1. Microstructures, mechanical properties, and electrical resistivity of rapidly quenched Fe-Cr-Al alloys

   • T. Naohara
   • A. Inoue
   • K. Kumada

   OriginalPaper Pages: 337 - 343

2. Effect of composition and high energy rate forging on the onset of precipitation in an iron-base superalloy

   • T. J. Headley
   • M. M. Karnowsky
   • W. R. Sorenson

   OriginalPaper Pages: 345 - 353

3. Enhanced densification of white cast iron powders by cyclic phase transformations under stress

   • Oscar A. Ruano
   • Jeffrey Wadsworth
   • Oleg D. Sherby

   OriginalPaper Pages: 355 - 361

4. Welding, Glazing, and Heat Treating —A dimensional analysis of heat flow

   • Sindo Kou

   OriginalPaper Pages: 363 - 371

5. Mechanical properties of Fe-Si-B amorphous wires produced by in-rotating-water spinning method

   • M. Hagiwara
   • A. Inoue
   • T. Masumoto

   OriginalPaper Pages: 373 - 382

6. Low temperature strain behavior of Pb thin films on a substrate

   • T. S. Kuan
   • M. Murakami

   OriginalPaper Pages: 383 - 391

7. Fatigue crack initiation and propagation in a quenched and tempered niobium bearing HSLA steel

   • S. I. Kwun
   • R. A. Fournelle

   OriginalPaper Pages: 393 - 399

8. Microstructure-property relationships of two AI-3Li-2Cu-0.2Zr-XCd alloys

   • F. S. Lin
   • S. B. Chakrabortty
   • E. A. Starke

   OriginalPaper Pages: 401 - 410

9. The influence of microstructure and strength on the fracture mode and toughness of 7XXX series aluminum alloys

   • Gerard M. Ludtka
   • David E. Laughlin

   OriginalPaper Pages: 411 - 425

10. A numerical study of cavity growth controlled by coupled surface and grain boundary diffusion

    • L. Martinez
    • W. D. Nix

    OriginalPaper Pages: 427 - 437

11. The influence of a duplex microstructure in steels on fatigue crack growth in the near-threshold region

    • K. Minakawa
    • Y. Matsuo
    • A. J. McEVILY

    OriginalPaper Pages: 439 - 445

12. The influence of substructure on the elevated and room temperature strength of a 26 Cr-1 Mo ferritic stainless steel

    • Charles G. Schmidt
    • Conrad M. Young
    • Oleg D. Sherby

    OriginalPaper Pages: 447 - 456

13. The mechanisms of crack initiation and crack propagation in metal-induced embrittlement of metals

    • Paul Gordon
    • Henry H. An

    OriginalPaper Pages: 457 - 472

14. Oxidation behavior of a fine-grained rapidly solidified 18-8 stainless steel

    • G. J. Yurek
    • D. Eisen
    • A. Garratt-Reed

    OriginalPaper Pages: 473 - 485

15. Surface wave studies of hydrogen damage incubation time

    • Andrzej Zielinski
    • Nicholas F. Fiore

    OriginalPaper Pages: 487 - 491

16. The occurrence of aligned microstructures in directionally solidified aluminum-bismuth alloys

    • R. N. Grugel
    • A. Hellawell

    Communication Pages: 493 - 495

17. Experimental and theoretical concentration profiles at the surface of chromized iron

    • S. K. Gupta
    • S. R. Adolph
    • L. L. Seigle

    Communication Pages: 495 - 497

18. Temperature dependence of sustained-load subcritical crack growth in Ti-6AI-6V-2Sn

    • R. J. Lederich
    • S. M. L. Sastry
    • P. S. Pao

    Communication Pages: 497 - 500