1. Forming limit prediction of AA7075-T6 sheet based on ductile fracture criterion and the error analysis of parameters calibration

   • Zhuoyun Yang
   • Changcai Zhao
   • Xiangdong Jia

   Original Research 14 January 2020 Pages: 341 - 359

   

2. On the selection of an empirical material constitutive model for the finite element modeling of Ti6Al4V orthogonal cutting, including the segmented chip formation

   • F. Ducobu
   • P.-J. Arrazola
   • E. Filippi

   Original Research 29 January 2020 Pages: 361 - 374

   

3. Experimental characterisation on the behaviour of PLLA for stretch blowing moulding of bioresorbable vascular scaffolds

   • Huidong Wei
   • Gary Menary
   • James Nixon

   Original Research Open access 17 January 2020 Pages: 375 - 389

   

4. Formability prediction of Ti6Al4V titanium alloy sheet deformed at room temperature and 600 °C

   • José Divo Bressan
   • Qiaoling Wang
   • Stefania Bruschi

   Original Research 27 February 2020 Pages: 391 - 405

   

5. Effect of single and multiple parts manufacturing on temperature-induced residual stress problems in SLM

   • Nihat Yılmaz
   • Mevlut Yunus Kayacan

   Original Research 13 May 2020 Pages: 407 - 419

   

6. A preform deformation and resin flow coupled model including the cure kinetics and chemo-rheology for the VARTM process

   • Da Wu
   • Ragnar Larsson
   • Brina Blinzler

   Original Research Open access 01 July 2020 Pages: 421 - 434

   

7. Effect of tension-compression testing strategy on kinematic model calibration and springback simulation of advanced high strength steels

   • Junying Min
   • Nan Guo
   • Jianping Lin

   Original Research 13 August 2020 Pages: 435 - 448

   

8. Warm forming simulations of Al-Mg alloy sheet using a viscoplastic model and advanced yield functions

   • Qing Zhang
   • Yong Zhang
   • Dateng Zheng

   Original Research 23 October 2020 Pages: 449 - 465

   

9. A comparison study of the yield surface exponent of the Barlat yield function on the forming limit curve prediction of zirconium alloys with M-K method

   • Congyi Lei
   • Jianzhong Mao
   • Ding Chen

   Original Research 03 February 2021 Pages: 467 - 484

   

10. Pre-stress state in cork agglomerates: simulation of the compression moulding process

    • Marco Delucia
    • Anita Catapano
    • Jérôme Pailhès

    Original Research 08 April 2021 Pages: 485 - 498