Abstract
This paper provides the results of tests of various grades of nanomodified cements (nanocements) and relevant reinforced concrete products. The following main quality indicators for nanocements were chosen: standard consistency and setting time of cement paste, flexural strength and compressive strength for various periods of time. The key indicator for tests of the reinforced concrete products is compressive resistance of concrete for different periods of time. Based on the results of laboratory tests, the construction and technical properties of Portland cement and nanomodified cement were compared. The comparison of strength characteristics of reinforced concrete products based on nanocement with the minimal design requirements is presented. The conducted analysis and the comparison of laboratory test results revealed that the use of nanocement in reinforced concrete products has significant benefits over Portland cement. The storage time for nanocement is also considerably higher, as the loss of nanocement activity during the long-term storage is many times lower than in case of Portland cement.
This is a preview of subscription content, log in via an institution to check access.
Access this chapter
Tax calculation will be finalised at checkout
Purchases are for personal use only
References
Barabanshchikov, Y.G., Komarinskiy, M.V.: Influence of superplasticizer S-3 on the technological properties of concrete mixtures. Adv. Mater. Res. 941–944, 780–785 (2014)
Barabanshchikov, YuG., Arkharova, A.A., Ternovskii, M.V.: On the influence on the efficiency of anti-shrinkage additives superplasticizer. Mag. Civ. Eng. 7(51), 23–30 (2014)
Barabanshchikov, YuG., Belyaeva, S.V., Arkhipov, I.E., Antonova, M.V., Shkol’nikova, A.A., Lebedeva, K.S.: Influence of superplasticizers on the concrete mix properties. Mag. Civ. Eng. 6(74), 140–146 (2017)
Usanova, K.: Properties of cold-bonded fly ash lightweight aggregate concretes. In: Anatolijs, B., Nikolai, V., Vitalii, S. (eds.) Proceedings of EECE 2019. Lecture Notes in Civil Engineering, vol. 70, pp. 507–516. Springer, Cham (2020). https://doi.org/10.1007/978-3-030-42351-3_44
Usanova, K., Barabanshchikov, YuG: Cold-bonded fly ash aggregate concrete. Mag. Civ. Eng. 3(95), 104–118 (2020)
Balaguru, P., Chong, K.: Nanotechnology and concrete: research opportunities. In: American Concrete Institute. ACI Special Publication, Issue 254 SP, pp. 15–28 (2008)
Dunuweera, S.P., Rajapakse, R.M.G.: Cement types, composition, uses and advantages of nanocement, environmental impact on cement production, and possible solutions. Adv. Mater. Sci. Eng. 2018, 4158682 (2018)
Frolov, A., Chumadova, L., Cherkashin, A., Akimov, L.: Prospects of use and impact of nanoparticles on the properties of high-strength concrete. Appl. Mech. Mater. 584–586, 1416–1424 (2014)
Frolov, A.V., Chumadova, L.I., Cherkashin, A.V., Akimov, L.I.: The economy of use and the impact of nanoparticles on properties of lightweight high-strength concrete. Constr. Unique Build. Struct. 4(19), 51–61 (2014). (In Russian)
Akimov, L., Ilenko, N., Mizharev, R., Cherkashin, A., Vatin, N., Chumadova, L.: Composite concrete modifier CM 02–10 and its impact on the strength characteristics of concrete. In: MATEC Web of Conferences, vol. 53, art. no. 01022 (2016)
Nizina, T.A., Ponomarev, A.N., Balykov, A.S., Pankin, N.A.: Fine-grained fibre concretes modified by complexed nanoadditives. Int. J. Nanotechnol. 7/8(14), 665–679 (2017)
Frolov, A.V., et al.: Acceleration of the formation process of the structure of cement stone with the use of carbon nanomodified additives. Constr. Unique Build. Struct. 7(34), 32–40 (2015). (rus)
Kiski, S.S., Ponomarev, A.N., Ageev, I.V., Cun, C.: Modification of the fine – aggregate concrete by high disperse silica fume and carbon nanoparticles containing modifiers. Adv. Mater. Res. 941–944, 430–435 (2014)
Pukharenko, YuV., Letenko, D.G., Nikitin, V.A., Morozov, V.I.: Obtaining the nanomodifier for cement composites based on the “DEALTOM” carbon nanotubes. Mater. Phys. Mech. 1–2(31), 59–62 (2017)
Gonzalez, M., Tighe, S.L., Hui, K., Rahman, S., De Oliveira Lima, A.: Evaluation of freeze/thaw and scaling response of nanoconcrete for Portland Cement Concrete (PCC) pavements. Constr. Build. Mater. 120, 465–472 (2016)
Gonzalez, M., De Oliveira Lima, A., Tighe, S.L.: Nanoconcrete for rigid pavements: abrasion response and impact on friction. Transp. Res. Rec. J. Transp. Res. Board 2441, 28–37 (2014)
Li, H., Xiao, H.G., Yuan, J., Ou, J.: Microstructure of cement mortar with nano-particles. Compos. Part B: Eng. 2(35), 185–189 (2004)
Sabdonoa, P., Sustiawana, F., Fadlillaha, D.A.: The effect of nano-cement content to the compressive strength of mortar. Proc. Eng. 95, 386–395 (2014)
Al-Rifaie, W.N., Ahmed, W.K., Mahdi, O.M.: Mechanical properties of nano-cement mortar: Compression and tension. In: IEOM 2015 – 5th International Conference on Industrial Engineering and Operations Management, Proceeding, art. no. 7093795 (2015)
Jemimah Carmichae, M., Prince Arulraj, G.: Strength and permeability studies on concrete with nano-cement. Int. J. Civ. Eng. Technol. 1(8), 132–139 (2017)
Bikbau, M.J.: Patent: Production of nanocement and nanocement, patent no. RU 2544355 C2, Russia (2015). (In Russian)
Bikbau, M.Y., Vysotskiy, D.V.: Concretes with the use of nano cements: properties and prospects. Concrete Technologies 11–12(64–65), 31–35 (2011). (In Russian)
Bickbau, M.J.: Nano-cements – future of world cement industry and concrete technology. Bull. RANS 5(15), 32–41 (2015). (In Russian)
Bikbau, M.Y.: Nanocement morphological peculiarities, structure properties and concrete on their base. Concr. Technol. 4(93), 38–44 (2014). (In Russian)
Bikbau, M.Y.: Properties and structure of nano-cement concretes. In: Proceeding of 2nd International Conference of Concrete and Reinforced Concrete “Concrete and Reinforced Concrete – Look into the Future”, pp. 158–171 (2014). (In Russian)
Author information
Authors and Affiliations
Editor information
Editors and Affiliations
Rights and permissions
Copyright information
© 2021 The Author(s), under exclusive license to Springer Nature Switzerland AG
About this paper
Cite this paper
Jos, V., Rybakov, V., Sviridenko, V., Brailova, T. (2021). Quality Indicators of Nanomodified Cements and Relevant Products. In: Vatin, N., Borodinecs, A., Teltayev, B. (eds) Proceedings of EECE 2020. EECE 2020. Lecture Notes in Civil Engineering, vol 150. Springer, Cham. https://doi.org/10.1007/978-3-030-72404-7_4
Download citation
DOI: https://doi.org/10.1007/978-3-030-72404-7_4
Published:
Publisher Name: Springer, Cham
Print ISBN: 978-3-030-72403-0
Online ISBN: 978-3-030-72404-7
eBook Packages: EngineeringEngineering (R0)