Abstract
A mechanism of non-stoichiometric laser ablation is proposed and experimentally verified for multicomponent alloys. The analysis of four-component bronze samples in various excitation modes and the recorded laser plasma spectra revealed that disproportion of plasma elements during laser evaporation arises from selective evaporation of components at the heating-melting-evaporation stage. Correction coefficients proportional to the work function of the alloy component vapor in the heating-melting-evaporation cycle are calculated for the plasma spectrum. Correction procedure for the spectral lines leads to a good agreement of the measured sample composition with the tabulated data. To check that the proposed approach is universal, aluminum alloys and iron alloys (high-alloy stainless steels) are analyzed. It is found that selective evaporation for aluminum alloys is lower than for bronzes. Evaporation selectivity was insignificant for stainless steels. The proposed mechanism for selective evaporation during laser ablation and correction of the plasma spectrum make it unnecessary to use a standard in the quantitative elemental analysis of complex bronze and aluminum alloy samples.
Similar content being viewed by others
References
D. A. Cremers and L. J. Radziemski, Handbook of Laser Induced Spectroscopy (Wiley, N.Y., 2006), 300 p.
Pulsed Laser Deposition of Thin Films, Ed. by D. B. Chrisey, G. K. Hubler (Wiley, N.Y., 1994), 650 p.
A. M. Prokhorov, V. I. Konov, I. Ursu, and I.N. Mihailescu, Laser Heating of Metals (Adam Hilger, Bristol, U.K., 1990)].
E. Goulielmakis, M. Schultze, M. Hofstetter, V. S. Yakovlev, J. Gagnon, M. Uiberacker, A. L. Aquila, E.M. Gullikson, D. T. Attwood, R. Kienberger, F. Krausz, and U. Kleineberg, “Single-Cycle Nonlinear Optics,” Science. 320, 1614 (2008).
Yu. Ya. Kuzyakov, V. N. Lednev, N.V. Alov, I. O. Volkov, N. B. Zorov, and R. D. Voronina, “Carbon Nitride Film Synthesis by Double Pulse Laser Deposition,” VestnikMGU. Khimiya. 48, 134 (2007).
C. Nouvellon, C. Chaleard, J. L. Lacour, and P. Mauchien, “Stoichiometry Study of Laser Produced Plasma by Optical Emission Spectroscopy,” Appl. Surf. Sci. 138–139, 306 (1999).
F. Colao, R. Fantoni, V. Lazic, L. Caneve, A. Giardini, V. Spizzichino, “LIBS as a Diagnostic Tool During the Laser Cleaning of Copper Based Alloys: Experimental Results,” J. Anal. At. Spectrom. 19, 502 (2004).
A. Ciussi, M. Corsi, V. Palleschi, S. Rastelli, A. Salvetti, and E. Tognoni, “New Procedure for Quantitative Elemental Analysis by Laser-Induced Plasma Spectroscopy,” Appl. Spectrosc. 53(8), 960 (1999).
E. Tognoni, G. Cristoforetti, S. Legnaioli, and V. Palleschi, “Calibration-Free Laser-Induced Breakdown Spectroscopy: State of the Art,” Spectrochim. Acta B. 64(1), 1 (2010).
A. Ciucci, V. Palleschi, S. Rastelli, A. Salvetti, D.P. Singh, and E. Tognoni, “CF-LIBS: A New Approachto LIPS Spectra Analysis,” Laser Part. Beams. 17, 793 (1999).
A. M. El Sherbini, Th.M. El Sherbini, H. Hegazy, G. Cristoforetti, S. Legnaioli, V. Palleschi, L. Pardini, A. Salvetti, and E. Tognoni, “Evaluation of Self-Absorption Coefficients of Aluminum Emission Lines in Laser-Induced Breakdown Spectroscopy Measurements,” Spectrochim. Acta B. 60(12), 1573 (2005).
D. Hahn and N. Omenetto, “Laser Induced Breakdown Spectroscopy (LIBS), Part I: Review of Basic Diagnostics and Plasma-Particle Interactions: Still-Challenging Issues within the Analytical Plasma Community,” Appl. Spectrosc. 64, 335A (2010).
L. Dudragne, Ph. Adam, and J. Amouroux, “Time-Resolved Laser-Induced Breakdown Spectroscopy: Application for Qualitative and Quantitative Detection of Fluorine, Chlorine, Sulfur, and Carbon in Air,” Appl. Spectrosc. 52(10), 1321 (1998).
D. Bulajic, M. Corsi, G. Cristoforetti, S. Legnaioli, V. Palleschi, A. Salvetti, and E. Tognoni, “A Procedure for Correcting Self-Absorption in Calibration Free-Laser Induced Breakdown Spectroscopy,” Spectrochim. Acta B. 57, 339 (2002).
M. Corsi, G. Cristoforetti, M. Hidalgo, S. Legnaioli, V. Palleschi, A. Salvetti, E. Tognoni, and C. Vallebon, “Double Pulse Calibration-Free Laser-Induced Breakdown Spectroscopy: A New Technique for in Situ Standard-Less Analysis of Polluted Soils,” Appl. Geochem. 21, 748 (2006).
L. Fornarini, F. Colao, R. Fantoni, V. Lazic, and V. Spizzicchino, “Calibration Analysis of Bronze Samples by Nanosecond Laser Induced Breakdown Spectroscopy: A Theoretical and Experimental Approach,” Spectrochim. Acta B. 60, 1186 (2005).
W. T. Chan and R.E. Russo, “Optical Emission Spectroscopy Studies of the Influence of Laser Ablated Mass on Dry Inductively Coupled Plasma Conditions,” Spectrochim. Acta B. 46, 1471 (1991).
O.V. Borisov, X. L. Mao, and R.E. Russo, “Effects of Crater Development on Fractionation and Signal Intensity During Laser Ablation Inductively Coupled Plasma Mass Spectrometry,” Spectrochim. Acta B. 55, 1693 (2000).
A. M. Popov, T. A. Labutin, and N.B. Zorov, “Application of Laser-Induced Breakdown Spectrometry for Analysis of Environmental and Industrial Materials,” Moscow Univ. Chem. Bull. 50, 453 (2009).
X. Mao, W. T. Chan, and R. E. Russo, “Influence of Sample Surface Condition on Chemical Analysis Using Laser Ablation Inductively Coupled Plasma Atomic Emission Spectroscopy,” Appl. Spectrosc. 51, 1047 (1997).
R. E. Russo, X. L. Mao, W. T. Chan, M. F. Bryant, and W. F. Kinard, “Laser Ablation Sampling with Inductively Coupled Plasma Atomic Emission Spectrometry for the Analysis of Prototypical Glasses,” J. Anal. At. Spectrom. 10, 295 (1995).
M. Guillong and D. Gunther, “Effect of Particle Size Distribution on ICP-Induced Elemental Fractionation in Laser Ablation-Inductively Coupled Plasma-Mass Spectrometry,” J. Anal. At. Spectrom. 17, 831 (2002).
D. Figg and M. S. Kahr, “Elemental Fractionation of Glass Using Laser Ablation Inductively Coupled Plasma Mass Spectrometry,” Appl. Spectrosc. 51, 1185 (1997).
J. M. Baldwin, “Q-Switched Laser Sampling of Copper-Zinc Alloys,” Appl. Spectrosc. 24, 429 (1970).
R. E. Russo, X. L. Mao, C. Liu, and J. Gonzalez, “Laser Assisted Plasma Spectrochemistry: Laser Ablation,” J. Anal. At. Spectrom. 19, 1084 (2004).
C. Liu, X. L. Mao, S. S. Mao, X. Zeng, R. Greif, and R. E. Russo, “Nanosecond and Femtosecond Laser Ablation of Brass: Particulate and ICPMS Measurements,” Anal. Chem. 76, 379 (2004).
R. E. Russo, X. Mao, J. J. Gonzalez, and S. S. Mao, “Femtosecond Laser Ablation ICP-MS,” J. Anal. At. Spectrom. 17, 1072 (2002).
S. M. Pershin and F. Colao, “Laser Plasma Emission Spectrum Corrected for the Quantitative Analysis of Alloys,” Tech. Phys. Lett. 31(9), 741 (2005).
V. N. Lednev and S.M. Pershin, “Plasma Stoichiometry Correction Method in Laser-Induced Breakdown Spectroscopy,” Laser Phys. 18, 1 (2008).
S. M. Pershin, F. Colao, and V. Spizzichino, “Quantitative Analysis of Bronze Samples by Laser-Induced Breakdown Spectroscopy (LIBS): A New Approach, Model, and Experiment,” Laser Phys. 16(3), 455 (2006).
C. Geertsen, A. Briand, F. Chartier, J.-L. Lacour, P. Mauchien, S. Sjostrom, and J.-M. Mermet, “Comparison between Infrared and Ultraviolet Laser Ablation at Atmospheric Pressure-Implications for Solid Sampling Inductively Coupled Plasma Spectrometry,” J. Anal. At. Spectrom. 9, 17 (1994).
Ya.B. Zeldovich and L.D. Landau, “On Relationship between the Liquid and Gaseous States in Metals,” Zh. Eksp. Teor. Fiz. 14, 32 (1944).
X. Xu and K. Song, “Interface Kinetics During Pulsed Laser Ablation,” Appl. Phys. A. 69, S869 (1999).
I. K. Kikoin and A.P. Senchenkov, “Electrical Conduction and the Equation of State of Mercury in the Temperature Range 0–2000 and Pressure Region 200–5000 Atmospheres,” Fiz. Met. Metalloved. 24, 843 (1967).
A. M. Prokhorov, V.A. Batanov, F.V. Bunkin, and V. B. Fedorov, “Metal Evaporation under Powerful Optical Radiation,” IEEE J. Quantum Electron. 9(5), 503 (1973).
J. M. Fishburn, M. J. Withford, D.W. Coutts, and J. A. Piper, “Method for Determination of the Volume of Material Ejected as Molten Droplets During Visible Nanosecond Ablation,” Appl. Opt. 43, 6473 (2004).
J. A. Aguilera, C. Aragon, G. Cristoforetti, and E. Tognoni, “Application of Calibration-Free Laser-Induced Breakdown Spectroscopy to Radially Resolved Spectra from a Copper-Based Alloy Laser-Induced Plasma,” Spectrochim. Acta B. 64, 685 (2009).
D. Bulajic, M. Corsi, G. Cristoforetti, S. Legnaioli, V. Palleschi, A. Salvetti, and E. Tognoni, “A Procedure for Correcting Self-Absorption in Calibration Free-Laser Induced Breakdown Spectroscopy,” Spectrochim. Acta B. 57, 339 (2002).
C. Aragon and J.A. Aguilera, “Characterization of Laser Induced Plasmas by Optical Emission Spectroscopy: A Review of Experiments and Methods,” Spectrochim. Acta B. 63, 893 (2008).
H. R. Griem, Plasma Spectroscopy (McGraw-Hill, London, 1964), 581 p.
F. Colao, V. Lazic, R. Fantoni, and S. Pershin, “A Comparison of Single and Dual Pulse Laser-Induced Breakdown Spectroscopy of Aluminum Samples,” Spectrochim. Acta B. 57, 1167 (2002).
G. Arumov, A. Bukharov, O. Kamenskaya, S. Kotyanin, V. Krivoshchekov, A. Lyash, V. Nekhaenko, and S. Pershin, “Effect of Surface Irradiation Regime on the Emission Spectrum of a Laser Plasma,” Pisma Zh. Eksp. Teor. Fiz. 13(14), 870 (1987).
S. M. Pershin, “Physical Mechanism of Suppression of the Emission of Radiation by Atmospheric Gases in a Plasma Formed as a Result of Two-Pulse Irradiation of the Surface,” Sov. J. Quantum Electron. 19(12), 1618 (1989).
B. Sallé, J.-L. Lacour, P. Mauchien, P. Fichet, et al. “Comparative Study of Different Methodologies for Quantitative Rock Analysis by Laser-Induced Breakdown Spectroscopy in a Simulated Martian Atmosphere,” Spectrochim. Acta B. 61, 301 (2006).
ESA’s Homepage for the AURORA ExoMars Mission: www.esa.int/SPECIALS/Aurora/SEM1NVZKQAD-0.html
Author information
Authors and Affiliations
Corresponding author
About this article
Cite this article
Pershin, S.M., Lednev, V.N. & Bunkin, A.F. Laser ablation of alloys: Selective evaporation model. Phys. Wave Phen. 19, 261–274 (2011). https://doi.org/10.3103/S1541308X11040054
Received:
Published:
Issue Date:
DOI: https://doi.org/10.3103/S1541308X11040054