1. Phase-transition kinetics of formation of β-Fe₅Ge₃ in isothermal sintering

   • D. Eliezer
   • S. F. Dirnfeld
   • S. Nadiv

   OriginalPaper Pages: 679 - 683

2. Structural characteristics of Nb₃Sn produced by three P/M techniques

   • Deepak Kapoor
   • Roger N. Wright

   OriginalPaper Pages: 685 - 692

3. An analytical electron microscopy study of the high temperature carbide formed in a V-5 Ti-C alloy

   • S. M. Bruemmer
   • C. P. Fluhr
   • H. L. Fraser

   OriginalPaper Pages: 693 - 699

4. Phase changes in fatigued ball bearings

   • Ragnar Österlund
   • Olof Vingsbo

   OriginalPaper Pages: 701 - 707

5. The niobium (columbium)-palladium constitution diagram

   • B. C. Giessen
   • N. J. Grant
   • R. M.Waterstrat

   OriginalPaper Pages: 709 - 715

6. Ferritic-austenitic solidification mode in austenitic stainless steel welds

   • N. Suutala
   • T. Takalo
   • T. Moisio

   OriginalPaper Pages: 717 - 725

7. The oxidation of ordered Zr₃Al

   • E. M. Schulson
   • T. P. Trottier

   OriginalPaper Pages: 727 - 738

8. Carbide reactions (M₃C→M₇C₃→M₂₃C₆→M₆C) during tempering of rapidly solidified high carbon Cr-W and Cr-Mo steels

   • A. Inoue
   • T. Masumoto

   OriginalPaper Pages: 739 - 747

9. Inhomogeneity of rolling texture in fcc metals

   • W. Truszkowski
   • J. Kr’ol
   • B. Major

   OriginalPaper Pages: 749 - 758

10. Dimensional changes in heat treating aluminum alloys

    • H. Y. Hunsicker

    OriginalPaper Pages: 759 - 773

11. Tritium permeation through clean incoloy 800 and sanicro 31 alloys and through steam oxidized incoloy 800

    • J. T. Bell
    • J. D. Redman
    • H. P. Bittner

    OriginalPaper Pages: 775 - 782

12. Analysis of oxide coatings on steam-oxidized incoloy 800

    • H. F. Bittner
    • J. T. Bell
    • R. E. Eby

    OriginalPaper Pages: 783 - 790

13. Influence of carbon content and ferrite morphology on the sensitization of duplex stainless steel

    • T. M. Devine

    OriginalPaper Pages: 791 - 800

14. An adsorption study of hydrogen on iron and its relation to hydrogen embrittlement

    • C. M. Ransom
    • P. J. Ficalora

    OriginalPaper Pages: 801 - 807

15. The propagation of transgranular stress-corrosion cracks in admiralty metal

    • J. A. Beavers
    • E. N. Pugh

    OriginalPaper Pages: 809 - 820

16. Effect of cathodic potential on corrosion fatigue crack growth rates of a Ni-Cr-Mo-V turbine disc steel in room temperature caustic environment

    • R. Rungta
    • J. A. Begley

    OriginalPaper Pages: 821 - 830

17. Evaluation of (residual) stresses in textured cubic metals

    • H. Dölle
    • J. B. Cohen

    OriginalPaper Pages: 831 - 836

18. Titanium alloy fatigue fracture facet investigation by selected area electron channeling

    • D. L. Davidson
    • D. Eylon

    OriginalPaper Pages: 837 - 843

19. Effect of oxidation on the toughness and strength of the co, Cr-(Cr,Co)₇C₃ In-Situ composite

    • M. H. Abdel Latif
    • A. Lawley

    Communications Pages: 845 - 846

20. Evidence for crack-arrest markings on intergranular stress corrosion fracture surfaces in Al-Zn-Mg alloys

    • G. M. Scamans

    Communications Pages: 846 - 850

21. Statistical aspects of fatigue crack nucleation from particles

    • W. L Morris
    • M. R. James

    Communications Pages: 850 - 851

22. On the law of mixtures in dual-phase steels

    • J. Y. Koo
    • M. J. Young
    • G. Thomas

    Communications Pages: 852 - 854

23. Humidity-induced hydrogen embrittlement in an Fe-Cr-Co magnet alloy

    • S. Jin
    • N. V. Gayle
    • C. Ghilarducci

    Communications Pages: 854 - 856

24. Erratum to: Iterative solutions for one-dimensional diffusion with time varying surface composition and composition-dependent diffusion coefficient

    • M. Chow
    • C. R. Houska

    Erratum Pages: 856 - 856