Abstract
The purpose of this study was to develop and apply a general method for estimating the architectural properties of human muscles in vivo. The method consists of a two-phase, nested optimization procedure in which the values of peak isometric force, optimal muscle-fiber length, and tendon slack length are calculated for each musculotendon actuator, knowing muscle volume and the minimum and maximum physiological lengths of the actuator. In phase I, the positions of the bones and the activation levels of the muscles are found by maximizing the isometric torque developed for each degree of freedom at each joint. In phase II, the architectural properties of each musculotendon actuator are found by matching the strength profile of the model to that measured for subjects. The method is used to estimate the architectural properties of 26 major muscle groups crossing the shoulder, elbow, and wrist. Wherever possible, the model calculations are compared against measurements obtained from anatomical studies reported in the literature. Architectural data obtained from our work should be useful to researchers interested in developing musculoskeletal models of the upper limb. © 2003 Biomedical Engineering Society.
PAC2003: 8719Rr, 8710+e, 8719Ff
Similar content being viewed by others
REFERENCES
Amis, A. A., D. Dowson, and V. Wright. Elbow joint force predictions for some strenuous isomeric actions. J. Biomech.13:765–775, 1980.
Amis, A. A., D. Dowson, and V. Wright. Muscle strengths and musculoskeletal geometry of the upper limb. Eng. Med. (Berlin)8:41–48, 1979.
An, K. N., F. C. Hui, B. G. Morrey, R. L. Linscheid, and E. Y. Chao. Muscles across the elbow joint: A biomechanical analysis. J. Biomech.14:659–669, 1981.
Anderson, F. C., and M. G. Pandy. Dynamic optimization of human walking. J. Biomech. Eng.123:381–390, 2001.
Anderson, F. C., and M. G. Pandy. Storage and utilization of elastic strain energy during jumping. J. Biomech.26:1413–1427, 1993.
Bassett, R. W., A. O. Browne, B. F. Morrey, and K. N. An. Glenohumeral muscle force and moment mechanics in a position of shoulder instability. J. Biomech.14:659–669, 1990.
Brand, P. W., R. B. Beach, and D. E. Thompson. Relative tension and potential excursion of muscles in the forearm and hand. J. Hand Surgery6:209–219, 1981.
Chen, J. J. Quantitative architectural analysis of human upper-extremity muscles. PhD dissertation, University of Virginia, 1988.
Cutts, A., R. M. Alexander, and R. F. Ker. Ratios of cross-sectional areas of muscles and their tendons in a healthy human forearm. J. Anatomy176:133–137, 1991.
Delp, S. L., A. E. Grierson, and T. S. Buchanan. Maximum isometric movements generated by the wrist muscles in flexion-extension and radial-ulnar deviation. J. Biomech.29:1371–1375, 1996.
Delp, S. L., J. P. Loan, M. G. Hoy, F. E. Zajac, E. L. Topp, and J. M. Rosen. An interactive graphics-based model of the lower extremity to study orthopaedic surgical procedures. IEEE Trans. Biomed. Eng.37:757–767, 1990.
Engin, A. E., and I. Kaleps. Active muscle torques about long-bone axes of major human joints. Aviat., Space Environ. Med.51:551–555, 1980.
Engin, A. E., and S. M. Chen. Statistical data base for the biomechanical properties of the human shoulder complex—I: Kinematics of the shoulder complex. J. Biomech. Eng.108:215–225, 1986.
Garner, B. A., and M. G. Pandy. Musculoskeletal model of the human arm based on the visible human male dataset. Comput. Methods Biomech. Biomed. Eng.4:93–126, 2001.
Garner, B. A., and M. G. Pandy. The obstacle set method for representing muscle paths in musculoskeletal models. Comput. Methods Biomech. Biomed. Eng.3:1–30, 2000.
Garner, B. A., and M. G. Pandy. A kinematic model of the upper limb based on the visible human project (VHP) image dataset. Comput. Methods Biomech. Biomed. Eng.2:107–124, 1999.
Gonzalez, R. V., E. L. Hutchins, R. E. Barr, and L. D. Abraham. Development and evaluation of a musculoskeletal model of the elbow joint complex. J. Biomech. Eng.118:32–40, 1996.
Gordon, A. M., A. F. Huxley, and F. J. Julian. The variation in isometric tension with sarcomere length in vertebrate muscle fibres. J. Physiol. (London)184:170–192, 1966.
Hatze, H.. Estimation of myodynamic parameter values from observations on isometrically contracting muscle groups. Appl. Phys. (Berlin)46:325–338, 1981.
Hoy, M. G., F. E. Zajac, and M. E. Gordon. A musculoskeletal model of the human lower extremity: The effect of muscle, tendon, and moment arm on the moment-angle relationship of musculotendon actuators at the hip, knee, and ankle. J. Biomech.23:157–169, 1990.
Hutchins, E. L. The musculoskeletal geometry of the human elbow and wrist: An analysis using torque-angle relationships. Masters thesis, The University of Texas at Austin, 1993.
Johnson, G. R., D. Spalding, A. Nowitzke, and N. Bogduk. Modelling the muscles of the scapula: Morphometric and coordinate data and functional implications. J. Biomech.29:1039–1051, 1996.
Karlsson, D., and B. Peterson. Towards a model for force predictions in the human shoulder. J. Biomech.25:189–192, 1992.
Keating, J. F., P. Waterworth, J. Shaw-Dunn, and J. Crossan. The relative strengths of the rotator cuff muscles. J. Bone Jt. Surg., Br. Vol.75B:137–140, 1993.
Klein-Breteler, M. D., C. W. Spoor, and F. C. T. Van der Helm. Measuring muscle and joint geometry parameters of a shoulder for modeling purposes. J. Biomech.32:1191–1197, 1999.
Knapik, J. J., J. E. Wright, R. H. Mawdsley, and J Braun. Isometric, isotonic, and isokinetic torque variations in four muscle groups through a range of joint motion. Physical Therapy63:938–947, 1983.
Lemay, M. A., and P. E. Crago. A dynamic model for simulating movements of the elbow, forearm, and wrist. J. Biomech.29:1319–1330, 1996.
Lieber, R. L., M. D. Jacobson, B. M. Fazeli, R. A. Abrams, and M. J. Botte. Architecture of selected muscles of the arm and forearm: Anatomy and implications for tendon transfer. J. Hand Surgery17A:787–798, 1992.
Loren, G. J., S. D. Shoemaker, T. J. Burkholder, M. D. Jacobson, J. Friden, and R. L. Lieber. Human wrist motors: Biomechanical design and application to tendon transfers. J. Biomech.29:331–342, 1996.
Otis, J. C., R. F. Warren, S. I. Backus, T. J. Santner, and J. D. Mabrey. Torque production in the shoulder of the normal young adult male. Am. J. Sports Med.18:119–123, 1990.
Pandy, M. G.. Computer modeling and simulation of human movement. Annu. Rev. Biomed. Eng.3:245–273, 2001.
Pandy, M. G., F. E. Zajac, E. Sim, and W. S. Levine. An optimal control model for maximum-height human jumping. J. Biomech.23:1185–1198, 1990.
Raasch, C. C., F. E. Zajac, B. Ma, and W. S. Levine. Muscle coordination of maximum-speed pedaling. J. Biomech.30:595–602, 1997.
Reiser, R. F. Development of geometric and muscle-specific parameter values for musculoskeletal modeling of the shoulder joint. Masters thesis, The University of Texas at Austin, 1993.
Spector, S. A., P. F. Gardiner, R. F. Zernicke, R. R. Roy, and V. R. Edgerton. Muscle architecture and force-velocity characteristics of cat soleus and medial gastrocnemius: Implications for motor control. J. Neurophysiol.44:951–960, 1980.
Steindler, A. Postgraduate lectures in orthopedics, diagnosis, and indications. Springfield, Illinois: Charles C. Thomas, 1950.
Veeger, H. E., Y. Bing, K. N. An, and R. H. Rozendal. Parameters for modeling the upper extremity. J. Biomech.30:647–652, 1997.
Veeger, H. E., F. C. van der Helm, L. H. van der Woulde, G. M. Pronk, and R. H. Rozendal. Inertia and muscle contraction parameters for musculoskeletal modeling of the shoulder mechanism. J. Biomech.24:615–629, 1991.
Weijs, W. A., and B. Hillen. Cross-sectional areas and estimated intrinsic strength of the human jaw muscles. Acta Morphology Aeerl.Scand23:267–274, 1985.
Winters, J. M., and D. J. Kleweno. Effect of initial upper limb alignment on muscle contributions to isometric strength curves. J. Biomech.26:143–153, 1993.
Winters, J. M., and L. Stark. Estimated mechanical properties of synergistic muscles involved in movements of a variety of human joints. J. Biomech.21:1027–1041, 1988.
Wood, J. E., S. G. Meek, and S. C. Jacobsen. Quantitation of human shoulder anatomy for prosthetic arm control—I. Surface modelling. J. Biomech.22:273–292, 1989.
Zajac, F. E. Muscle and tendon: Properties, models, scaling, and application to biomechanics and motor control. In: CRC Critical Reviews in Biomedical Engineering, edited by J. R. Bourne. Baltimore; Williams & Wilkins, 1989, Vol. 17, pp. 359–411.-
Author information
Authors and Affiliations
Rights and permissions
About this article
Cite this article
Garner, B.A., Pandy, M.G. Estimation of Musculotendon Properties in the Human Upper Limb. Annals of Biomedical Engineering 31, 207–220 (2003). https://doi.org/10.1114/1.1540105
Issue Date:
DOI: https://doi.org/10.1114/1.1540105