Skip to main content
Log in

The impact of bed temperature on heat transfer characteristic between fluidized bed and vertical rifled tubes

  • Published:
Journal of Thermal Science Aims and scope Submit manuscript

Abstract

In the present work, the heat transfer study focuses on assessment of the impact of bed temperature on the local heat transfer characteristic between a fluidized bed and vertical rifled tubes (38mm-O.D.) in a commercial circulating fluidized bed (CFB) boiler. Heat transfer behavior in a 1296t/h supercritical CFB furnace has been analyzed for Geldart B particle with Sauter mean diameter of 0.219 and 0.246mm. The heat transfer experiments were conducted for the active heat transfer surface in the form of membrane tube with a longitudinal fin at the tube crest under the normal operating conditions of CFB boiler. A heat transfer analysis of CFB boiler with detailed consideration of the bed-to-wall heat transfer coefficient and the contribution of heat transfer mechanisms inside furnace chamber were investigated using mechanistic heat transfer model based on cluster renewal approach. The predicted values of heat transfer coefficient are compared with empirical correlation for CFB units in large-scale.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Similar content being viewed by others

References

  1. Directive 2010/75/EU of the European Parliament and the Council on industrial emissions (integrated pollution prevention and control) adopted on 24 November 2010.

  2. Ludowski, P., Taler, D., Taler J., 2013, Identification of thermal boundary conditions in heat exchangers of fluidized bed boilers, Appl. Therm. Eng., 58, pp. 194–204.

    Article  Google Scholar 

  3. Taler, J., Duda, P., Weglowski, B., Zima, W., Gradziel, S., Sobota, T., Taler, D., 2009, Identification of local heat flux to membrane water-walls in steam boilers, Fuel, 88, pp. 305–311.

    Article  Google Scholar 

  4. Taler, J., Taler, D., Ludowski, P., 2014, Measurements of local heat flux to membrane water walls of combustion chambers, Fuel, 115, pp. 70–83.

    Article  Google Scholar 

  5. Zima, W., Gradziel, S., Cebula, A., 2010, Modeling of heat and flow phenomena occurring in water wall tubes of boilers for supercritical steam parameters, Arch. Thermodyn., 31, pp. 19–36.

    ADS  Google Scholar 

  6. Lu, Y., Zhang, T., Dong, X., 2015, Bed to wall heat transfer in supercritical water fluidized bed: Comparision with the gas-solid fluidized bed, Appl. Therm. Eng., 88, pp. 297–305.

    Article  Google Scholar 

  7. Cheng, L., Wang, Q., Shi, Z., Luo, Z., Ni, M., Cen, K., 2007, Heat transfer in a large-scale circulating fluidized bed boiler, Front. Energy Power Eng., 1, pp. 477–482.

    Article  Google Scholar 

  8. Andersson, B., Leckner, B., 1992, Experimental methods of estimating heat transfer in circulating fluidized bed boilers, Int. J. Heat Mass Tran., 35, pp. 3353–3362.

    Article  Google Scholar 

  9. Dutta, A., Basu, P., 2005, An improved cluster-renewal model for the estimation of heat transfer coefficients on the furnace walls of commercial circulating fluidized bed boilers, J. Heat Trans. - T ASME, 126, 1040–1043.

    Article  Google Scholar 

  10. Wedermann, C.C., Werther, J., 1994, Heat transfer in large-scale circulating fluidized bed combustors of different sizes, in: Avidan A. (Ed.), Circulating Fluidized Bed Technology IV, American Institute of Chemical Engineers, New York, pp. 428–435.

    Google Scholar 

  11. Blaszczuk, A., Nowak, W., 2014, Bed-to-wall heat transfer coefficient in a supercritical CFB boiler at different bed particle sizes, Int. J. Heat Mass Tran., 79, pp. 736–749.

    Article  Google Scholar 

  12. Blaszczuk, A., Nowak, W., 2015, Heat transfer behavior inside a furnace chamber of large-scale supercritical CFB reactor, Int. J. Heat Mass Tran., 87, pp. 464–480.

    Article  Google Scholar 

  13. Blaszczuk, A., Nowak, W., Jagodzik, Sz., 2014, Bed-towall heat transfer in a supercritical circulating fluidized bed boiler, Chem. Process Eng., 35, pp. 191–204.

    Article  Google Scholar 

  14. Blaszczuk, A., 2015, Effect of flue gas recirculation on heat transfer in a supercritical circulating fluidized bed combustor, Arch. Therm., 36, pp. 61–83.

    Google Scholar 

  15. Basu, P., Cheng, L., Cen, K. 1996, Heat transfer in a pressurized circulating fluidized bed, Int. J. Heat Mass Trans., 39, pp. 2711–2722.

    Article  Google Scholar 

  16. Basu, P., Fraser, S.A., 1991, Circulating Fluidized Bed Boilers-Design and Operation, Butterworth-Heinemann, Stoneham.

    Google Scholar 

  17. Grace, J.R., 1982, Fluidized bed heat transfer, in: G. Hestroni (Ed.), Handbook of Multiphase Flow, McGraw- Hill, Hemisphere, Washington, DC.

    Google Scholar 

  18. Basu, P., 2006, Combustion and Gasification in Fluidized Beds, CRC Press.

    Book  Google Scholar 

  19. Kunii, D., Levenspiel, O., 1991, Fluidization Engineering, 2nd edition, Butterworth-Heinemann, Stoneham.

    Google Scholar 

  20. Bucak, O., Dogan, O.M., Uysal, B.Z., 1999, Heat transfer in circulating fluidized bed combustor, in: R.B. Reuther (Ed.), Proceedings of 15th International Conference on Fluidized Bed Combustion, ASME, Savannah, Georgia, USA.

    Google Scholar 

  21. Brewster, M.Q., 1986, Effective absorptivity and emissivity of particulate media with application to fluidized bed, Trans. ASME J. Heat Transfer, 108, pp. 710–713.

    Article  Google Scholar 

  22. Blaszczuk, A., Leszczynski, J., Nowak, W., 2013, Simulation model of mass balance in a supercritical circulating fluidized bed combustor, Powder Technol., 246, pp. 317–326.

    Article  Google Scholar 

  23. Blaszczuk, A., Zylka, A., Leszczynski, J., 2015, Simulation of mass balance behavior in a large-scale circulating fluidized bed reactor, Particuology, DOI: 10.1016/j.partic. 2015.04.003 (in press).

    Google Scholar 

  24. Marks, R.J., 2009, Handbook of Fourier Analysis & Its Applications, Oxford University Press, New York.

    MATH  Google Scholar 

  25. Blaszczuk, A., Nowak, Jagodzik, Sz., 2014, The impact of bed particle size in heat transfer to membrane walls of supercritical CFB boiler, Arch. Therm., 35, pp. 207–223.

    Google Scholar 

  26. Andersson, B., Leckner, B., 1992, Experimental methods of estimating heat transfer in circulating fluidized bed boilers, In. J. Heat Mass Tran., 35, pp. 3353–3362.

    Article  Google Scholar 

  27. Divilio, R.J., Boyd, T.J., 1994, Practical implication of the effect of solids suspension density on heat transfer in large-scale CFB boilers, in: Avidan A. (Ed.), Circulating Fluidized Bed Technology IV, American Institute of Chemical Engineers, New York, pp. 334–339.

    Google Scholar 

  28. Reddy, B.V., 2002, Fundamental heat transfer mechanism between bed-to-membrane water-walls in circulating fluidized bed combustors, Int. J. Energy Res., 27, pp. 813–824.

    Article  Google Scholar 

Download references

Author information

Authors and Affiliations

Authors

Additional information

This work was financially supported by scientific research No BS-PB-406/301//11.

Rights and permissions

Reprints and permissions

About this article

Check for updates. Verify currency and authenticity via CrossMark

Cite this article

Blaszczuk, A., Nowak, W. The impact of bed temperature on heat transfer characteristic between fluidized bed and vertical rifled tubes. J. Therm. Sci. 25, 476–483 (2016). https://doi.org/10.1007/s11630-016-0887-2

Download citation

  • Received:

  • Published:

  • Issue Date:

  • DOI: https://doi.org/10.1007/s11630-016-0887-2

Keywords

Navigation