Abstract
Mineral composition and microstructure changes under loading greatly influence the macroscopic mechanical strength of rocks. In this study, the chemical and mineral composition of sandstone from a coal mine in China were analyzed with energy dispersive spectrometry and X-ray diffraction. Triaxial compression tests of three sandstone samples with different compositions were carried out by using a servo-controlled rock mechanics testing system to obtain macroscopic failure characteristics and complete stress–strain curves. Fracture morphologies of the sandstone samples were observed by scanning electron microscopy (SEM), and the fracture origins, defects, grain size, pore structure and distribution, microfracture characteristics and grain boundaries were determined. Finally, the fracture mechanism of the rocks was analyzed, and the microstructure and fracture characteristics of three samples were obtained. The results showed that the stress–strain curve of samples under triaxial compression can be divided into four stages: microfractures compressed-closed, elastic deformation, plastic-failure and post-failure. Under triaxial compression, shear failure occurred in the samples, and the slip occurred along the plane of maximum shear stress. The SEM results showed grooves and steps on the fracture surface, where the debris was piled up in angular and granular shapes. Higher quartz and feldspar content is positively correlated with sample strength. There were some microcracks in the fracture surface of the clastic sandstone with higher hydrophilic clay minerals, which indicates the fracture was easily extended during the shear process. Thus, tensile fractures are more likely to be generated along the bedding plane, resulting in the low strength of clastic sandstone.
Similar content being viewed by others
References
Cao DT (2009) Study on hydrogeological features and evaluation of water inrush danger of sandstone at the top of coal 3 in Yanzhou mining area. Site Investig Sci Technol 1:37–40 (in Chinese)
Fralick PW, Kronberg BI (1997) Geochemical discrimination of elastic sedimentary rock sources. Sedment Geol 113(1–2):111–124
Geiger J, Hunyadfalvi Z, Bogner P (2009) Analysis of small-scale heterogeneity in elastic rocks by using computerized X-ray tomography (CT). Eng Geol 103(3–4):112–118
Kang YM, Jia Y (2015) Analysis on micro-structural characteristics for limestone components and the evaluation of grouting reinforcement properties. Mental Mine 10:146–151 (in Chinese)
Liu TS, Shao AJ (2002) A Study on the rock mechanics and micro-structure features of rock in Feng feng No.5 coal mine. Min Res Dev 22(4):14–17 (in Chinese)
Meng ZP, Peng SP (2004) Mudstone composition of coal measures and its influence on the mechanical properties. Coal Geol Explor 32(2):14–16 (in Chinese)
Wen SY, Guo CY, Zhou DP, Zhou JJ (2013) Study on petrologic characteristics of outburst sandstone in a coal mine in Chongqing. Min Saf Environ Prot 40(5):25–28 (in Chinese)
Yang HL, Shen RC, Fu L (2013) Composition and mechanical properties of gas shale. Pet Drill Tech 41(5):31–35
Zhang H, Kang YL, Chen YJ, You LJ (2004) Influence of the rock components and fractures on tight sandstone stress sensitivity. Nat Gas Ind 24(7):55–58
Zhang YB, Kang ZQ, Li FP (2008) Microcosmic mechanism analysis and experimental study of rock burst fracture based on SEM. In: Proceedings of the international young scholars’ symposium on rock mechanics, pp. 873–876
Acknowledgements
This study was supported by the National Natural Science Foundation Project (No. 51704152) and the Natural Foundation Projects of Shandong Province (No. ZR2017BEE001, No. ZR2017PEE018), China.
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Zhang, G., Zhang, W., Wang, H. et al. Microscopic Failure Mechanism Analysis of Sandstone Under Triaxial Compression. Geotech Geol Eng 37, 683–690 (2019). https://doi.org/10.1007/s10706-018-0638-0
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s10706-018-0638-0