Abstract
The weathering of coal combustion products (CCPs) in a lotic environment was assessed following the Tennessee Valley Authority (Kingston, TN) fly ash release of 2008 into surrounding rivers. Sampled materials included stockpiled ash and sediment collected from 180 to 880 days following the release. Total recoverable concentrations of heavy metals and metalloids in sediment were measured, and percent ash was estimated visually or quantified by particle counts. Arsenic and selenium in sediment were positively correlated with percent ash. For samples collected 180 days after the release, total concentrations of trace elements downstream of the release were greater than reference levels but less than concentrations measured in stockpiled ash. Total concentrations of trace elements remained elevated in ash-laden sediment after almost 2.5 years. A sequential extraction procedure (SEP) was used to speciate selected fractions of arsenic, copper, lead, nickel, and selenium in decreasing order of bioavailability. Concentrations of trace elements in sequentially extracted fractions were one to two orders of magnitude lower than total recoverable trace elements. The bulk of sequentially extractable trace elements was associated with iron-manganese oxides, the least bioavailable fraction of those measured. By 780 days, trace element concentrations in the SEP fractions approached reference concentrations in the more bioavailable water soluble, ion exchangeable, and carbonate-bound fractions. For each trace element, the percentage composition of the bioavailable fractions relative to the total concentration was calculated. These SEP indices were summed and shown to significantly decrease over time. These results document the natural attenuation of leachable trace elements in CCPs in river sediment as a result of the loss of bioavailable trace elements over time.
This is a preview of subscription content, log in via an institution to check access.
Similar content being viewed by others
References
Babyak, C. M., Tuberty, S. R., Carter, B. D., Gibbs, A., Routhier, D., Woodruff, C., et al. (2010). Sequential extraction of river sediments impacted by a recent coal fly ash slide. Spectros Letters, 43, 567–579.
Bodog, I., Polyak, K., Csikos-Hartyanyi, Z., & Hlavay, J. (1996). Sequential extraction procedure for the speciation of elements in fly ash samples. Microchemical Journal, 54, 320–330.
Burton, G. A. (2013). Assessing sediment toxicity: past, present and future. Environmental Toxicology and Chemistry, 32, 1438–1440.
Canuto, F. A. B., Garcia, C. A. B., Alves, J. P. H., & Passos, E. A. (2013). Mobility and ecological risk assessment of trace metals in polluted estuarine sediments using a sequential extraction scheme. Environmental Monitoring and Assessment, 185, 6173–6185.
Couture, R. M., Rose, J., Kumar, N., Mitchell, K., Wallschlager, D., & Cappellen, P. V. (2013). Sorption of arsenite, arsenate and thioarsenates to iron oxides and iron sulfides: a kinetic and spectroscopic investigation. Environmental Science and Technology, 47, 5652–5659.
Environmental Protection Agency (EPA). (2010). US EPA Contract Laboratory Program, National Functional Guidelines for Inorganic Superfund Data Review, OSWER 9240.1-51, Office of Superfund Remediation and Technology Innovation. See http://www.epa.gov/superfund/programs/clp/guidance.htm.
Filgueiras, A. V., Lavilla, I., & Bendicho, C. (2002). Chemical sequential extraction for metal partitioning in environmental solid samples. Journal of Environmental Monitoring, 4, 823–857.
Kennedy, V. H., Sancheza, A. L., Oughtonb, D. H., & Rowlanda, A. P. (1997). Critical review: use of single and sequential chemical extractants to assess radionuclide and heavy metal availability from soils for root uptake. Analyst, 122, 89–100.
Landsberger, S., Cerbus, J. F., & Larson, S. (1995). Elemental characterization of coal ash and its leachates using sequential extraction. Journal of Radioanalytical and Nuclear Chemistry, 192, 265–274.
Larios, R., Fernandez-Martinez, R., & Rucandio, I. (2012). Comparison of three sequential extraction procedures for fractionation of arsenic from highly polluted mining sediments. Analytical Bioanalylitical Chemistry, 402, 2909–2921.
Lihareva, N. L. (2003). Study of metals fractionation in ash samples using a sequential extraction procedure. Bulgarian Chemical Communication, 35, 110–114.
Lovley, D. R. (1991). Dissimilatory Fe(III) and Mn(IV) reduction. Microbiological Reviews, 5, 259–287.
Pierre Stecko, J. R., & Bendell-Young, L. I. (2000). Contrasting the geochemistry of suspended particulate matter and deposited sediments within an estuary. Applied Geochemistry, 15, 753–775.
Querol, X., Juan, R., Lopez-Soler, A., Fernandez-Turiel, J. L., & Ruiz, C. R. (1996). Mobility of trace elements from coal and combustion wastes. Fuel, 75, 821–838.
Rapin, F., Tessier, A., Campbell, P. G. C., & Carignan, R. (1986). Potential artifacts in the determination of metal partitioning in sediments by a sequential extraction procedure. Environmental Science and Technology, 20, 836–840.
Ruhl, L., Vengosh, A., Dwyer, G. S., Hsu-Kim, H., & Deonarine, A. (2010). Environmental impacts of the coal ash spill in Kingston, Tennessee: an 18-month survey. Environmental Science and Technology, 44, 9272–9278.
Seramur, K. C., Cowan, E. A., Babyak, C. M. (2011). Sedimentary, chemical and geophysical characteristics of ash deposits and their distribution since the 2008 spill. Appalachian State University, Report to N.E. Carriker, Tennessee Valley Authority.
Smeda, A., & Zyrnicki, W. (2002). Application of sequential extraction and the ICP-AES method for study of the partitioning of metals in fly ashes. Microchemical Journal, 72, 9–16.
Tessier, A., Campbell, P. G. C., & Bisson, M. (1979). Sequential extraction procedure for the speciation of particulate trace metals. Analytical Chemistry, 51, 844–851.
Ure, A. M., Quevauviller, P., Muntau, H., & Griepinck. (1993). Speciation of heavy metals in soils and sediments. An account of the improvement and harmonization of extraction techniques undertaken under the auspices of the BCR of the Commission of the European Communities. International Journal of Environmental and Analytical Chemistry, 51, 135–151.
Wadge, A., & Hutton, M. (1987). The leachability and chemical speciation of selected trace elements in fly ash from coal combustion and refuse incineration. Environmental Pollution, 48, 85–99.
Zevenbergen, C., Bradley, J. P., van Reeuwijk, L. P., Shyam, A. K., Hjelmar, O. L. E., & Comans, R. N. J. (1999). Clay formation and metal fixation during weathering of coal fly ash. Environmental Science and Technology, 33, 3405–3409.
Zimmerman, A. J., & Weindorf, D. C. (2010). Heavy metal and trace metal analysis in soil by sequential extraction: a review of procedures. International Journal of Analytical Chemistry, 7, 1–7.
Acknowledgement
Funding for this study was provided by the Tennessee Valley Authority (Environmental Standards, Inc., Contract 472411). We would like to thank Environmental Standards’ staff Abby Koss, Megan Filipovits, Sarah Snyder, Jaclyn Ellerie, and Jeff Paar for assistance.
Conflict of interest
The authors have no conflict of interest to declare.
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Markwiese, J.T., Rogers, W.J., Carriker, N.E. et al. Natural attenuation of coal combustion waste in river sediments. Environ Monit Assess 186, 5235–5246 (2014). https://doi.org/10.1007/s10661-014-3772-z
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s10661-014-3772-z