Abstract
Currently, control systems are used to improve the behavior of actuators that are part of an equipment or process. However, to enhance their performance, it is necessary to perform tests to evaluate the responses of its operation depending on the type of controller. In this sense, a test platform was developed to compare and optimize the speed control of a DC motor with three types of controllers: Predictive Model Control (MPC), Proportional Integral Derivative (PID) and Fuzzy Logic. Data acquisition was performed using the Arduino MEGA board and LabVIEW software. The mathematical model of the three controllers was developed, taking into account the electrical and physical properties of the DC motor. Through MATLAB IDENT, the state space (SS) and transfer function F(S) equations were generated for the MPC and PID controller, respectively; on the other hand, input/output ranges for the Fuzzy Logic controller were input/output ranges defined by assigning belonging functions and linguistic variables. Experimental tests were carried out with these models under no-load and load. Tests performed in vacuum show that performance index with the motor at 100 rpm results in a PID of 0.2245, a Fuzzy Logic of 0.3212 and an MPC of 0.3576. On the other hand, with load at 100 rpm, a PID of 0.2343, a Fuzzy Logic of 0.3871 and an MPC of 0.3104 were obtained. It was determined that the Fuzzy Logic controller presents a higher over impulse; the PID and MPC have a faster stabilization time and with negligible over impulses. Finally, the MPC controller presents a better performance index analysis according to the Integral Square Error criterion (ISE).
This is a preview of subscription content, log in via an institution to check access.
Access this chapter
Tax calculation will be finalised at checkout
Purchases are for personal use only
Similar content being viewed by others
References
Fang, G., Pinarello Scalcon, F., Xiao, D., Vieira, R., Grundling, H., Emadi, A.: Advanced Control of Switched Reluctance Motors (SRMs): a review on current regulation, torque control and vibration suppression. IEEE Open J. Ind. Electron. Soc. 2, 280–301 (2021). https://doi.org/10.1109/OJIES.2021.3076807
Dantas, A.D.O.D.S., Dantas, A.F.O.D.A., Campos, J.T.L.S., De Almeida Neto, D.L., Dórea, C.E.T.: PID control for electric vehicles subject to control and speed signal constraints. J. Control Sci. Eng. 2018 (2018). https://doi.org/10.1155/2018/6259049
Guzey, H.M., Dumlu, A., Guzey, N., Alpay, A.: Optimal synchronizing speed control of multiple DC motors. In: Proceedings of the 2018 International Conference on Optimization Application. ICOA 2018, vol. 0, no. 2, pp. 1–5 (2018). https://doi.org/10.1109/ICOA.2018.8370508
Buele, J., Varela-Aldás, J., Santamaría, M., Soria, A., Espinoza, J.: Comparison between fuzzy control and MPC algorithms implemented in low-cost embedded devices. In: Rocha, Á., Ferrás, C., Montenegro Marin, C.E., Medina García, V.H. (eds.) ICITS 2020. AISC, vol. 1137, pp. 429–438. Springer, Cham (2020). https://doi.org/10.1007/978-3-030-40690-5_42
Welsch, M., Fichter, W.: Control of large multicopters with rate-limited electric motors. In: AIAA Scitech 2020 Forum, vol. 1 PartF, no. January, pp. 1–12 (2020). https://doi.org/10.2514/6.2020-1832
Aguila Mejía, O., Tapia Olvera, R., Rivas Cambero, I., Minor Popocatl, H.: Adaptative speed controller for a permanent magnet synchronous motor, pp. 142–170 (2019)
Qu, L., Qiao, W., Qu, L.: An enhanced linear active disturbance rejection rotor position sensorless control for permanent magnet synchronous motors. IEEE Trans. Power Electron. 35(6), 6175–6184 (2020). https://doi.org/10.1109/TPEL.2019.2953162
Kryukov, O.V., Blagodarov, D.A., Dulnev, N.N., Safonov, Y.M., Fedortsov, N.N., Kostin, A.A.: Intelligent control of electric machine drive systems. In: 2018 10th International Conference on Electrical Power Drive System ICEPDS 2018 – Conference on Proceedings, pp. 1–4 (2018). https://doi.org/10.1109/ICEPDS.2018.8571670
Djuric, A., Jovanovic, V.M., Yaprak, E., Chen, W.: Learning module on electric motors modeling, control, and testing (LMEMMCT). In: ASEE Annual Conference Export Conference on Proceedings, vol. 2017-June (2017). https://doi.org/10.18260/1-2--28613
Saad, M., Amhedb, A.H., Al Sharqawi, M.: Real time DC motor position control using PID controller in LabVIEW. J. Robot. Control 2(5), 342–348 (2021). https://doi.org/10.18196/jrc.25104
Alkurawy, L.E.J., Khamas, N.: Model predictive control for DC motors. In: 1st International Science Conference on Engineering Science - 3rd Science Conference on Engineering Science ISCES 2018 - Proceedings, vol. 2018-Janua, pp. 56–61 (2018). https://doi.org/10.1109/ISCES.2018.8340528
Saá, F., Gordón, A., Mendoza Chipantasi, D., Espejo Velasco, P., Velasco, E.N.: Test system for control algorithms on a DC motor. In: Botto-Tobar, M., León-Acurio, J., Díaz Cadena, A., Montiel Díaz, P. (eds.) ICAETT 2019. AISC, vol. 1067, pp. 154–163. Springer, Cham (2020). https://doi.org/10.1007/978-3-030-32033-1_15
Lotfy, A., Kaveh, M., Mosavi, M.R., Rahmati, A.R.: An enhanced fuzzy controller based on improved genetic algorithm for speed control of DC motors. Analog Integr. Circ. Sig. Process 105(2), 141–155 (2020). https://doi.org/10.1007/s10470-020-01599-9
Author information
Authors and Affiliations
Corresponding author
Editor information
Editors and Affiliations
Rights and permissions
Copyright information
© 2022 The Author(s), under exclusive license to Springer Nature Switzerland AG
About this paper
Cite this paper
Saá-Tapia, F., Mayorga-Miranda, L., Ayala-Chauvin, M., Domènech-Mestres, C. (2022). Control System Test Platform for a DC Motor. In: Stephanidis, C., Antona, M., Ntoa, S., Salvendy, G. (eds) HCI International 2022 – Late Breaking Posters. HCII 2022. Communications in Computer and Information Science, vol 1654. Springer, Cham. https://doi.org/10.1007/978-3-031-19679-9_86
Download citation
DOI: https://doi.org/10.1007/978-3-031-19679-9_86
Published:
Publisher Name: Springer, Cham
Print ISBN: 978-3-031-19678-2
Online ISBN: 978-3-031-19679-9
eBook Packages: Computer ScienceComputer Science (R0)