Abstract
In applications of concrete for shielding against hazardous radiation or for being used as counterweight, as well as in various other applications that involve the use of heavyweight concrete, the most significant method of mix design involves the use of heavyweight aggregates. Concrete mixes that were produced for this work contained iron ore, steel mill scale, two types of barite, and steel slag, which are the heavyweight aggregates available in Turkey. An additional heavyweight concrete mixture was also produced using magnetite as a natural mineral heavyweight aggregate. In all concrete mixes produced, water/cement ratio, cement content, and the maximum aggregate size of the aggregates used were kept constant. In terms of the main mechanical properties, the best performances were obtained when iron ore was used, while the highest fracture energy values were reached in concretes with steel mill scale, magnetite, or with the combination of steel slag, iron ore, and crushed sand. Another important objective of this research was to evaluate the radiation shielding properties of heavyweight concretes containing iron ore, steel mill scale, two types of barite, or steel slag as aggregates. The experimental results showed that the attenuation coefficient varied from 0.224 to 0.265 1/cm, while the unit weight of heavyweight concrete was increased from 3012 to 3820 kg/m3. On the other hand, there is reasonably good agreement between theoretical and experimental results of linear attenuation coefficients. It can be concluded that the dominant factor in the determination of attenuation coefficient is the unit weight of heavyweight concrete and that the value of the coefficient is independent of the type of heavyweight aggregate used.
Similar content being viewed by others
References
Kılınçarslan Ş., Başyiğit C., Akkurt İ.: Investigation of heavyweight concrete with barite aggregates for radiation shielding. J. Fac. Eng. Architect. Gazi Univ. 22(2), 393–399 (2007)
Akyüz, S.: Heavyweight concrete with barite aggregate for protecting structures against Gamma Rays, ITU J. 35(5), 59–69(1977)
Coşkun, A.: Use of barite aggregate in heavy-weight concrete and study of concrete properties. Master Thesis, Afyon Kocatepe University (2010)
Ouda A.S.: Development of high performance heavy density concrete using different aggregates for Gamma-Ray shielding. Prog. Nucl. Energy 79, 48–55 (2015)
Ling T.C., Poon C.S.: Feasible use of recycled CRT funnel glass as heavyweight fine aggregate in barite concrete. J. Clean. Prod. 33, 42–49 (2012)
Ling T.C., Poon C.S.: High temperatures properties of barite concrete with cathode ray tube funnel glass. Fire Mater 38, 279–289 (2014)
Gonzales-Ortega M.A., Segura I., Cavalaro S.H.P., Toralles-Carbonari B., Aguado A., Andrello A.C.: Radiological protection and mechanical properties of concretes with EAF steel slag. Constr. Build. Mater. 51, 432–438 (2014)
Monte L.F., Gambarova P.G.: Thermo-mechanical behavior of baritic concrete exposed to high temperature. Cem. Concr. Compos. 53, 305–315 (2014)
Alwaeli M., Nadziakiewicz J.: Recycling of scale and steel chips waste as a partial replacement of sand in concrete. Constr. Build. Mater. 28, 157–163 (2012)
Gencel O., Bozkurt A., Kam E., Korkut T.: Determination and calculation of gamma and neutron shielding characteristics of concretes containing different hematite proportions. Ann. Nucl. Energy 38, 2719–2723 (2011)
Rezaei-Ochbelagh D., Azimkhani S., Gasemzadeh Mosavinejad H.: Shielding and strength tests of silica fume concrete. Ann. Nucl. Energy 45, 150–154 (2012)
Mindess, S.; Young, J.F.: Concrete, pp. 596–599. Prentice-Hall, Englewood Cliffs, NJ (1981)
Neville A.M.: Properties of Concrete, pp. 844. Wiley, New York (1997)
RILEM Technical Committee 50-FMC.: Draft Recommendation Determination of the fracture energy of mortar and concrete by means three point bend test on notched beams. Mater. Struct. 18(4), 287–290(1985)
Richard P., Cheyrezy M.H.: Reactive powder concrete. Cem. Concr. Res. 25(7), 1501–1511 (1995)
Taşdemir C., Taşdemir M.A., Mills N., Barr B.I.G., Lydon F.D.: Combined effects of silica fume, aggregate type, and size on the post-peak response of concrete in bending. ACI Mater. J. 96(I), 1–10 (1999)
Taşdemir C., Taşdemir M.A., Lydon F.D., Barr B.I.G.: Effects of silica fume and aggregate size on the brittleness of concrete. Cem. Concr. Res. 26(1), 63–68 (1996)
Berger, M.J.; Hubbell, J.H.; Seltzer, S.M.; Chang, J.; Coursey, J.S.; Sukumar, R.; Zucker, D.S.; Olsen, K.: XCOM: photon cross section database (version 1.5). [Online]. http://physics.nist.gov/xcom. National Institute of Standards and Technology, Gaithersburg, MD (2010)
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Özen, S., Şengül, C., Erenoğlu, T. et al. Properties of Heavyweight Concrete for Structural and Radiation Shielding Purposes. Arab J Sci Eng 41, 1573–1584 (2016). https://doi.org/10.1007/s13369-015-1868-6
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s13369-015-1868-6