Skip to main content
Log in

Determination of antimony and barium in UK air quality samples as indicators of non-exhaust traffic emissions

  • Published:
Environmental Monitoring and Assessment Aims and scope Submit manuscript

Abstract

The aim of this study was to determine concentrations of antimony and barium in air quality samples and assess the potential suitability of these metals as tracer elements for non-exhaust traffic emissions sources. Air quality filters sampled at monitoring sites around the UK for the purposes of the UK Heavy Metals Monitoring Network were subjected to microwave digestion in hydrogen peroxide and nitric acid, then analysed by ICP-MS for a suite of metals including antimony and barium. The average antimony concentration found across all the network sites was 1.84 ng m−3; the average barium concentration was 6.33 ng m−3. The range of antimony concentrations observed was 0.13–8.02 ng m−3; barium concentrations ranged from levels below the detection limit of 0.18 to 39.9 ng m−3. There are no legislative limits for antimony and barium in ambient air, but the maximum concentrations found are well below the Workplace Exposure Limits specified by the UK Health and Safety Executive. The highest concentrations were found at roadside sites situated to monitor traffic environments, supporting the suitability of antimony and barium to be considered tracer elements for traffic emissions sources. Strong correlations were observed between antimony, barium and copper, indicating they share a common traffic-related source. Based on the strong correlation with copper at urban and traffic locations, indicative annual UK atmospheric emission estimates for antimony and barium in brake and tyre wear were calculated as 6 and 19 tonnes respectively.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Fig. 1
Fig. 2
Fig. 3

Similar content being viewed by others

References

  • Agency for Toxic Substances and Disease Registry (ATSDR). (2007). Toxicological Profile for Barium and Barium Compounds.

  • Agency for Toxic Substances and Disease Registry (ATSDR). (2017). Toxicological Profile for Antimony and Compounds: Draft for Public Comment.

  • Agilent Technologies Inc. (2011). Enhanced Helium Mode Cell Performance for Improved Interference Removal in ICP-MS.

  • Air Quality Strategy for England, Scotland, Wales and Northern Ireland. (2007). Cmd paper No 7169 NIA 61/06-07.

  • Birmili, W., Allen, A. G., Bary, F., & Harrison, R. M. (2006). Trace metal concentrations and water solubility in size-fractionated atmospheric particles and influence of road traffic. Environmental Science & Technology, 40, 1144–1153.

    Article  CAS  Google Scholar 

  • Brown, R. J. C. (2010). Comparison of estimated annual emissions and measured annual ambient concentrations of metals in the UK 1980–2007. Journal of Environmental Monitoring, 12, 665–671.

    Article  CAS  Google Scholar 

  • Brown, R. J. C., Yardley, R. E., Muhunthan, D., Butterfield, D. M., Williams, M., Woods, P. T., Brown, A. S., & Goddard, S. L. (2008). Twenty-five years of nationwide ambient metals measurement in the United Kingdom: concentration levels and trends. Environmental Monitoring and Assessment, 142, 127–140.

    Article  CAS  Google Scholar 

  • Brunekreef, B., & Forsberg, B. (2005). Epidemiological evidence of effects of coarse airborne particles on health. The European Respiratory Journal, 26, 309–318.

    Article  CAS  Google Scholar 

  • BS EN 12341. (2014). Ambient air - Standard gravimetric measurement method for the determination of the PM 10 or PM 2,5 mass concentration of suspended particulate matter. European Committee for Standardization (CEN).

  • BS EN 14902. (2005). Ambient air quality - Standard method for the measurement of Pb, Cd, As and Ni in the PM10 fraction of suspended particulate matter. European Committee for Standardization (CEN).

  • Carslaw, D. (2013). The openair manual open-source tools for analysing air pollution data. London: King’s College.

    Google Scholar 

  • Centre for Ecology & Hydrology, National Environment Research Council. (2012). Heavy Metal Deposition Mapping: Concentrations and Deposition of Heavy Metals in Rural Areas of the UK. Defra.

  • Dams, R., & de Jonge, J. (1976). Chemical composition of Swiss aerosols from the Jungfraujoch. Atmospheric Environment, 10, 1079–1084.

    Article  CAS  Google Scholar 

  • Defra UK-AIR website (2019). Monitoring Site Search tool: https://uk-air.defra.gov.uk/networks/find-sites (last accessed 12 Aug 2019)

  • European Commission. (2005). Council Directive 2004/107/EC of the European Parliament and of the Council of 15 December 2004 relating to arsenic, cadmium, mercury, nickel and polycyclic aromatic hydrocarbons in ambient air. Official Journal of the European Union, L023_3, 3–16.

    Google Scholar 

  • European Commission. (2008). Council Directive 2008/50/EC of the European Parliament and of the Council of 21 May 2008 on ambient air quality and cleaner air for Europe. Official Journal of the European Union, L152_1, 1–44.

    Google Scholar 

  • Garg, B. D., Cadle, S. H., Mulawa, P. A., & Groblicki, P. J. (2000). Brake wear particulate matter emissions. Environmental Science & Technology, 34, 4463–4469.

    Article  CAS  Google Scholar 

  • Gietl, J. K., Lawrence, R., Thorpe, A. J., & Harrison, R. M. (2010). Identification of brake wear particles and derivation of a quantitative tracer for brake dust at a major road. Atmospheric Environment, 44(2010), 141–146.

    Article  CAS  Google Scholar 

  • Goddard, S. L., Brown, R. J. C., Butterfield, D. M., McGhee, E. A., Robins, C., Brown, A., Beccaceci, S., Lilley, A., Bradshaw, C., & Brennan, S. (2015). Annual Report for 2014 on the UK Heavy Metals Monitoring Network. Teddington: Queen’s Printer and Controller of HMSO.

    Google Scholar 

  • Grigoratos, T., & Martini, G. (2015). Brake wear particle emissions: a review. Environmental Science and Pollution Research, 22, 2491–2504.

    Article  CAS  Google Scholar 

  • Harrison, R. M., Yin, J., Mark, D., Stedman, J., Appleby, R. S., Booker, J., & Moorcroft, S. (2001) Studies of the coarse particle (2.5 − 10 μm) component in UK urban atmospheres. Atmos Environ, 35, 3667–3679.

  • Harrison, R. M., Jones, A. M., Gietl, J., Yin, J., & Green, D. C. (2012). Estimation of the contributions of brake dust, tire wear, and resuspension to nonexhaust traffic particles derived from atmospheric measurements. Environmental Science & Technology, 46, 6523–6529.

    Article  CAS  Google Scholar 

  • Health and Safety Executive. (2018). EH40/2005 Workplace exposure limits: containing the list of workplace exposure limits for use with the Control of Substances Hazardous to Health Regulations 2002 (as amended), 3rd edition.

  • Hurtig, H. W. (1990). Die Immisionsbelastung von Böden durch Antimon. [Exposure of soils to antimony.]. VDI-Berichte, 837, 91–102.

    Google Scholar 

  • Inorganic Ventures. (2018). https://www.inorganicventures.com/element/antimony (last accessed 2 Nov 2018)

  • National Atmospheric Emissions Inventory. (2018). http://naei.beis.gov.uk/data/ (last accessed 2 Nov 2018)

  • Scanmetals UK Limited. (2017). Proposed change of use and associated development: former Brookside Metal Works, Bilston Lane, Willenhall. GVA Grimley Limited.

  • Schauer, J. J., et al. (2006). Research Report 133: Characterization of metals emitted from motor vehicles. Boston: Health Effects Institute.

    Google Scholar 

  • Smith, I. M. (2010). NPL Report MS 11, Software for determining polynomial calibration functions by generalised least squares: user manual. Teddington: NPL.

    Google Scholar 

  • Tabor, E. C., & Warren, W. V. (1958). Distribution of certain metals in the atmosphere of some American cities. A.M.A. Archives of Industrial Health, 17, 145–151.

    CAS  Google Scholar 

  • US Environmental Protection Agency (EPA). (1984). Health effects assessment for barium. Washington, DC: U.S. Environmental Protection Agency, Office of Solid Waste and Emergency Response. EPA540186021.

    Google Scholar 

  • US Environmental Protection Agency (EPA). (2015). Air quality system (AQS). Data files. Annual summary data. U.S. Environmental Protection Agency.

  • World Health Organization (WHO) 2003. Antimony in drinking-water: background document for development of WHO Guidelines for Drinking-water Quality.

    Google Scholar 

  • Xing, Y., Xu, Y., Shi, M., & Lian, Y. (2016). The impact of PM2.5 on the human respiratory system. Journal of Thoracic Disease, 8(1), E69–E74.

    Google Scholar 

Download references

Funding

This study is funded by the Environment Agency, the UK Department for Environment, Food and Rural Affairs, and the UK Department for Business, Energy and Industrial Strategy.

Author information

Authors and Affiliations

Authors

Corresponding author

Correspondence to S. L. Goddard.

Ethics declarations

Conflict of interest

The authors declare that they have no conflict of interest.

Additional information

Publisher’s note

Springer Nature remains neutral with regard to jurisdictional claims in published maps and institutional affiliations.

Electronic supplementary material

ESM 1

(PDF 145 kb)

ESM 2

(DOCX 131 kb)

ESM 3

(DOCX 18 kb)

Rights and permissions

Reprints and permissions

About this article

Check for updates. Verify currency and authenticity via CrossMark

Cite this article

Goddard, S.L., Williams, K.R., Robins, C. et al. Determination of antimony and barium in UK air quality samples as indicators of non-exhaust traffic emissions. Environ Monit Assess 191, 641 (2019). https://doi.org/10.1007/s10661-019-7774-8

Download citation

  • Received:

  • Accepted:

  • Published:

  • DOI: https://doi.org/10.1007/s10661-019-7774-8

Keywords

Navigation