Abstract
The conditions for the optimisation of any step index waveguide evanescent-wave sensor and for the manufacturing tolerances are given in the form of analytical and normalised expressions. The analysis is made for both TE and TM modes, in both cases where the measurand is homogeneously distributed in the cover, and where it is an ultrathin film on the waveguide-cover interface.
Similar content being viewed by others
References
Hodgson, J. Bio/Technology, 30–35. BIAcore, Sweden; BIOS-1, ASI, Switzerland; IAsys, Labsystems Affinity Sensors, UK, 1994.
Kunz, R.E. Sensors and Actuators B 38–39 13, 1997.
Nellen, P.M., K. Tiefenthaler and W. Lukosz. Sensors and Actuators B 15 285, 1988.
Parriaux, O and G.J. Veldhuis. J. Lightwave Tech. 16 573, 1998.
Tien, P.K. Appl. Opt. 11–11 2395, 1971.
Author information
Authors and Affiliations
Rights and permissions
About this article
Cite this article
Brioude, V., Parriaux, O. Normalised analysis for the design of evanescent-wave sensors and its use for tolerance evaluation. Optical and Quantum Electronics 32, 899–908 (2000). https://doi.org/10.1023/A:1007030931823
Issue Date:
DOI: https://doi.org/10.1023/A:1007030931823