Abstract
This article proposes a technique for defining the parameters of heat treatment and melting of materials in a solar furnace. The parameters are the flux density distribution in the working zone, the maximum heating temperature and temperature distribution in the working zone, and the specific material melting rate.
Similar content being viewed by others
REFERENCES
Baum, V.A., Solnechnye vysokotemperaturnye pechi, Sbornik perevodov (Solar High-Temperature Furnaces, Collection of Articles), Baum, V.A., Ed., Moscow: Inostr. Liter., 1960.
Zakhidov, R.A., Umarov, G.A., and Vainer, A.A., Teoriya i raschet geliotekhnicheskikh kontsentriruyushchikh sistem (Theory and Calculation of Solar Concentrating Systems), Tashkent: Fan, 1977.
Design, manufacture and testing of alignment equipment and other non-standard devices and accessories for the Large Solar Furnace, Report, Tashkent: VNTITs, 1988.
Isachenko, V.P., Osipova, V.A., and Sukomel, A.S., Teploperedacha (Heat transfer), Moscow: Energoizdat, 1981.
Fiziko-khimicheskie svoistva okislov. Spravochnik (Physic-chemical properties of oxides. Handbook), Samsonov, G.V., Ed., Moscow: Metallurgiya, 1978.
ACKNOWLEDGMENTS
This work was performed as part of the joint Uzbek–Russian project MRU-FA-18/2017 “Studying the Behavior of a Ceramic Refractory Oxide Composite and Its Morphological and Structural Changes in a Heavily Imbalanced Thermal and Light Field.”
Author information
Authors and Affiliations
Corresponding author
Additional information
Translated by S. Kuznetsov
About this article
Cite this article
Suleymanov, S.X., Dyskin, V.G., Dudko, O.A. et al. Determination of Parameters of Heat Treatment and Melting of Materials in a Solar Furnace. Appl. Sol. Energy 54, 485–487 (2018). https://doi.org/10.3103/S0003701X18060154
Received:
Revised:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.3103/S0003701X18060154