavior (22.96 × 107 Ω cm2), were observed for aluminate-phosphate-based electrolyte. The Mott–Schottky analysis exhibited that all samples had n-type semiconducting behavior. The coating prepared in aluminate-phosphate-based electrolyte possessed the lowest donor densities.
Similar content being viewed by others
References
A. Alsaran, G. Purcek, I. Hacisalihoglu, Y. Angelo, Ö. Bayrak, I. Karaman, and A. Celik, Surf. Coat. Technol., 2011, vol. 205, pp. S537-S542.
M. Molaei, A. Fattah-Alhosseini, and S. O. Gashti, Metall. Mater. Trans. A, 2018, vol. 49, pp. 368-375.
YL Cheng, XQ Wu, Z Xue, E Matykina, P Skeldon, and GE Thompson, Surf. Coat. Technol., 2013, vol. 217, pp. 129-139.
S. Hariprasad, M. Ashfagh, T. Arunnellaiappan, M. Harilal, and N. Rameshbabu, Surf. Coat. Technol., 2016, vol. 292, pp. 20-29.
T.E. Park, H.Ch. Choe, and W.A. Brantley, Surf. Coat. Technol., 2013, vol. 235, pp. 706-713.
M. Mu, J. Liang, X. Zhou, and Q. Xiao, Surf. Coat. Technol., 2013, vol. 214, pp. 124-130.
M. Aliofkhazraei, R. S. Gharabagh, M. Teimouri, M. Ahmadzadeh, Gh. B. Darband, and H. Hasannejad, J. Alloys Compd., 2016, vol. 685, pp. 376-383.
M. Shokouhfar and S.R. Allahkaram, Surf. Coat. Technol., 2016, vol. 291, pp. 396-405.
S. K. Yazıcı, F. Muhaffel, and M. Baydogan, Appl. Surf. Sci., 2014, vol. 318, pp. 10-14.
S. Sarbishei, M.A. Faghihi Sani, and M.R. Mohammadi, Ceram. Int., 2016, vol. 42, pp. 8789-8797.
Ch.Ch. Tseng, J.L. Lee, T.H. Kuo, Sh.N. Kuo, and K.H. Tseng, Surf. Coat. Technol., 2012, vol. 206, pp. 3437-3443.
E. Matykina, A. Berkani, P. Skeldon, and G.E. Thompson, Electrochim. Acta, 2007, vol. 53, pp. 1987-1994.
M. Babaei, Ch. Dehghanian, and M. Babaei, Surf. Coat. Technol., 2015, vol. 279, pp. 79-91.
S. Durdu, Ö. F. Deniz, I. Kutbay, and M. Usta, J. Alloys Compd., 2013, vol. 551, pp. 422-429.
S. Stojadinović, R. Vasilić, M. Petković, and L Zeković, Surf. Coat. Technol., 2011, vol. 206, pp. 575-581.
X. Shi, L. Xu, and Q. Wang, Surf. Coat. Technol., 2010, vol. 205, pp. 1730-1735.
M. Khorasanian, A. Dehghan, M.H. Shariat, M.E. Bahrololoom, and S. Javadpour, Surf. Coat. Technol., 2011, vol. 206, pp. 1495-1502.
O.A. Galvis, D. Quintero, J.G. Castaño, H. Liu, G.E. Thompson, P. Skeldon, and F. Echeverría, Surf. Coat. Technol., 2015, vol. 269, pp. 238-249.
F.Y. Teng, I.Ch. Tai, M.W. Wang, Y.J. Wang, Ch.Ch. Hung, and Ch.Ch. Tseng, J. Taiwan Inst. Chem. Eng., 2014, vol. 45, pp. 1331-1337.
H.P. Teng, Ch.J. Yang, J.F. Lin, Y.H. Huang, and F.H. Lu, Electrochim. Acta, 2016, vol. 193, pp. 216-224.
H. Tang, Q. Sun, T. Xin, Ch. Yi, Zh. Jiang, and F. Wang, Curr. Appl. Phys., 2012, vol. 12, pp. 284-290.
K. Venkateswarlu, N. Rameshbabu, D. Sreekanth, A.C. Bose, V. Muthupandi, N.K. Babu, and S. Subramanian, Appl. Surf. Sci., 2012, vol. 258, pp. 6853-6863.
A. Fattah-alhosseini, S. O. Gashti, and M. Molaie, J. Mater. Eng. Perform., 2018, vol. 27, pp. 825-834.
M. Shokouhfar, C. Dehghanian, M. Montazeri, and A. Baradaran, Appl. Surf. Sci., 2012, vol. 258, pp. 2416-2423.
Y.H. Wang, Zh.G. Liu, J.H. Ouyang, Y.M. Wang, and Y. Zhou, J. Alloys Compd., 2015, vol. 647, pp. 431-437.
M. Shokouhfar, C. Dehghanian, and A. Baradaran, Appl. Surf. Sci., 2011, vol. 257, pp. 2617-2624.
A.L. Yerokhin, X. Nie, A. Leyland, and A. Matthews, Surf. Coat. Technol., 2000, vol. 130, pp. 195-206.
K. Venkateswarlu, N. Rameshbabu, D. Sreekanth, M. Sandhyarani, A.C. Bose, V. Muthupandi, and S. Subramanian, Electrochim. Acta, 2013, vol. 105, pp. 468-480.
H. Dong, ed.: Surface Engineering of Light Alloys, Wood head Publishing Limited, Cambridge, 2010, p. 126.
F. Liu, J.L. Xu, D.Z. Yu, F.P. Wang, and L.C. Zhao, Mater. Chem. Phys., 2010, vol. 121, pp. 172-177.
J. Liang, P. Bala Srinivasan, C. Blawert, M. Störmer, W. Dietzel, Electrochim. Acta, 2009, vol. 54, pp. 3842-3850.
A. Fattah-alhosseini and M. SabaghiJoni, J. Mater. Eng. Perform., 2015, vol. 24, pp. 3444-3452.
K.R. Shin, Y.S. Kim, G.W. Kim, H.W. Yang, Y.G. Ko, and D.H. Shin, Appl. Surf. Sci., 2015, vol. 347, pp. 574-582.
Zh. Yao, B. Hu, Q. Shen, A. Niu, Zh. Jiang, P. Su, and P. Ju, Surf. Coat. Technol., 2014, vol. 253, pp. 166-170.
F. Liu, J. Yu, Y. Song, D. Shan, E.H. Han, Mater. Chem. Phys., 2015, vol. 162, pp. 452-460.
P. Zhang, X. Nie, H. Hua, Y. Liu, Surf. Coat. Technol., 2010, vol. 205, pp. 1508-1514.
M. Roknian, A. Fattah-alhosseini, and S. O. Gashti, J. Mater. Sci. Technol., 2018, vol. 27, pp. 1343-1351.
VS de Viteri, R Bayón, A Igartua, G Barandika, JE Moreno, CP-J Peremarch, and MM Pérez, Appl. Surf. Sci., 2016, vol. 367, pp. 1-10.
A. Kazek-Kęsik, G. Dercz, K. Suchanek, I. Kalemba-Rec, J. Piotrowski, and W. Simka, Surf. Coat. Technol., 2015, vol. 276, pp. 59-69.
H.Y. Wang, R.F. Zhu, Y.P. Lu, G.Y. Xiao, K. He, Y.F. Yuan, X.N. Ma, and Y. Li, Appl. Surf. Sci., 2014, vol. 292, pp. 204-212.
A. Fattah-Alhosseini, M. Vakili-Azghandi, and M. K. Keshavarz: Acta Metall. Sin. (Engl. Lett.), 2016, vol. 29, pp. 274–81.
Zh. Yao, Zh. Jiang, Sh. Xin, X. Sun, and X. Wu, Electrochim. Acta, 2005, vol. 50, pp. 3273-3279.
Zh. Yao, Zh. Jiang, X. Sun, Sh. Xin, and Zh. Wu, Mater. Chem. Phys., 2005, vol. 92, pp. 408-412.
Zh. Yao, Zh. Jiang, and F. Wang, Electrochim. Acta, 2007, vol. 52, pp. 4539-4546.
R.O. Hussein, X. Nie, and D.O. Northwood, Mater. Chem. Phys., 2012, vol. 134, pp. 484-492.
M. Babaei, Ch. Dehghanian, and M. Vanaki, Appl. Surf. Sci., 2015, vol. 357, pp. 712-720.
J. Ma, C.Z. Wang, C.L. Ban, C.Z. Chen, and H.M. Zhang, Vacuum, 2016, vol. 125, pp. 48-55.
D.R. Lide, ed.: CRC Handbook of Chemistry and Physics, CRC Press, Boca Raton, 1985.
D.D. Macdonald, J. Electrochem. Soc., 2006, vol. 153, pp. B213-B224.
D.D. Macdonald, Arab. J. Sci. Eng., 2012, vol. 37, pp. 1143-1185.
D.D. Macdonald, J. Nucl. Mater., 2008, vol. 379, pp. 24-32.
Author information
Authors and Affiliations
Corresponding author
Additional information
Manuscript submitted November 20, 2017.
Rights and permissions
About this article
Cite this article
Fattah-Alhosseini, A., Keshavarz, M.K., Molaei, M. et al. Plasma Electrolytic Oxidation (PEO) Process on Commercially Pure Ti Surface: Effects of Electrolyte on the Microstructure and Corrosion Behavior of Coatings. Metall Mater Trans A 49, 4966–4979 (2018). https://doi.org/10.1007/s11661-018-4824-8
Received:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s11661-018-4824-8