Abstract
The effects of coolant’s temperature on emissions of particulate matters (PM) and particle-bound polycyclic aromatic hydrocarbons (PAHs) from a gasoline direct injection (GDI) engine were studied during the start process using gasoline (M0) and gasoline mixed with methanol in 15 % volume (M15). The engine worked at a certain idle speed automatically under different coolant’s temperature conditions after successful start. The experimental data was recorded from 0 to 40 seconds during the start. Results indicated that, there are significant differences in PM and particle-bound PAHs emissions between cold and warm start conditions. Particulate size distribution was measured with the Engine Exhaust Particle Sizer (EEPS) 3090. Compared with M0 fuel, the PM emission of M15 fuel decreased significantly, especially nucleation-mode particulate emission. The mass emission of PM was measured using the Gravimetric method. A same variation trend in PM mass emissions can be inferred for both fuels, i.e. it decreases while the coolant’s temperature increases. Compared with M0 fuel, the PM mass with M15 fuel reduces by 80 % at 20 oC coolant’s temperature. Agilent 7000B GC-QQQ was used to provide both qualitative and quantitative analysis on PAHs. The application of M15 fuel reduces the concentrations of most PAH species compared with M0 fuel, except those with smaller aromatic rings. In addition, Benzo(a)pyrene equivalent toxicity (BEQ) is calculated to evaluate the toxicity of PAHs emissions. The toxicity decreases when the GDI engine starts with higher coolant’s temperature or with M15 fuel.
Similar content being viewed by others
References
Ayala, A. and Herner, J. D. (2005). Transient ultrafine particle emission measurements with a new fast particle aerosol sizer for a trap equipped diesel truck. SAE Paper No. 2005–01-3800
Bakeas, E., Karavalakis, G., Fontaras, G. and Stournas, S. (2011). An experimental study on the impact of biodiesel origin on the regulated and PAH emissions from a Euro 4 light-duty vehicle. Fuel 90, 11, 3200–3208
Brinkman, N. D., Halsall, R., Jorgensen, S. W. and Kirwan, J. E. (1994). The Development of Improved Fuel Specifications for Methanol (M85) and Ethanol (Ed85). SAE International. Warrendale, Pennsylvania, USA.
Carter, R. N., Menacherry, P., Pfefferle, W. C., Muench, G. and Roychoudhury, S. (1998). Laboratory evaluation of ultra-short metal monolith catalyst. SAE Paper No. 980672
Chan, T. W., Meloche, E., Kubsh, J., Brezny, R., Rosenblatt, D. and Rideout, G. (2013). Impact of ambient temperature on gaseous and particle emissions from a direct injection gasoline vehicle and its implications on particle filtration. SAE Int. J. Fuels and Lubricants 6, 2, 350–371
Chen, L., Braisher, M., Crossley, A., Stone, R. and Richardson, D. (2010). The influence of ethanol blends on particulate matter emissions from gasoline direct injection engines. SAE Paper No. 2010–01-0793
Dockery, D. W. and Pope, C. A. (1994). Acute respiratory effects of particulate air pollution. Annual Review of Public Health, 15, 107–132
Egebäck, K. E., Henke, M., Rehnlund, B., Wallin, M. and Westerholm, R. (2005). Blending of Ethanol in Gasoline for Spark Ignition Engines-problem Inventory and Evaporative Measurements. AVL MTC Motortestcenter AB. Report 2005–05-30
Gauderman, W. J., Urman, R., Avol, E., Berhane, K., McConnell, R., Rappaport, E., Chang, R., Lurmann, F. and Gilliland, F. (2015). Association of improved air quality with lung development in children. The New England J. Medicine, 372, 905–913
Geng, P., Zhang, H. and Yang, S. (2015). Experimental investigation on the combustion and particulate matter (PM) emissions from a port-fuel injection (PFI) gasoline engine fueled with methanol–ultralow sulfur gasoline blends. Fuel, 145, 221–227
Ghadikolaei, M. A. (2016). Effect of alcohol blend and fumigation on regulated and unregulated emissions of IC engines–A review. Renewable and Sustainable Energy Reviews, 57, 1440–1495
Hsieh, W. D., Chen, R. H., Wu, T. L. and Lin, T. H. (2002). Engine performance and pollutant emission of an SI engine using ethanol-gasoline blended fuels. Atmos Environ 36, 3, 403–410
Karavalakis, G., Short, D., Vu, D., Villela, M., Russell, R., Jung, H., Asa-Awuku, A. and Durbin, T. (2014). Regulated emissions, air toxics, and particle emissions from SI-DI light-duty vehicles operating on different iso-butanol and ethanol blends. SAE Int. J. Fuels and Lubricants 7, 1, 183–199
Kazakov, A., Wang, H. and Frenklach, M. (1995). Detailed modeling of soot formation in laminar premixed ethylene flames at a pressure of 10 bar. Combustion and Flame 100, 1–2, 111–120
Kittelson, D. B. (1998). Engines and nanoparticles: A review. J. Aerosol Science 29, 5–6, 575–588
Lewis, M. G. and Valley, M. (2007). E8 Fuel Composition and Method. U.S. Patent. US 20070256354
Li, M. (2014). Research on the State Characteristics of Particles and Formation Mechanism of Precursors Formed by Oxygenated Fuels. Ph. D. Dissertation. Jiangsu University. Zhenjiang, China.
Liang, B., Ge, Y., Tan, J., Han, X., Gao, L., Hao, L., Ye, W. and Dai, P. (2013). Comparison of PM emissions from a gasoline direct injected (GDI) vehicle and a port fuel injected (PFI) vehicle measured by electrical low pressure impactor (ELPI) with two fuels: Gasoline and M15 methanol gasoline. J. Aerosol Science, 57, 22–31
Liao, S. Y., Jiang, D. M., Cheng, Q., Huang, Z. H. and Wei, Q. (2005). Investigation of the cold-start combustion characteristics of ethanol-gasoline blends in a constantvolume chamber. Energy and Fuels 19, 3, 813–819
Liu, S., Cuty Clemente, E. R., Hu, T. and Wei, Y. (2007). Study of spark ignition engine fueled with methanol/gasoline fuel blends. Applied Thermal Engineering 27, 11–12, 1904–1910
Luo, Y. Q., Zhu, L., Fang, J. H., Zhuang, Z. Y., Guan, C., Xia, C., Xie, X. M. and Huang, Z. (2015). Size distribution, chemical composition and oxidation reactivity of particulate matter from gasoline direct injection (GDI) engine fueled with ethanol-gasoline fuel. Applied Thermal Engineering, 89, 647–655
Magnusson, R. and Nilsson, C. (2011). The influence of oxygenated fuels on emissions of aldehydes and ketones from a two-stroke spark ignition engine. Fuel 90, 3, 1145–1154
Miller, J. A. and Melius, C. F. (1992). Kinetic and thermodynamic issues in the formation of aromatic compounds in flames of aliphatic fuels. Combust Flame 91, 1, 21–39
Miller, J. A., Volponi, J. V. and Pauwels, J. F. (1996). The effect of allene addition on the structure of a rich C2H2 O2/Ar flame. Combust Flame 105, 4, 451–461
Nisbet, I. C. T. and LaGoy, P. K. (1992). Toxic equivalency factors (TEFs) for polycyclic aromatic hydrocarbons (PAHs). Regulatory Toxicology and Pharmacology 16, 3, 290–300
Oh, C. and Cha, G. (2013). Influence of oxygenate content on particulate matter emission in gasoline direct injection engine. Int. J. Automotive Technology 14, 6, 829–836
Pang, X., Mu, Y., Yuan, J. and He, H. (2008). Carbonyls emission from ethanol-blended gasoline and biodieselethanol-diesel used in engines. Atmospheric Environment 42, 6, 1349–1358
Price, P., Twiney, B., Stone, R., Kar, K. and Walmsley, H. (2007). Particulate and hydrocarbon emissions from a spray guided direct injection spark ignition engine with oxygenate fuel blends. SAE Paper No. 2007–01-0472
Ravindra, K., Sokhi, R. and Van Grieken, R. (2008). Atmospheric polycyclic aromatic hydrocarbons: Source attribution, emission factors and regulation. Atmospheric Environment 42, 13, 2895–2921
Sobotowski, R. A., Butler, A. D. and Guerra, Z. (2015). A pilot study of fuel impacts on PM Emissions from lightduty gasoline vehicles. SAE Int. J. Fuels and Lubricants 8, 1, 214–233
Tang, M. J., Li, Q. F., Xiao, L. F., Li, Y. P., Jensen, J. L., Liou, T. G. and Zhou, A. H. (2012). Toxicity effects of short term diesel exhaust particles exposure to human small airway epithelial cells (SAECs) and human lung carcinoma epithelial cells (A549). Toxicology Letters 215, 3, 181–192
Vojtisek-Lom, M., Pechout, M., Dittrich, L., Beránek, V., Kotek, M., Schwarz, J., Vodička, P., Milcová, A., Rossnerová, A., Ambrož, A. and Topinka, J. (2015). Polycyclic aromatic hydrocarbons (PAH) and their genotoxicity in exhaust emissions from a diesel engine during extended low-load operation on diesel and biodiesel fuels. Atmospheric Environment, 109, 9–18
Walch, S. P. (1995). Characterization of the minimum energy paths for the ring closure reactions of C4H3 with acetylene. J. Chemical Physics, 103, 8544
Wang, H. and Frenklach, M. (1997). A detailed kinetic modeling study of aromatics formation in laminar premixed acetylene and ethylene flames. Combustion and Flame 110, 1–2, 173–221
Wang, X., Ge, Y., Liu, L., Peng, Z., Hao, L., Yin, H., Ding, Y. and Wang, J. (2015). Evaluation on toxic reduction and fuel economy of a gasoline direct injection-(GDI-) powered passenger car fueled with methanol–gasoline blends with various substitution ratios. Applied Energy, 157, 134–143
Zhang, S. and McMahon, W. (2012). Particulate emissions for LEV II light-duty gasoline direct injection vehicles. SAE Int. J. Fuels and Lubricants 5, 2, 637–646
Zheng, D. and Zhong, B. J. (2015). Characteristics and kinetic analysis of soot formation for representative species of gasoline in premixed flame. J. Combustion Science and Technology 21, 2, 131–134
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Hong, W., Yuan, C., Xie, F. et al. Particulate Matter and Particle-Bound PAHs Emissions from Gasoline Direct Injection (GDI) Engine with Methanol-Gasoline Blended Fuel During Start. Int.J Automot. Technol. 19, 717–726 (2018). https://doi.org/10.1007/s12239-018-0069-1
Received:
Revised:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s12239-018-0069-1