1. The Influence of Amplitude-Dependent Damping on Vibrodiagnostic Parameters of the Presence of a Closing Crack in a Beam Under Subharmonic Resonance

   • V. V. Matveev
   • A. P. Yakovlev
   • O. E. Boginich

   SCIENTIFIC AND TECHNICAL SECTION 08 August 2015 Pages: 375 - 384

   

2. Methodology of Including Spatial Nonuniformity of Material Properties in the Brittle Fracture Resistance Calculation for WWER-1000 Reactor Pressure Vessels. Part 1. Theoretical Analysis

   • B. Z. Margolin
   • V. N. Fomenko
   • A. A. Chernobaeva

   OriginalPaper 08 August 2015 Pages: 385 - 399

   

3. Experimental Investigation of Mechanical Behavior of Materials by Small Punch Testing of Miniature Disk Specimens

   • V. V. Kharchenko
   • A. G. Makaev
   • A. V. Bogomolov

   OriginalPaper 05 August 2015 Pages: 400 - 405

   

4. A Program for Numerical Calculation of Dynamic Stress-Strain State and Strength of Hollow Multilayer Anisotropic Cylinders and Spheres. Part 2. Comparison of Numerical Results with Experimental and Theoretical for Cylinders

   • P. P. Lepikhin
   • V. A. Romashchenko
   • E. V. Bakhtina

   OriginalPaper 07 August 2015 Pages: 406 - 414

   

5. On the Rational Choice of the Azimuthal Crystallographic Orientation of Single-Crystal Cooled Rotor Blades in Aircraft Gas Turbine Engines

   • R. P. Pridorozhnyi
   • A. V. Sheremet’ev
   • A. P. Zinkovskii

   OriginalPaper 07 August 2015 Pages: 415 - 421

   

6. Limiting State Models for Structural Materials Under Symmetrical Cyclic Bending-Torsional Loading

   • V. P. Golub

   OriginalPaper 07 August 2015 Pages: 422 - 433

   

7. Effect of Electric Current Pulses and Cryogenic Temperatures on the Strength of Cutting Hard-Alloy Plates

   • L. S. Novogruds’kyi
   • V. O. Strizhalo
   • M. Ya. Opravkhata

   OriginalPaper 08 August 2015 Pages: 434 - 440

   

8. Influence of Preliminary Deformation on the Characteristics of Cyclic Creep and Damageability of Steel 10GN2MFA Under Plane Stress Conditions

   • F. F. Giginyak
   • P. A. Bulakh

   OriginalPaper 05 August 2015 Pages: 441 - 446

   

9. Effect of Electrodynamic Treatment on the Fracture Resistance of the AMg6 Aluminum Alloy Under Cyclic Loading

   • L. M. Lobanov
   • N. A. Pashchin
   • O. L. Mikhodui

   OriginalPaper 07 August 2015 Pages: 447 - 453

   

10. Effect of the Choice of the Simulation Model of the Cyclone-4 Launch Vehicle on the Calculated Values of Dynamic Characteristics

    • A. S. Konyukhov
    • A. S. Tsybenko
    • N. G. Krishchuk

    OriginalPaper 07 August 2015 Pages: 454 - 459

    

11. Modeling the Mechanism of Inelastic Shear at Fiber Interfaces in Material with Unidirectional Structure by Thin Perfectly Plastic Interlayer

    • A. V. Borovik

    OriginalPaper 08 August 2015 Pages: 460 - 466

    

12. Strain-Gauge Method of Detecting Subcritical Fatigue Cracks in Low-Carbon Steel Welds

    • A. O. Lukashevich
    • V. A. Leonets’
    • L. M. Chaus

    OriginalPaper 07 August 2015 Pages: 467 - 473

    

13. Method for Assessing the Mechanical Characteristics of Braided Core-Sheath Ropes Made of Synthetic Multifilament Yarns

    • M. P. Zemtsov
    • V. I. Skripchenko

    OriginalPaper 07 August 2015 Pages: 474 - 480

    

14. Ultimate Load of Three-Layered Annular Fibrous Composite Plate Fastened on Internal and Simply Supported External Contours

    • A. A. Dzhagangirov

    OriginalPaper 07 August 2015 Pages: 481 - 487

    

15. Brittle Failure of Graphite Weakened by V-Notches: A Review of Some Recent Results Under Different Loading Modes

    • F. Berto
    • A. Campagnolo
    • P. Gallo

    OriginalPaper 07 August 2015 Pages: 488 - 506

    

16. A Method of Virtual Design of the Fatigue Life of a Dynamic Structure

    • Wenli Zhao
    • Xiaojun Zhou
    • Meina Shen

    OriginalPaper 07 August 2015 Pages: 507 - 513