Abstract
Squirrel-cage induction motors are widely used in a number of applications throughout the world. This paper proposes a neuro-fuzzy approach to identify and to classify a typical fault related to the induction motor damage, such as broken rotor bars. Two fuzzy classifiers are obtained by an adaptive-network-based fuzzy inference system model whose parameters can be identified by using the hybrid learning algorithm. A Hall effect sensor was installed between two stator slots of the induction machine, and a magnetic flux density variation is measured according to the failure. The data from the Hall sensor were used to extract some harmonic components by applying fast Fourier transform. Thus, some frequencies and their amplitudes were considered as inputs for the proposed fuzzy model to detect not only adjacent broken bars, but also noncontiguous faulted scenarios. In the present work it is not necessary to estimate the rotor slip, as required by the traditional condition monitoring technique, known as motor current signature analysis. This method was able to detect broken bars for induction motor running at low-load or no-load condition. The intelligent approach was validated using some experimental data from a 7.5-kW squirrel-cage induction machine.
Similar content being viewed by others
References
Al-Badri, M., Pillay, P., & Angers, P. (2015). A novel in situ efficiency estimation algorithm for three-phase IM using GA, IEEE method F1 calculations, and pretested motor data. IEEE Transactions on Energy Conversion, 30(3), 1092–1102.
Burriel-Valencia, J., Puche-Panadero, R., Martinez-Roman, J., Sapena-Bano, A., & Pineda-Sanchez, M. (2017). Short-frequency Fourier transform for fault diagnosis of induction machines working in transient regime. IEEE Transactions on Instrumentation and Measurement, 66(3), 432–440.
Chandralekha, R., & Jayanthi, D. (2016). Diagnosis of faults in three phase induction motor using neuro fuzzy logic. International Journal of Applied Engineering Research, 11(8), 5735–5740.
Choi, S., Pazouki, E., Baek, J., & Bahrami, H. R. (2015). Iterative condition monitoring and fault diagnosis scheme of electric motor for harsh industrial application. IEEE Transactions on Industrial Electronics, 62(3), 1760–1769.
Dias, C. G., & Chabu, I. E. (2014). Spectral analysis using a hall effect sensor for diagnosing broken bars in large induction motors. IEEE Transactions on Instrumentation and Measurement, 63(12), 2890–2902.
Dias, C. G. & de Sousa, C. M. (2017). An experimental approach for diagnosis of adjacent and nonadjacent broken bars in induction motors at very low slip. In 2017 IEEE International Electric Machines and Drives Conference (IEMDC) (pp. 1–6).
el Malek, M. A., Abdelsalam, A. K., & Hassan, O. E. (2017). Induction motor broken rotor bar fault location detection through envelope analysis of start-up current using hilbert transform. Mechanical Systems and Signal Processing, 93(Supplement C), 332–350.
Faiz, J., & Ebrahimi, B. (2009). Locating rotor broken bars in induction motors using finite element method. Energy Conversion and Management, 50(1), 125–131.
Godoy, W. F., da Silva, I. N., Goedtel, A., Palacios, R. H. C., & Lopes, T. D. (2016). Application of intelligent tools to detect and classify broken rotor bars in three-phase induction motors fed by an inverter. IET Electric Power Applications, 10(5), 430–439.
Guan, Y., Zhu, Z. Q., Afinowi, I. A. A., Mipo, J. C., & Farah, P. (2014). Calculation of torque-speed characteristic of induction machine for electrical vehicle application using analytical method. In 2014 International Conference on Electrical Machines (ICEM) (pp. 2715–2721).
Jang, J. S. R. (1993). Anfis: Adaptive-network-based fuzzy inference system. IEEE Transactions on Systems, Man, and Cybernetics, 23(3), 665–685.
Jung, J. H., Lee, J. J., & Kwon, B. H. (2006). Online diagnosis of induction motors using mcsa. IEEE Transactions on Industrial Electronics, 53(6), 1842–1852.
Laala, W., Guedini, S., & Zouzou, S. (2011). Novel approach for diagnosis and detection of broken bar in induction motor at low slip using fuzzy logic. In 2011 IEEE international symposium on diagnostics for electric machines, power electronics drives (SDEMPED) (pp. 511–516).
Lee, S., Hyun, D., Kang, T., Yang, C., Shin, S., Kim, H., et al. (2015). Identification of false rotor fault indications produced by on-line mcsa for medium voltage induction machines. In 2015 61st IEEE pulp and paper industry conference (PPIC) (Vol. 1, pp. 1–9).
Lizarraga-Morales, R. A., Rodriguez-Donate, C., Cabal-Yepez, E., Lopez-Ramirez, M., Ledesma-Carrillo, L. M., & Ferrucho-Alvarez, E. R. (2017). Novel FPGA-based methodology for early broken rotor bar detection and classification through homogeneity estimation. IEEE Transactions on Instrumentation and Measurement, 66(7), 1760–1769.
Lu, B., Habetler, T. G., & Harley, R. G. (2008). A nonintrusive and in-service motor-efficiency estimation method using air-gap torque with considerations of condition monitoring. IEEE Transactions on Industry Applications, 44(6), 1666–1674.
Maouche, Y., Oumaamar, M. E. K., Boucherma, M., & Khezzar, A. (2014). Instantaneous power spectrum analysis for broken bar fault detection in inverter-fed six-phase squirrel cage induction motor. International Journal of Electrical Power and Energy Systems, 62(Supplement C), 110–117.
Naha, A., Samanta, A. K., Routray, A., & Deb, A. K. (2016). A method for detecting half-broken rotor bar in lightly loaded induction motors using current. IEEE Transactions on Instrumentation and Measurement, 65(7), 1614–1625.
Palacios, R., Goedtel, A., & Godoy, W. F. (2016). Fault identification in the stator winding of induction motors using PCA with artificial neural networks. Journal of Control, Automation and Electrical Systems, 27(406), 1–13.
Puche-Panadero, R., Pineda-Sanchez, M., Riera-Guasp, M., Roger-Folch, J., Hurtado-Perez, E., & Perez-Cruz, J. (2009). Improved resolution of the mcsa method via hilbert transform, enabling the diagnosis of rotor asymmetries at very low slip. IEEE Transactions on Energy Conversion, 24(1), 52–59.
Riera-Guasp, M., Cabanas, M. F., Antonino-Daviu, J. A., Pineda-Snchez, M., & Garc-a, C. H. R. (2010). Influence of nonconsecutive bar breakages in motor current signature analysis for the diagnosis of rotor faults in induction motors. IEEE Transactions on Energy Conversion, 25(1), 80–89.
Sadeghian, A., Ye, Z., & Wu, B. (2009). Online detection of broken rotor bars in induction motors by wavelet packet decomposition and artificial neural networks. IEEE Transactions on Instrumentation and Measurement, 58(7), 2253–2263.
Samanta, A. K., Naha, A., Routray, A., & Deb, A. K. (2017). Fast and accurate spectral estimation for online detection of partial broken bar in induction motors. Mechanical Systems and Signal Processing, 98(Supplement C), 63–77.
Sauer, I. L., Tatizawa, H., Salotti, F. A., & Mercedes, S. S. (2015). A comparative assessment of Brazilian electric motors performance with minimum efficiency standards. Renewable and Sustainable Energy Reviews, 41, 308–318.
Singh, H., Seera, M., & Abdullah, M. Z. (2013). Detection and diagnosis of broken rotor bars and eccentricity faults in induction motors using the fuzzy min-max neural network. In The 2013 international joint conference on neural networks (IJCNN) (pp. 1–5).
Sizov, G. Y., Sayed-Ahmed, A., Yeh, C. C., & Demerdash, N. A. O. (2009). Analysis and diagnostics of adjacent and nonadjacent broken-rotor-bar faults in squirrel-cage induction machines. IEEE Transactions on Industrial Electronics, 56(11), 4627–4641.
Thomson, W. T. & Fenger, M. (2003). Case histories of current signature analysis to detect faults in induction motor drives. In IEEE international electric machines and drives conference. IEMDC’03 (Vol. 3, pp. 1459–1465).
Zarei, J. (2012). Induction motors bearing fault detection using pattern recognition techniques. Expert Systems With Applications, 39(68–73), 68–73.
Zhang, P., Du, Y., Habetler, T. G., & Lu, B. (2011). A survey of condition monitoring and protection methods for medium-voltage induction motors. IEEE Transactions on Industry Applications, 47(1), 34–46.
Acknowledgements
The authors are thankful to the São Paulo Research Foundation (FAPESP), Grant #2016/02525-1, and Nove de Julho University (UNINOVE) for their support.
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Dias, C.G., de Sousa, C.M. A Neuro-Fuzzy Approach for Locating Broken Rotor Bars in Induction Motors at Very Low Slip. J Control Autom Electr Syst 29, 489–499 (2018). https://doi.org/10.1007/s40313-018-0388-5
Received:
Revised:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s40313-018-0388-5