1. Computerized data bank “Strength of Materials”

   • V. T. Troshchenko
   • P. P. Lepikhin
   • Yu. N. Babich

   Scientific and Technical Section 03 June 2009 Pages: 235 - 242

2. On diffusion creep of polycrystals

   • V. T. Golovchan

   OriginalPaper 03 June 2009 Pages: 243 - 250

3. Redistribution of stresses in the header–PGV-1000 steam generator connector weldment under loading after thermal treatment

   • V. V. Kharchenko
   • G. V. Stepanov
   • V. A. Piminov

   OriginalPaper 03 June 2009 Pages: 251 - 256

4. Experimental analysis of behavior and damage of sandwich composite materials in three-point bending. Part 2. Fatigue test results and damage mechanisms

   • A. Bezazi
   • A. El Mahi
   • B. Bezzazi

   OriginalPaper 03 June 2009 Pages: 257 - 267

5. Generalized relative characteristics of limiting states of material under nonisothermal deformation

   • B. S. Karpinos

   OriginalPaper 03 June 2009 Pages: 268 - 277

6. Analysis of the stressed state of a circular thin-walled cylinder under complex loading and with nonlinear hardening of the material

   • I. V. Khromov

   OriginalPaper 03 June 2009 Pages: 278 - 284

7. Influence of the modes of operation and structural factors on the crack propagation in 12Cr–2Ni–Mo steel

   • V. V. Pokrovskii
   • V. N. Ezhov
   • V. S. Zamotaev

   OriginalPaper 04 June 2009 Pages: 285 - 293

8. Strength characteristics of Mg–Li alloys

   • D. Regenera
   • V. Tkachenko

   OriginalPaper 03 June 2009 Pages: 294 - 302

9. Pulse current treatment effect on the strength of reinforcing steel and its weld joint under impact loading

   • L. Kruszka
   • G. V. Stepanov
   • A. I. Babutskii

   OriginalPaper 04 June 2009 Pages: 303 - 309

10. Forced oscillations of beam with essentially nonlinear absorber

    • K. V. Avramov
    • O. V. Gendelman

    OriginalPaper 04 June 2009 Pages: 310 - 317

11. Analysis of the influence of the level of residual stresses on the ultimate stresses in a cycle for welded structures according to the results of testing of small-size specimens

    • V. A. Degtyarev

    OriginalPaper 03 June 2009 Pages: 318 - 324

12. Procedure for the determination of torsional deformation relationships for anisotropic materials

    • V. S. Dzyuba
    • L. V. Kravchuk

    OriginalPaper 03 June 2009 Pages: 325 - 331

13. Inelasticity monitoring of structural materials by the resonance method

    • A. N. Mailo

    Production Section 03 June 2009 Pages: 332 - 338

14. A study of stress concentration zones under cyclic loading by thermal imaging method

    • I. T. Mirsayapov

    OriginalPaper 03 June 2009 Pages: 339 - 344