Abstract
Results of particle-in-cell simulation of the formation of a near-wall plasma layer produced by an ionization source remote from the chamber walls are verified experimentally. The measured profiles of the density and temperature of the plasma produced by an electron beam in two modes are compared: (i) gas is ionized by a low-density electron beam, while collective interactions are almost absent (beam-induced plasma), and (ii) gas is mainly ionized by plasma electrons heated due to the development of two-stream instability (beam−plasma discharge). The measured spatial profiles of the parameters of the beam-induced plasma are found to qualitatively agree with the model ones.
Similar content being viewed by others
REFERENCES
M. A. Lieberman and A. J. Lichtenberg, Principles of Plasma Discharges and Materials Processing (Wiley, New York, 1994).
E. G. Shustin, V. P. Tarakanov, and K. Ronald, Vacuum 135, 1 (2017).
N. V. Isaev, I. L. Klykov, V. V. Peskov, E. G. Shustin, I. V. Vizgalov, and V. A. Kurnaev, Instrum. Exp. Tech. 57, 82 (2014).
N. V. Isaev, A. I. Chmil’, and E. G. Shustin, Plasma Phys. Rep. 30, 263 (2004).
E. G. Shustin, N. V. Isaev, M. P. Temiryazeva, and Yu. V. Fedorov, Vaccum 83, 1350 (2009).
O. V. Kozlov, Electrical Probe in Plasma (Atomizdat, Moscow, 1969) [in Russian].
ACKNOWLEDGMENTS
We are grateful to F.S. Podolyako for his assistance in conducting probe measurements. This work was supported in part by the Russian Foundation for Basic Research, project no. 18-38-00884.
Author information
Authors and Affiliations
Corresponding author
Additional information
Translated by E. Chernokozhin
Rights and permissions
About this article
Cite this article
Sorokin, I.A., Shustin, E.G. Density Profile of a Plasma Layer Formed by an Electron Beam. Plasma Phys. Rep. 44, 1164–1168 (2018). https://doi.org/10.1134/S1063780X18120061
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1134/S1063780X18120061