Abstract
Historically, the optoacoustic effect has been produced in gases through the absorption of IR radiation1–3. As the effect depends only on the conversion of modulated radiation to periodic heating of the gas (which in a closed vessel is equivalent to a sound wave), it is not surprising that the optoacoustic effect can be produced by several different interactions where radiation is absorbed by matter. Here we report generation of the optoacoustic effect by photochemical release of energy through a chain reaction mechanism in H2–Cl2 mixtures. A unique feature of the optoacoustic effect produced in this manner is chemical amplification of the acoustic signal caused by a release of energy from the chemical reactions that is greater than the energy absorbed from the light beam. In addition, because the acoustic signal depends on the kinetics of the reaction and the time dependent concentrations of the reactants, the optoacoustic effect acts to monitor directly the progress of the reaction in time.
Similar content being viewed by others
References
Bell, A. G. Proc. Am. Ass. Adv. Sci. 29, 115–136 (1880).
Patel, C. K. N. Science 202, 157–173 (1978).
Pao, Y. H. Optoacoustic Spectroscopy and Detection (Academic, New York, 1977).
Diebold, G. J. & Hayden, J. S. Chem. Phys. 49, 429–437 (1980).
Diebold, G. J. J. phys. Chem. 84, 2213–2221 (1980).
Colles, M. J., Angus, A. M. & Marinero, E. E. Nature 262, 681–683 (1976).
Burnett, G. M. & Melville, H. W. in Techniques of Organic Chemistry Vol. 8 (Interscience, New York, 1953).
Author information
Authors and Affiliations
Rights and permissions
About this article
Cite this article
O'Connor, M., Diebold, G. Chemical amplification of optoacoustic signals. Nature 301, 321–322 (1983). https://doi.org/10.1038/301321a0
Received:
Accepted:
Issue Date:
DOI: https://doi.org/10.1038/301321a0
- Springer Nature Limited
This article is cited by
-
Optoacoustic detection: Revival of an old technique
Nature (1983)