Abstract
The phase precipitation in industrial AISI 316L stainless steel during aging for up to 80,000 hours between 823 K and 1073 K (550 °C and 800 °C) has been studied using transmission electron microscopy, scanning transmission electron microscopy, and carbon replica energy-dispersive X-ray microanalysis. Three phases were identified: Chromium carbides (M23C6), Laves phase (η), and σ-phase (Fe-Cr). M23C6 carbide precipitation occurred firstly and was followed by the η and σ-phases at grain boundaries when the aging temperature is higher than 873 K (600 °C). Precipitation and growth of M23C6 create chromium depletion zones at the grain boundaries and also retard the σ-phase formation. Thus, the σ-phase is controlled by the kinetic of chromium bulk diffusion and can appear only when the chromium reaches, at grain boundaries and at the M23C6/γ and M23C6/η/γ interfaces, content higher than a critical value obtained by self-healing. An analytical model, based on equivalent chromium content, has been established in this study and successfully validated to predict the time–temperature–precipitation diagram of the σ-phase. The obtained diagram is in good agreement with the experimental results.
Similar content being viewed by others
References
G.R. Garcés, J.L. Coze, J.L. Garin, R.L. Mannheim. Scripta Mater. 2004; 50: 651-54.
C.C. Hsieh, D.Y. Lin, W. Wu. Mater. Sci. Eng. A 2007; 467: 181-89.
Y.H. Kim, D.J. Lee, J.C. Byun, K.H. Jung, J.I. Kim, H.J. Lee, Y.T. Shin, S.H. Kim, H.W. Lee, Mater. Des. 2011; 32: 330-36.
M. Schwind, J. Kallqvist, J.O. Nilsson, J. Agren. Acta Mater. 2000; 48: 2473-81.
F. Liu, Y.H. Hwang, S.W. Nam. Mater. Sci. Eng. A 2008; 484: 418-21.
A.F. Padilha, D.M. Escriba, E.M. Morris, M. Rieth. J. Nucl. Mater. 2007; 362: 132-38.
S. Kozuh, M. Gojic, L. Kosec. RMZ-M&G 2007; 54: 331-44.
X. Tang. Microsc. Microanal. 2005; 11: 78-79.
A.M. Babakr, A. Alahmari, K. Aljumayiah, F. Habiby. JMMCE 2008; 7: 127-45.
H. Sahlaoui, K. Makhlouf, H. Sidhom, J. Philibert. Mater. Sci. Eng. A 2004; 372: 98-108.
H. Sahlaoui, H. Sidhom, J. Philibert. Acta Mater. 2002; 50: 1383-92.
M.E. Nicholson, C.H. Samans, F.J. Shortsleeve. Trans. ASM 1952; 44: 601-20.
O. Conejero, M. Palacios, S. Rivera. Eng. Fail. Anal. 2009; 16: 699-704.
Author information
Authors and Affiliations
Corresponding author
Additional information
Manuscript submitted September 24, 2012.
Rights and permissions
About this article
Cite this article
Sahlaoui, H., Sidhom, H. Experimental Investigation and Analytical Prediction of σ-Phase Precipitation in AISI 316L Austenitic Stainless Steel. Metall Mater Trans A 44, 3077–3083 (2013). https://doi.org/10.1007/s11661-013-1647-5
Published:
Issue Date:
DOI: https://doi.org/10.1007/s11661-013-1647-5