Volume 26, issue 6, November 2013
24 articles in this issue
-
-
-
Novel mobility formula for parallel mechanisms expressed with mobility of general link group
Authors (first, second and last of 6)
-
-
-
-
Effect of the cutter parameters and machining parameters on the interference in gear slicing
Authors (first, second and last of 5)
-
Plastic mechanism of multi-pass double-roller clamping spinning for arc-shaped surface flange
Authors (first, second and last of 4)
-
Key techniques and applications of adaptive growth method for stiffener layout design of plates and shells
Authors (first, second and last of 4)
-
Evolution of residual stresses in micro-arc oxidation ceramic coatings on 6061 Al alloy
Authors (first, second and last of 4)
-
Step-stress accelerated degradation test modeling and statistical analysis methods
Authors (first, second and last of 5)
-
-
Modelica-based object-orient modeling of rotor system with multi-faults
Authors (first, second and last of 5)
-
Bispectrum feature extraction of gearbox faults based on nonnegative Tucker3 decomposition with 3D calculations
Authors (first, second and last of 6)
-
Simulations and experimental investigation on motion stability of a flexible rotor-bearing system with a transverse crack
Authors (first, second and last of 4)
-
-
Nonlinear modeling and identification of the electro-hydraulic control system of an excavator arm using BONL model
Authors (first, second and last of 5)
-
Dynamic modeling and experiment of a new type of parallel servo press considering gravity counterbalance
Authors (first, second and last of 4)
-
-
-
Mechanisms of accelerated degradation in the front cells of PEMFC stacks and some mitigation strategies
Authors (first, second and last of 6)
-
-
Multi-objective optimization design and experimental investigation of centrifugal fan performance
Authors (first, second and last of 4)
-
Nanofluids transport model based on Fokker-Planck equation and the convection heat transfer calculation
Authors (first, second and last of 6)