Rolling is one of the most important primary material manufacturing processes due to the huge volume of flat rolled metals required by both the civilian and military sectors. Friction control between the workpiece and the rolls is essential to draw the workpiece into the roll bite (see Fig.
1) and transmit proper force to plastically deform the workpiece.
This is a preview of subscription content, log in to check access.
References
A.K.E.H. El-Kalay, L.G.M. Sparling, Factors affecting friction and their effect upon load, torque and spread in hot, flat rolling. J. Iron Steel Inst. 206, 152–163 (1968)Google Scholar
Y. Kimura, T.H.C. Childs, Surface asperity deformation under bulk plastic straining conditions. Int. J. Mech. Sci. 41, 283–307 (1999)MATHCrossRefGoogle Scholar
J.G. Lenard, Tribology in metal rolling. Keynote presentation forming group F. CIRP Ann. Manuf. Technol. 49(2), 567–590 (2000)CrossRefGoogle Scholar
J.G. Lenard, Z. Malinowski, Measurements of friction during the warm rolling of aluminum. J. Mat. Process. Technol. 39, 357–371 (1993)CrossRefGoogle Scholar
P.A. Munther, J.G. Lenard, A study of friction during hot rolling of steels. Scand. J. Metall. 26, 231–240 (1997)Google Scholar
M. Plancak, A.N. Bramley, F.H. Osman, Some observation on contact stress measurement by pin load cell in bulk metal forming. J. Mater. Process. Technol. 60, 339–342 (1996)CrossRefGoogle Scholar
W.L. Roberts, Hot Rolling of Steel (Marcel Dekker, New York, 1983)Google Scholar
W.L. Roberts, Flat Processing of Steel (Marcel Dekker, New York, 1988)Google Scholar
J.A. Schey, Tribology in Metalworking: Friction, Lubrication and Wear (American Society for Metals, Metal Park, 1983). 44073Google Scholar
W.R.D. Wilson, S. Sheu, Real area of contact and boundary friction in metal forming. Int. J. Mech. Sci. 30, 475–489 (1988)CrossRefGoogle Scholar
