Computerized data bank “Strength of Materials” V. T. TroshchenkoP. P. LepikhinYu. N. Babich Scientific and Technical Section 03 June 2009 Pages: 235 - 242
Redistribution of stresses in the header–PGV-1000 steam generator connector weldment under loading after thermal treatment V. V. KharchenkoG. V. StepanovV. A. Piminov OriginalPaper 03 June 2009 Pages: 251 - 256
Experimental analysis of behavior and damage of sandwich composite materials in three-point bending. Part 2. Fatigue test results and damage mechanisms A. BezaziA. El MahiB. Bezzazi OriginalPaper 03 June 2009 Pages: 257 - 267
Generalized relative characteristics of limiting states of material under nonisothermal deformation B. S. Karpinos OriginalPaper 03 June 2009 Pages: 268 - 277
Analysis of the stressed state of a circular thin-walled cylinder under complex loading and with nonlinear hardening of the material I. V. Khromov OriginalPaper 03 June 2009 Pages: 278 - 284
Influence of the modes of operation and structural factors on the crack propagation in 12Cr–2Ni–Mo steel V. V. PokrovskiiV. N. EzhovV. S. Zamotaev OriginalPaper 04 June 2009 Pages: 285 - 293
Strength characteristics of Mg–Li alloys D. RegeneraV. Tkachenko OriginalPaper 03 June 2009 Pages: 294 - 302
Pulse current treatment effect on the strength of reinforcing steel and its weld joint under impact loading L. KruszkaG. V. StepanovA. I. Babutskii OriginalPaper 04 June 2009 Pages: 303 - 309
Forced oscillations of beam with essentially nonlinear absorber K. V. AvramovO. V. Gendelman OriginalPaper 04 June 2009 Pages: 310 - 317
Analysis of the influence of the level of residual stresses on the ultimate stresses in a cycle for welded structures according to the results of testing of small-size specimens V. A. Degtyarev OriginalPaper 03 June 2009 Pages: 318 - 324
Procedure for the determination of torsional deformation relationships for anisotropic materials V. S. DzyubaL. V. Kravchuk OriginalPaper 03 June 2009 Pages: 325 - 331
Inelasticity monitoring of structural materials by the resonance method A. N. Mailo Production Section 03 June 2009 Pages: 332 - 338
A study of stress concentration zones under cyclic loading by thermal imaging method I. T. Mirsayapov OriginalPaper 03 June 2009 Pages: 339 - 344