Skip to main content
SpringerLink
Log in

Load distribution in pile group embedded in sandy soil containing cavity

  • Geotechnical Engineering
  • Published:
KSCE Journal of Civil Engineering Aims and scope Submit manuscript

Abstract

The present study investigates the influence of presence of cavities on the bearing capacity and settlement of piled foundation. The work included experiments carried out to study the behavior of pile models constructed in sand with a dry unit weight 16.8 kN/m3. Pile models were tested in a sand container under a load applied through a hydraulic mounted jack and measured using a load cell. Three strain gages were proved to piles to evaluate the strains and then estimate the load transformed to each pile in the group by a strain indicator. Three groups of piles (single pile, group of piles (1 × 2), and group of piles (2 × 2)) were tested in the laboratory as a free standing pile group. A prototype of a cavity was used and placed adjacent to the piles at various distances from the centerline of piles and various depths below the surface. The effect of variation of cavity location (X), cavity depth (Y), and cavity diameter (d) on the load and settlement of the pile and groups of piles has been studied for all tests. It was found that the load in pile increases with increase of (X/D, D is the pile diameter) due to decrease of the zone affected by the presence of cavity. When the cavity is located at a close distance to the pile, it will reduce the soil density and hence decrease the shaft friction along the pile and lead to decrease in the pile failure load. The failure load is not affected by the presence of a cavity at a distance of 5.5 pile diameters at all depths. The presence of the cavity in the soil reduces the ultimate failure load of the pile. For pile group (1 × 2), the reduction rate is about (40% to 80%) at (d/D = 1), while the rate at (d/D = 2) is about 65% to 85%.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Log in via an institution

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Institutional subscriptions

Similar content being viewed by others

References

  • Al-Taie, S. M. (2004). The performance of laterally loaded piles embedded in sandy soils which contains cavities, MSc Thesis, Civil Engineering Department, University of Baghdad. Iraq

    Google Scholar 

  • Arosemena, R. L. (2007). Effect of horizontal piles on the soil bearing capacity for circular footing above cavity, MSc Thesis, Civil and Environmental Engineering, College of Engineering and Computer Science at the University of Central Florida, Orlando, Florida, USA.

    Google Scholar 

  • Asakereh, A., Moghaddas Tafreshi, S. N., and Ghazavi, M. (2012). “Strip footing behavior on reinforced sand with void subjected to repeated loading.” International Journal of Civil Engineering, Vol. 10, No. 2, pp. 139–152.

    Google Scholar 

  • ASTM D854-02 (2002). “Standard test methods for specific gravity of soil solids by water pycnometer.” American Society for Testing and Materials.

    Google Scholar 

  • ASTM D 1143-07 (2007). “Standard test method for piles under static axial compressive load.” American Society for Testing and Materials.

    Google Scholar 

  • ASTM D2487-02 (2000). “Standard practice for classification of soils for engineering purposes (unified soil classification system).” American Society for Testing and Materials.

    Google Scholar 

  • ASTM D4253-02 (2000). “Standard test methods for maximum index density and unit weight of soils using a vibratory table.” American Society for Testing and Materials.

    Google Scholar 

  • ASTM D4254-02 (2000). “Standard test methods for minimum index density and unit weight of soils and calculation of relative density.” American Society for Testing and Materials.

    Google Scholar 

  • ASTM D3080-98 (2000). “Standard test method for direct shear test of soils under consolidated drained conditions.” American Society for Testing and Materials.

    Google Scholar 

  • Baus, R. L. and Wang, M. C. (1983). “Bearing capacity of strip footings above void.” Journal of Geotechnical Engineering, ASCE, Vol. 109, No. 1, pp. 1–14.

    Article  Google Scholar 

  • Cheng, C. Y., Dasari, G. R., Leung, C. F., Chow, Y. K., and Rosser, H. B. (2004). “3D Numerical Study of Tunnel-Soil-Pile Interaction.” Journal of Tunnelling and Underground Space Technology, Vol. 19, Issues 4-5, pp. 381–382.

    Article  Google Scholar 

  • Cheng, C. Y., Dasari, G. R., Chow, Y. K., and Leung, C. F. (2007). “Finite element analysis of tunnel-soil-pile interaction using displacement control model.” Tunnelling and Underground Space Technology, Vol. 22, No. 4, pp. 450–466, DOI: 10.1016/j.tust.2006.08.002.

    Article  Google Scholar 

  • Chen, L. T., Poulos, H. G., and Loganathan, N. (1999). “Pile Responses Caused by Tunneling.” Journal of Geotechnical and Geoenvironmental Engineering, ASCE, Vol. 125, No. 3, pp. 207–215.

    Article  Google Scholar 

  • Gordon, T. K. and Ng, C. W. W. (2005). “Effects of advancing open face tunneling on an existing loaded pile.” Journal of Geotechnical and Geoenvironmental Engineering, ASCE, Vol. 131, No. 2, pp. 193–201.

    Article  Google Scholar 

  • Haijian, H., Weining, L., Yanyong, X., and Ting, W. (2004). “Safety analysis of the influence of metro construction on adjacent bridge piles.” School of Civil Engineering and Architecture, Beijing Jiaotong University, Beijing 100044, China.

    Google Scholar 

  • Huang, M., Zhang, C., and Li, Z. (2009). “A simplified analysis method for the influence of tunneling on grouped piles.” Journal of Tunnelling and Underground Space Technology, Vol. 24, Issue 4, pp. 410–422, DOI: 10.1016/j.tust.2008.11.005.

    Article  Google Scholar 

  • Khattab, S. A. and Khalil A. A. (2009). “Effect of cavity on stress distribution and settlement under foundation.” Journal of Al-Rafidain Engineering, Vol. 17, No. 6, pp. 14–29.

    Google Scholar 

  • Kitiyodom, P., Matsumoto, T., and Kawaguchi, K. (2005). “A simplified analysis method for piled raft foundations subjected to ground movements induced by tunneling.” International Journal of Numerical and Analytical Methods in Geomechanics, Vol. 29, pp. 1485–1507.

    Article  MATH  Google Scholar 

  • Lavasan, A. A., Talsaz, A., Ghazavi, M., and Schanz, T. (2015). “Behavior of shallow strip footing on twin voids.” Geotechnical and Geological Engoneering, DOI: 10.1007/s10706-016-9989-6.

  • Lee, C. J. and Jacobsz, S. W. (2006). “The influence of tunneling on adjacent piled foundation.” Tunneling and Underground Space Technology, Vol. 21, Nos. 3-4, 430, DOI: 10.1016/j.tust.2005.12.072.

    Article  Google Scholar 

  • Lee, J. K., Jeong, S., and Ko, J. (2014). “Undrained stability of surface strip footings above voids.” Computers and Geotechnics, Vol. 62, pp. 128–135, DOI: 10.1016/j.compgeo.2014.07.009.

    Article  Google Scholar 

  • Lee, Y. J. and Bassett, R. H. (2007). “Influence zones for 2D Pile-Soiltunneling interaction based on model test and numerical analysis.” Tunneling and Underground Space Technology, Vol. 22, Issue 3, pp. 325–342, DOI: 10.1016/j.tust.2006.07.001.

    Article  Google Scholar 

  • Loganathan, N., Poulos, H. G., and Stewart, D. P. (2000). “Centrifuge model testing of tunneling-induced ground and pile deformations.” Géotechnique, Vol. 50, No. 3, pp. 283–294.

    Article  Google Scholar 

  • Loganathan, N., Poulos, H. G., and Xu, K. J. (2001). “Ground and pile group response due to tunneling.” Soils and Foundations, Vol. 41, No. 1, pp. 57–67.

    Article  Google Scholar 

  • Morton, J. D. and King, K. H. (1979). “Effect of tunneling on the bearing capacity and settlement of piled foundation.” Proceedings of Tunneling 79, IMM, London, pp. 57–68.

    Google Scholar 

  • Mroueh, H. and Shahrour, I. (2002). “Three dimensional finite element analysis of the interaction between tunneling and pile foundations.” International Journal for Numerical and Analytical Methods in Geomechanics, Vol. 26, Issue 3, pp. 217–230.

    Article  MATH  Google Scholar 

  • Murthy, V. N. S. (1989). Soil mechanics and foundation engineering, 3rd. Edition, Bangalore.

    Google Scholar 

  • Peng, F. L., Kiyosumi, M., Ohuchi, M., and Kusakabe, O. (2006). “Cavity effects on the bearing capacity of footing foundations and the calculation method.” Underground Construction and Ground Movement, ASCE, pp. 50–57, DOI: 10.1061/40867(199)4.

    Google Scholar 

  • Prakash, S. (1990). Pile foundations in engineering practice, John Wiley and Sons, New York.

    Google Scholar 

  • Sowers, G. F. (1996). Building on sinkholes: Design and construction of foundations in Karst Terrain, New York, NY: American Society of Civil Engineers.

    Book  Google Scholar 

  • Terzaghi, K. (1943). Theoretical soil mechanics, Wiley, New York.

    Book  Google Scholar 

  • Xu, K. J. and Poulos, H. G. (2001). “3-D Elastic Analysis of Vertical Piles Subjected to Passive Loadings.” Computers and Geotechnics, Vol. 28, pp. 349–375.

    Article  Google Scholar 

Download references

Author information

Authors and Affiliations

  1. Building and Construction Engineering Dept., University of Technology, Baghdad, Iraq

    Mohammed Y. Fattah, Karim Hadi I. Al Helo & Hala H. Abed

Authors
  1. Mohammed Y. Fattah
    View author publications

    You can also search for this author in PubMed Google Scholar

  2. Karim Hadi I. Al Helo
    View author publications

    You can also search for this author in PubMed Google Scholar

  3. Hala H. Abed
    View author publications

    You can also search for this author in PubMed Google Scholar

Corresponding author

Correspondence to Mohammed Y. Fattah.

Rights and permissions

Reprints and permissions

About this article

Check for updates. Verify currency and authenticity via CrossMark

Cite this article

Fattah, M.Y., Al Helo, K.H.I. & Abed, H.H. Load distribution in pile group embedded in sandy soil containing cavity. KSCE J Civ Eng 22, 509–519 (2018). https://doi.org/10.1007/s12205-017-0002-6

Download citation

  • Received:

  • Revised:

  • Accepted:

  • Published:

  • Issue Date:

  • DOI: https://doi.org/10.1007/s12205-017-0002-6

Keywords

Search

Navigation