Background
Phase contrast magnetic resonance imaging (PC-MRI) is the current gold standard for blood flow quantification. Using this technique it is possible to quantify cardiac output, stroke volume, shunts and valve insufficiencies. The accuracy of flow quantification is highly dependent on the manual delineation of the vessels of interest. Therefore, the purpose of this study is to develop an automatic method for vessel segmentation in PC-MRI sequences.
Methods
A total of 211 subjects from a previous study [1] were included (160 heart failure patients with ejection fraction below 40% and 51 healthy volunteers). For all subjects manual delineations of aorta ascendens were available in all timeframes. The subjects were randomly divided into a training (n = 40) and a test set (n = 171). The manual delineations in the training set were parameterized and principle component analysis (PCA) was performed to extract a priori information regarding vessel shape change and motion during the cardiac cycle. The proposed algorithm is an active contour model which tracks the edges of the aortic wall, initialized by a manual delineation in one timeframe. Every deformation is followed by a projection onto a subset of linearly independent components from the PCA result of the a priori dataset. This procedure is repeated 8 times. Validation was performed by comparing automated delineations with manual delineations in the test set consisting of the 171 remaining patients. All automatic segmentations were initiated with the manual delineation from the user in one timeframe. Stroke volume was used as performance measure. The inter observer variability for manual delineations from two observers was calculated in the previous study [1].
Results
The stroke volume from the automated method agreed well with manual delineations (Figure 1), with a correlation coefficient of r2 = 0.98. Bias between automated and manual delineation was -0.69 ± 2.55 ml, or -0.7 ± 3.5% of the stroke volume. This should be compared to an inter observer variability of 3 ± 4% [1]. The low bias of the proposed method compared to the inter observer variability of the previous study [1] is likely attributed to the fact that the initialization of the automatic method was done by the observer to whom the comparison was made.
Conclusions
In conclusion, the proposed method for vessel segmentation results in bias and variability comparable to manual delineations.
Funding
Swedish Research Council, Swedish Heart-Lung Foundation, Medical Faculty at Lund University.
References
Carlsson M, et al: JCMR. 2012, 14 (51):
Author information
Authors and Affiliations
Rights and permissions
This article is published under an open access license. Please check the 'Copyright Information' section either on this page or in the PDF for details of this license and what re-use is permitted. If your intended use exceeds what is permitted by the license or if you are unable to locate the licence and re-use information, please contact the Rights and Permissions team.
About this article
Cite this article
Bidhult, S.L., Carlsson, M., Steding-Ehrenborg, K. et al. A new method for vessel segmentation based on a priori input from medical expertise in cine phase-contrast Magnetic Resonance Imaging. J Cardiovasc Magn Reson 16 (Suppl 1), P355 (2014). https://doi.org/10.1186/1532-429X-16-S1-P355
Published:
DOI: https://doi.org/10.1186/1532-429X-16-S1-P355