Encyclopedia of Engineering Geology

2018 Edition
| Editors: Peter T. Bobrowsky, Brian Marker

Crushed Rock

  • Brian R. MarkerEmail author
Reference work entry
DOI: https://doi.org/10.1007/978-3-319-73568-9_73

Definition

Hard natural rock reduced to fragments by mechanical crushing or breaking. (Preparation of ore minerals also requires crushing but that is to secure crushed mineral rather than crushed rock and is not within this definition.)

Synonyms

Crushed stone

Introduction

Hard rock is mechanically crushed or broken mainly for construction aggregates and fill. Sources are primarily limestone, dolomite, sandstone, and igneous rock but sometimes quartzite and metamorphic rocks such as marble and granulite. Sources are widespread where bedrock is at or near the surface and is not significantly weathered or hydrothermally altered. Mineralogical composition, grain size, grain sorting, cementation, compaction, porosity, and weathering state directly affect potential uses. Selection depends on a variety of physical and chemical tests.

Crushing and Grading

Large blocks brought directly from the quarry blast pile are reduced to a few tens of centimeters or less, in primary crushers then further...
This is a preview of subscription content, log in to check access.

References

  1. Kazi A, Al-Mansour ZR (1980) Influence of geological factors on abrasion and soundness characteristics of aggregates. Eng Geol 15(3–4):195–203.  https://doi.org/10.1016/0013-7952(80)90034-4CrossRefGoogle Scholar
  2. Rooney LF, Carr DD (1971) Applied geology of industrial limestone and dolomite, vol 46. Indiana Geological Survey Bulletin, Bloomington. http://hdl.handle.net/2022/230
  3. Smith MR, Collis L (2001) Aggregates: sand, gravel and crushed rock aggregates for construction purposes, vol 17, 3rd edn. Geological Society Engineering Geology Special Publication, LondonGoogle Scholar

Copyright information

© Springer International Publishing AG, part of Springer Nature 2018

Authors and Affiliations

  1. 1.LondonUK