Detection of fluorescent compounds in the environment using granular activated charcoal detectors

Abstract.

Granular activated charcoal (GAC) acts as a general adsorptive medium for organic molecules, and is widely used to capture fluorescent tracer dyes. To investigate the capability of GAC in contaminant screening and tracer adsorption, a number of detectors were deployed for 2–6 days in a range of urban surface waters, and the adsorbed compounds eluted in an alkaline alcohol solution. Simultaneous water samples showed a diverse range of fluorescence environments, ranging from relatively clean, steady groundwater discharge, to highly concentrated and variable treated municipal sewage. A wide variety of organic compounds and dyes were found in the waters, as chronic and acute contaminants. The relationship between charcoal and water spectra depended on exposure time and loading. Short exposure times emphasized short wavelengths, longer exposure times emphasized longer wavelengths at the expense of shorter wavelengths. The magnitude of the effect depended on loading, being greater in enriched waters. In general, charcoal eluent shows a significant gain in fluorescence intensity over water. However, there may be an apparent loss at shorter wavelengths for samples with long exposure times and high loading. A similar bias was also discovered with the elution time of activated charcoal. Short wavelength fluorescence intensity peaked after a few minutes of elution; longer wavelength fluorescence increased over many days. These results show that charcoal is a reasonably effective material for adsorption of longer wavelength compounds. However, the ubiquity of many fluorescent dyes in the environment, and the complex relationship between the waters and the eluent spectrum, suggest that considerable care is required in the interpretation of eluent spectra.