Volume 3, Issue 4 | Advances in Manufacturing

Search all Advances in Manufacturing articles

Volume 3, Issue 4

December 2015

Special Issue: Production Methods for Difficult-to-Manufacture Materials

Issue Editor:

Erhan Budak

Filter by

Volume:

Sort by

Date published:

New to old Old to new

8 articles in this issue

Single point and asymmetric incremental forming
J. Jeswiet
D. Adams
P. Gupta
OriginalPaper 26 November 2015 Pages: 253 - 262
Micro ball-end milling of freeform titanium parts
Ali Mamedov
Ismail Lazoglu
OriginalPaper 20 October 2015 Pages: 263 - 268
Dual phase titanium alloy hot forging process design: experiments and numerical modeling
A. Ducato
G. Buffa
R. Shivpuri
OriginalPaper 28 November 2015 Pages: 269 - 281
An experimental study on grinding of Zr-based bulk metallic glass
Mustafa Bakkal
Erdinç Serbest
Bora Derin
OriginalPaper 05 October 2015 Pages: 282 - 291
Experimental investigation of tool wear and chip formation in cryogenic machining of titanium alloys
D. Biermann
H. Abrahams
M. Metzger
OriginalPaper 03 November 2015 Pages: 292 - 299
Tool geometry based prediction of critical thrust force while drilling carbon fiber reinforced polymers
Y. Karpat
O. Bahtiyar
OriginalPaper 08 December 2015 Pages: 300 - 308
Finite element analysis of chip formation and residual stresses induced by sequential cutting in side milling with microns to sub-micron uncut chip thickness and finite cutting edge radius
Nejah Tounsi
Tahany El-Wardany
OriginalPaper 07 December 2015 Pages: 309 - 322
Analysis of hard turning process: thermal aspects
Varaprasad Bhemuni
Srinivasa Rao Chalamalasetti
Venkata Vinay Pragada
OriginalPaper 13 November 2015 Pages: 323 - 330