Abstract
A technology of manufacturing goods from polymeric composite materials (PCMs) by resin film infusion using a VSE-20 epoxy joining agent was developed. It was shown that such a technology provides PCMs with physical-mechanical characteristics of the same level as that of materials produced using traditional prepreg-autoclave technology.
Similar content being viewed by others
References
L. V. Chursova, M. I. Dushin, A. V. Khrul’kov, et al., in Abstr. Intersect. Sci.-Technol. Conf. “Composite Materials in Aerospace Materials Science” Dedicated to the 100th Anniversary of A.T. Tumanov (Moscow, 2009) [in Russian].
K. J. Sen, E. W. Lindsay, and C. J. Schuck, in 28th Eur. Rotorcraft Forum (Bristol, 2002).
D. Lang, in Proc. Conf. “Composites RTM Infusion-2009.”
Author information
Authors and Affiliations
Corresponding author
Additional information
Original Russian Text © D.I. Kogan, L.V. Chursova, A.P. Petrova, 2011, published in Klei. Germetiki. Tekhnologii, 2011, No. 6, pp. 25–29.
Rights and permissions
About this article
Cite this article
Kogan, D.I., Chursova, L.V. & Petrova, A.P. A manufacturing technology of polymeric composite materials by resin film infusion. Polym. Sci. Ser. D 5, 60–64 (2012). https://doi.org/10.1134/S1995421212010078
Received:
Published:
Issue Date:
DOI: https://doi.org/10.1134/S1995421212010078