Abstract
In this study, an attempt is made to investigate the load transfer in pile groups constructed in saturated and unsaturated soil using aluminum model piles of \(20\times 20\) mm in cross section and 200 mm in length with six group configurations, single, \(2\times 1\), \(3\times 1\), \(2\times 2\), \(3\times 2\), and \(3\times 3\), groups in addition to pull-out test. The samples are prepared at three different soil properties: two models with the same degree of saturation and two with different dry unit weights and the third is unsaturated soil model with. A relationship between the soil suction and water content is introduced using a digital monitor, accompanied by eight suction probes planted in CBR molds. This relationship is used to predict the value of suction when conducting tests on models of the unsaturated soil. Further, the soil suction is measured using a filter paper method. Results of ultimate load capacity obtained from the load–displacement curves reveal an increase in the ultimate load with increasing the number of piles in the group for the same soil properties, and also an increase in the soil dry unit weight. Further, the results indicate an increase in pile capacity when the soil becomes in unsaturated state compared with saturated soil for the same pile group tested. On the other hand, the pull-out test gives a maximum load carrying capacity when the single pile tested was in saturated soil with high dry density, and minimum results are obtained when tested in unsaturated condition with the percentage of increase being about 463 and 34% for two saturated soils, compared with that for unsaturated soil.
Similar content being viewed by others
References
Georgiadis, K.: Development, implementation and application of partially saturated soil models in finite element analysis. Ph.D. Thesis, Imperial College of Science, Technology and Medicine, University of London (2003)
Vanapalli, S.K.; Taylan, Z.N.: Design of single piles using the mechanics of unsaturated soils. Int. J. GEOMATE 2(1 (Sl. No. 3)), 197–204 (2012). Japan
Mohsen, I.M.: Behavior of single pile in unsaturated clay soils. M.Sc. Thesis, Building and Construction Engineering Department, University of Technology, Iraq (2012)
Fattah, M.Y.; Salim, N.M.; Mohsin, I.M.: Behavior of single pile in unsaturated clayey soils. Eng. Technol. J. 32(3), 763–787 (2014)
Vanapalli, S.K.; Mohamed, F.M.O.: Bearing capacity and settlement of footings in unsaturated sands. Int. J. GEOMATE 5(1), 595–604 (2013)
Oh, W.T.; Vanapalli, S.K.: Interpretation of the bearing capacity of unsaturated fine-grained soil using the modified effective and the modified total stress approaches. Int. J. Geomech. ASCE 13(6), 769–778 (2013)
Xu, Y.; Cao, L.: Fractal representation for effective stress of unsaturated soils. Int. J. Geomech. ASCE (2014). https://doi.org/10.1061/(ASCE)GM.1943-5622.0000446,04014098
Hamilton, M.: Pile–soil interaction in unsaturated soil conditions, University of New Hampshire. http://scholars.unh.edu/honors/180 (2014)
Chung, S.H.; Yang, S.R.: Numerical analysis of small-scale model pile in unsaturated clayey soil. Int. J. Civ. Eng. 15(6), 877–886 (2017)
ASTM D 422-00: Standard test method for particle size-analysis of soils, American Society for Testing and Materials
Fattah, M.Y.; Yahya, A.Y.; Al-Hadidi, M.T.; Ahmed, B.A.: Effect of salt content on total and matric suction of unsaturated soils. Eur. Sci. J. 9(9), 228–245 (2013)
ASTM Standard D698: Standard test methods for laboratory compaction characteristics of soil using standard effort. ASTM International, West Conshohocken, PA (2007)
Bicalho, K.V.; Cupertino, K.F.; Bertolde, A.I.: Evaluation of the suction calibration curve for Whatman 42 filter paper. In: Caicedo, L., et al. (eds.) Advances in Unsaturated Soils. Taylor and Francis Group, London (2013)
ASTM-D-5298-03: Standard test method for measurement of soil potential (suction) using filter paper. In: Annual Book of ASTM Standards, Vol. 04.08, Soil and Rock, pp. 1–6
Fredlund, D.G.; Gan, J.K.M.; Gallen, P.: Suction measurements on compacted till specimens and indirect filter paper calibration technique. Transp. Res. Board Transp. Res. Record 1481, 3–9 (1995)
Likos, W.J.; Lu, N.: Filter paper technique for measuring total soil suction. Transportation Research Record 1786, Paper No. 02-2140, pp. 120-128 (2002)
EM 1110-2-2906.: (1991).: Design of pile foundations. Engineer Manual. Department of the Army, U.S. Army Corps of Engineers Washington, DC, pp. 20314–1000 (1991)
Fellenius, B.H.: What Capacity Value to Choose from the Results of a Static Loading Test. Fulcrum, Deep Foundation Institute, New Jersey (2001)
Fellenius, B.H.: Basics of Foundation Design, Electronic edn (2006). www.Fellenius.net
Lambe, T.W.; Whitman, R.V.: Soil Mechanics. Wiley, New York (1979)
Prakash, S.; Sharma, H.D.: Pile Foundations in Engineering Practice. Wiley, New York (1990)
Murthy, V.N.S.: Geotechnical Engineering: Principles and Practices of Soil Mechanics and Foundation Engineering. Marcel Dekker, Inc., New York (2003)
Bowles, J.E.: Foundation Analysis and Design, 5th edn. McGraw-Hill Book Companies, Inc., New York (1996)
Huat, B.B.K.; Ali, F.H.; Abdullah, A.: Field and laboratory suction–soil moisture relationship of unsaturated residual soils. Am. J. Environ. Sci. 1(1), 34–40 (2005)
Daichao, S.; Annan, Z.; Fredlund, D.G.: Shear strength criteria for unsaturated soils. Geotech. Geol. Eng. 2(9), 145–159 (2011)
Fredlund, D.G.; Morgernstern, N.R.; Widger, R.A.: The shear strength of unsaturated soils. Can. Geotech. J. 15(3), 316–321 (1978)
Fredlund, D.G.; Xing, A.; Fredlund, M.D.; Barbour, S.L.: The relationship of the unsaturated shear strength to the soil-water characteristic curve. Can. Geotech. J. 33(3), 440–448 (1996)
Vanapalli, S.K.; Fredlund, D.G.; Barbor, S.L.: A rational for an extended soil- water characteristic curve. In: 49th Canadian Geotechnical Conference of the Canadian Geotechnical Society, St. John Newfoundland, Canada (1996)
Vanapalli, S.K.; Fredlund, D.G.: Comparison of different procedures to predict unsaturated soil shear strength. Adv. Unsaturated Geotech. ASCE Geotech. Spec. Publ. 99, 195–221 (2000)
Tomlinson, M.J.: Pile Design and Construction Practice, pp. 2–6. Boundary Row, London (1994)
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Al-Omari, R.R., Fattah, M.Y. & Kallawi, A.M. Laboratory Study on Load Carrying Capacity of Pile Group in Unsaturated Clay. Arab J Sci Eng 44, 4613–4627 (2019). https://doi.org/10.1007/s13369-018-3483-9
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s13369-018-3483-9