1. Editorial PIAM October 2020

   • Eujin Pei

   Editorial 09 November 2020 Pages: 315 - 315

2. Standardisation efforts of ISO/TC 261 “Additive Manufacturing”: Reports from 14th and 15th Plenary Meeting

   • Eujin Pei

   Short Communication Open access 20 July 2020 Pages: 317 - 318

3. A comprehensive review: metrology in additive manufacturing and 3D printing technology

   • Hitesh D. Vora
   • Subrata Sanyal

   Review Article 09 July 2020 Pages: 319 - 353

   

4. Effective elastic properties of additively manufactured metallic cellular structures using numerical unit-cell homogenization

   • Okanmisope Fashanu
   • David Murphy
   • John Porter

   Full Research Article 20 June 2020 Pages: 355 - 366

   

5. Monitoring and detection of meltpool and spatter regions in laser powder bed fusion of super alloy Inconel 625

   • Lihang Yang
   • Lydia Lo
   • Tuğrul Özel

   Full Research Article 19 June 2020 Pages: 367 - 378

   

6. Effect of heat treatment time on the microstructure and mechanical deformation behavior of additive-manufactured AlSi10Mg components

   • Velaphi Jeffrey Matjeke
   • Collin Moopanar
   • Josias Willem van der Merwe

   Full Research Article 13 June 2020 Pages: 379 - 385

   

7. Spherical slicing method and its application on robotic additive manufacturing

   • Ismail Enes Yigit
   • I. Lazoglu

   Full Research Article 08 May 2020 Pages: 387 - 394

   

8. Gold plating of AlSi10Mg parts produced by a laser powder-bed fusion additive manufacturing technique

   • Alexandra Inberg
   • Dana Ashkenazi
   • Adin Stern

   Full Research Article 25 April 2020 Pages: 395 - 404

   

9. Process gas influence on microstructure and mechanical behavior of Inconel 718 fabricated via selective laser melting

   • Glenn E. Bean
   • David B. Witkin
   • Rafael J. Zaldivar

   Full Research Article 18 April 2020 Pages: 405 - 417

   

10. Correction to: Effect of process parameters on surface roughness of hybrid investment casting

    • Parlad Kumar
    • Inderpreet S. Ahuja
    • Rupinder Singh

    Correction 04 May 2020 Pages: 419 - 419

11. Correction to: The influence of stiffener geometry on flexural properties of 3D-printed polylactic acid (PLA) beams

    • Silas Z. Gebrehiwot
    • Leonardo Espinosa-Leal
    • L. Rechenberg

    Correction 02 September 2020 Pages: 421 - 421