Microstructures, mechanical properties, and electrical resistivity of rapidly quenched Fe-Cr-Al alloys T. NaoharaA. InoueK. Kumada OriginalPaper Pages: 337 - 343
Effect of composition and high energy rate forging on the onset of precipitation in an iron-base superalloy T. J. HeadleyM. M. KarnowskyW. R. Sorenson OriginalPaper Pages: 345 - 353
Enhanced densification of white cast iron powders by cyclic phase transformations under stress Oscar A. RuanoJeffrey WadsworthOleg D. Sherby OriginalPaper Pages: 355 - 361
Welding, Glazing, and Heat Treating —A dimensional analysis of heat flow Sindo Kou OriginalPaper Pages: 363 - 371
Mechanical properties of Fe-Si-B amorphous wires produced by in-rotating-water spinning method M. HagiwaraA. InoueT. Masumoto OriginalPaper Pages: 373 - 382
Low temperature strain behavior of Pb thin films on a substrate T. S. KuanM. Murakami OriginalPaper Pages: 383 - 391
Fatigue crack initiation and propagation in a quenched and tempered niobium bearing HSLA steel S. I. KwunR. A. Fournelle OriginalPaper Pages: 393 - 399
Microstructure-property relationships of two AI-3Li-2Cu-0.2Zr-XCd alloys F. S. LinS. B. ChakraborttyE. A. Starke OriginalPaper Pages: 401 - 410
The influence of microstructure and strength on the fracture mode and toughness of 7XXX series aluminum alloys Gerard M. LudtkaDavid E. Laughlin OriginalPaper Pages: 411 - 425
A numerical study of cavity growth controlled by coupled surface and grain boundary diffusion L. MartinezW. D. Nix OriginalPaper Pages: 427 - 437
The influence of a duplex microstructure in steels on fatigue crack growth in the near-threshold region K. MinakawaY. MatsuoA. J. McEVILY OriginalPaper Pages: 439 - 445
The influence of substructure on the elevated and room temperature strength of a 26 Cr-1 Mo ferritic stainless steel Charles G. SchmidtConrad M. YoungOleg D. Sherby OriginalPaper Pages: 447 - 456
The mechanisms of crack initiation and crack propagation in metal-induced embrittlement of metals Paul GordonHenry H. An OriginalPaper Pages: 457 - 472
Oxidation behavior of a fine-grained rapidly solidified 18-8 stainless steel G. J. YurekD. EisenA. Garratt-Reed OriginalPaper Pages: 473 - 485
Surface wave studies of hydrogen damage incubation time Andrzej ZielinskiNicholas F. Fiore OriginalPaper Pages: 487 - 491
The occurrence of aligned microstructures in directionally solidified aluminum-bismuth alloys R. N. GrugelA. Hellawell Communication Pages: 493 - 495
Experimental and theoretical concentration profiles at the surface of chromized iron S. K. GuptaS. R. AdolphL. L. Seigle Communication Pages: 495 - 497
Temperature dependence of sustained-load subcritical crack growth in Ti-6AI-6V-2Sn R. J. LederichS. M. L. SastryP. S. Pao Communication Pages: 497 - 500