During diabatic rectification, the internal flows of the mixture being separated change along the column height due to heat exchangers placed on plates through which the heat carrier circulates. The authors of the article propose a scheme for implementing diabatic rectification with integrated coil reflux exchangers in a poppet column and present a mathematical description of the process of heat removal from them during condensation of ascending vapors of ethyl alcohol–water mixture under separation on the coil pipes. The thermal power of the built-in reflux exchanger is determined by considering the influence of thermophysical properties and the location of the coils. An increase in the coolant’s temperature at the outlet of the coil deflector leads to a decrease in thermal power. All other conditions being equal, the largest amount of thermal power falls on the lower plates of the column. The values of the average heat transfer coefficient during condensation of liquid vapors increase with an increase in the coolant’s temperature (water) at the outlet of the reflux exchanger, however, the linear heat transfer coefficient decreases. To increase the thermal capacity of the reflux exchangers (and, consequently, the efficiency of separation of liquid mixtures) it is advisable to use various methods of intensifying heat exchange from the outside of the pipes.,
Similar content being viewed by others
References
Z. Fonyo, “Thermodynamic analysis of rectification,” International Chemical Engineering, (Part I, “Reversible model of rectification,” 14, No. 1, 18–27 (1974); Part II, “Finite cascade models,” 14, No. 2, 203–210 (1974).
G. Koeijer, A. Røsjorde, and S. Kjelstrup, “Distribution of heat exchange in optimum diabatic distillation columns,” Energy, 29, No. 12-15, 2425–2440 (2004).
J. R. Alcántara-Avila, K.-I. Sotowa, and T. Horikawa, “Entropy production and economic analysis in diabatic distillation columns with heat exchangers in series,” Energy, 93, Part 2, 1719–1730 (2015).
G. N. Mello, R. Battisti, N.S. Urruth, et al., “New distributed-action control strategy with simultaneous heating and cooling in trays of a pilot-scale diabatic distillation column,” Chemical Engineering Research and Design, 159, 424–438 (2020).
G. Koeijer and R. Rivero, “Entropy production and exergy loss in experimental distillation columns,” Chemical Engineering Science, 58, No. 8, 1587–1597 (2003).
I. N. Björn, U. Grén, and A. P. Soermardji, “Diabatic distillation − comments on the influence of side streams,” Computer Aided Chemical Engineering, 20, 511–516 (2005).
N. A. Voinov, D. A. Zemtsov, A. V. Bogatkova, et al., “Intensification of heat exchange in diabatic rectification columns,” Khim. Rastiteln. Syriya, No. 4, 511–518 (2020).
I. N. Björn, U. Grén, and F. Svensson, “Simulation and experimental study of intermediate heat exchange in a sieve tray distillation column,” Computers & Chemical Engineering, 26, No. 4-5, 499–505 (2002).
T. R. Andersen, G. Siragusa, B. Andresen, et al., “Energy efficient distillation by optimal distribution of heating and cooling requirements,” European Symposium on Computer Aided Process Engineering, 10, 709-714 (2000).
I. N. Madyshev, O. S. Dmitrieva, A. O. Mayasova, and A. N. Nikolaev, “Increasing efficiency of contact devices of column masstransfer apparatuses when using thermal rectification processes,” Khim. Neftegaz. Mashinostr., No. 4, 3–6 (2022).
K. F. Pavlov, P. G. Romankov, and А. А. Noskov, Examples and Tasks for the Course of Chemical Engineering Processes and Apparatuses [in Russian], Khimiya, Leningrad (1987), p. 560.
G. M. Mikhailov, V. G. Mikhailov, L. A. Kondakova, and L. S. Reva, “Determination of the coefficient of convective heat transfer in a transient pipe flow at high Grashof numbers,” Theoretical Foundations of Chemical Engineering, 41, No. 4, 414–416 (2007).
Author information
Authors and Affiliations
Corresponding author
Additional information
Translated from Khimicheskoe i Neftegazovoe Mashinostroenie, Vol. 58, No. 7, pp. 3−6, July, 2022.
Rights and permissions
Springer Nature or its licensor (e.g. a society or other partner) holds exclusive rights to this article under a publishing agreement with the author(s) or other rightsholder(s); author self-archiving of the accepted manuscript version of this article is solely governed by the terms of such publishing agreement and applicable law.
About this article
Cite this article
Madyshev, I.N., Dmitrieva, O.S., Mayasova, A.O. et al. Determination of Heat Flows in Built-in Column Reflux Exchangers During Diabatic Rectification. Chem Petrol Eng 58, 537–544 (2022). https://doi.org/10.1007/s10556-023-01126-3
Published:
Issue Date:
DOI: https://doi.org/10.1007/s10556-023-01126-3