Abstract
We selected the shaly sandstone at the rock slope of the Three Gorges Reservoir area in China where water level varies (the water level-fluctuating zone) in order to study the effect of dry–wet cycles on strength deterioration and micro-structure changes of shaly sandstone. After n dry–wet cycles (n being the number of cycles, with a value of 0, 1, 5, 10, 15, and 20), the shaly sandstone samples were exposed to a uniaxial compression test, triaxial compression test, and Scanning Electron Microscope observation. The strength deterioration and micro-structural changes of the samples are then analyzed with PFC2D (particle flow code in 2D). We found that as n increases, the micro-structure of the shaly sandstone changes from a well-organized dense structure stage to a porous stage and then to a cracking stage, the particles within the shaly sandstone bear and transfer a larger load, strength deterioration is more obvious, and particles are more prone to yield failure. The dry–wet cycles lower the micro-structure strength of the particles contact network, at the macro level, which is reflected in the strength decrease of shaly sandstone. At peak stress state, the shaly sandstone mainly shows the characteristics of shear failure after dry–wet cycles. With the loading process and n increasing, the cracks propagation process of the shaly sandstone samples can be divided into four stages: the elastic deformation stage, cracks generation and stable cracks growth stage, cracks damage and unstable cracks growth stage, and post-peak failure stage.
Similar content being viewed by others
References
Baud P, Zhu W, Wong TF (2000) Failure mode and weakening effect of water on sandstone. J Geophys Res 105:16371–16389
Chester FM, Logan JM (1986) Implications for mechanical properties of brittle faults from observations of the punchbowl fault zone, California. Pure Appl Geophys 124:79–126
Hua W, Dong SM, Li YF, Xu JG, Wang QY (2015) The influence of cyclic wetting and drying on the fracture toughness of sandstone. Int J Rock Mech Min Sci 78:331–335
Duda M, Renner J (2000) The weakening effect of water on the brittle failure strength of sandstone. Geophys J Int 192:1091–1108
Hall K, Hall A (1996) Weathering by wetting and drying: some experimental results. Earth Surf Process Landf 21:365–376
Hale PA, Shakoor A (2003) A laboratory investigation of the effects of cyclic heating and cooling, wetting and drying, and freezing and thawing on the compressive strength of selected sandstones. Environ Eng Geosci 9:117–130
Itasca Consulting Group Inc (2004). PFC2D (particle flow code in 2D) theory and background. Minnesota: Itasca Consulting
Jeoungseok Y (2007) Application of experimental design and optimization to PFC model calibration in uniaxial compression simulation. Int J Rock Mech Min Sci 44:871–889
Jiang QH, Qi YJ, Wang ZJ, Zhou CB (2013) An extended Nishihara model for the description of three stages of sandstone creep. Geophys J Int 193:841–854
Jiang QH, Zhang ZH, Wei W, Ni X, Zhou CB (2012) Research on triggering mechanism and kinematic process of Qianjiangping landslide. Disaster Adv 5:598–603
Klein E, Baud P, Reuschle T, Wong TF (2001) Mechanical behavior and failure mode of Bentheim sandstone under triaxial compression. Phys Chem Earth 26:21–25
Li KG, Zheng DP, Huang WH (2013a) Experiment research on shear characteristics of sandstone considering cyclic drying-wetting effect. Disaster Adv s1:83–87
Li KG, Zheng DP, Huang WH (2013b) Mechanical behavior of sandstone and its neural network simulation of constitutive model considering cyclic drying-wetting effect. Rock Soil Mech 34:168–173 in Chinese
Miihlhaus HB, Vardoulakis I (1988) The thickness of shear bands in granular materials. Geotechnique 38:271–284
Ozbek A (2014) Investigation of the effects of wetting-drying and freezing-thawing cycles on some physical and mechanical properties of selected ignimbrites. Bull Eng Geol Environ 73:595–609
Potyondy DO, Cundall PA (2004) A bonded-particle model for rock. Int J Rock Mech Min Sci 41:1329–1364
Rong HR, Bai HB, Wang ZS (2005) Experimental research on mechanical properties and microstructure change law of red sandstone after different temperatures. Rock Soil Mech 36:463–469 in Chinese
Torres-Suareza MC, Alarcon-Guzman A, Moya RD (2014) Effects of loading-unloading and wetting-drying cycles on geomechanical behaviors of mudrocks in the Colombian Andes. J Rock Mech Geotech Eng 6:257–268
Wong TF, Baud P (2012) The brittle-ductile transition in rocks: a review. J Struct Geol 44:25–53
Yang SQ, Jing HW, Wang SY (2012) Experimental investigation on the strength, deformability, failure behavior and acoustic emission locations of red sandstone under triaxial compression. Rock Mech Rock Eng 45:583–606
Yao HY, Zhang ZH, Zhu CH, Shi YC, Li Y (2010) Experimental study of mechanical properties of sandstone under cyclic drying and wetting. Rock Soil Mech 31:3704–3708
Yao HY, Zhu Y, Wu P (2013) Research on uniaxial compression and tension tests of sandstone subjected to drying-wetting cycle. Disaster Adv 6(S3):388–392
Zhang ZH, Jiang QH, Zhou CB, Liu XT (2014) Strength and failure characteristics of Jurassic red-bed sandstone under cyclic wetting-drying conditions. Geophys J Int 198:1034–1044
Zha ZH, Song EX (2015) Particle mechanics modeling of creep behavior of rockfill materials under dry and wet conditions. Comput Geotech 68:137–146
Acknowledgments
This study is supported by the National Natural Science Foundation of China (Project no. 41372356); the authors gratefully acknowledge this support.
Author information
Authors and Affiliations
Corresponding author
Ethics declarations
Conflicts of interest
The authors declare no conflicts of interest.
Rights and permissions
About this article
Cite this article
Liu, X., Jin, M., Li, D. et al. Strength deterioration of a Shaly sandstone under dry–wet cycles: a case study from the Three Gorges Reservoir in China. Bull Eng Geol Environ 77, 1607–1621 (2018). https://doi.org/10.1007/s10064-017-1107-3
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s10064-017-1107-3